期刊文献+
共找到3篇文章
< 1 >
每页显示 20 50 100
Mg-Cd-Nd-Zn-Zr合金的组织与力学性能研究 被引量:5
1
作者 曾祥亮 刘楚明 +1 位作者 姜辉 徐雷 《热加工工艺》 CSCD 北大核心 2009年第16期1-2,7,共3页
通过显微组织观察和力学性能测试等手段研究了Mg-Cd-Nd-Zn-Zr合金的组织和力学性能。结果表明:Cd和Nd能细化镁合金晶粒,铸态平均晶粒尺寸细化到35μm左右,挤压态平均晶粒尺寸细化到约10μm;Mg-Cd-Nd-Zn-Zr镁合金经挤压变形后综合力学性... 通过显微组织观察和力学性能测试等手段研究了Mg-Cd-Nd-Zn-Zr合金的组织和力学性能。结果表明:Cd和Nd能细化镁合金晶粒,铸态平均晶粒尺寸细化到35μm左右,挤压态平均晶粒尺寸细化到约10μm;Mg-Cd-Nd-Zn-Zr镁合金经挤压变形后综合力学性能提高,抗拉强度和屈服强度分别提高到334和330MPa,伸长率达到15%。 展开更多
关键词 Mg-Zn-Zr-Nd-Cd合金 力学性能 微观组织 挤压
下载PDF
Mg-5.52Zn-1.73Nd-0.71Cd-0.5Zr镁合金的热变形组织和力学性能 被引量:2
2
作者 刘先兰 刘楚明 +2 位作者 张文玉 李慧中 曾苏民 《粉末冶金材料科学与工程》 EI 2011年第6期799-805,共7页
采用Gleeble-1500热模拟机研究Mg-Zn-Nd-Cd-Zr合金在温度为300~420℃、应变速率为0.001~1 s-1、最大变形程度为80%的条件下的高温变形行为。采用光学显微镜及透射电镜研究Mg-Zn-Nd-Cd-Zr镁合金在不同压缩变形条件下的组织形貌特征。... 采用Gleeble-1500热模拟机研究Mg-Zn-Nd-Cd-Zr合金在温度为300~420℃、应变速率为0.001~1 s-1、最大变形程度为80%的条件下的高温变形行为。采用光学显微镜及透射电镜研究Mg-Zn-Nd-Cd-Zr镁合金在不同压缩变形条件下的组织形貌特征。结果表明:在实验条件下,合金的流变应力-应变曲线属于动态再结晶类型。合金的峰值流变应力随应变速率的增大而增加,随温度的升高而降低。实验分析认为该镁合金挤压温度定在340~380℃左右为宜;在360℃左右顺利挤出的实验合金有很好的力学性能。抗拉强度(σb)为310 MPa,屈服强度(σ0.2)为290 MPa,伸长率(δ)为16%。 展开更多
关键词 镁合金 热模拟变形 动态再结晶 力学性能
下载PDF
Effect of Nd^(3+) substitution on structural and magnetic properties of Mg-Cd ferrites synthesized by microwave sintering technique 被引量:5
3
作者 S.R.Bhongale H.R.Ingawale +1 位作者 T.J.Shinde P.N.Vasambekar 《Journal of Rare Earths》 SCIE EI CAS CSCD 2018年第4期390-397,共8页
Nd3+ substituted spinel ferrites with formula MgxCd1-xNd0.03Fe1.97O4(x = 0.0.2,0.4,0.6.0.8 and 1.0)were prepared by oxalate co-precipitation method using novel microwave sintering technique. AR grade sulphates were... Nd3+ substituted spinel ferrites with formula MgxCd1-xNd0.03Fe1.97O4(x = 0.0.2,0.4,0.6.0.8 and 1.0)were prepared by oxalate co-precipitation method using novel microwave sintering technique. AR grade sulphates were used as starting chemicals. The samples were sintered at optimized power of 70 W for10 min in a microwave oven(800 W). The structural analysis of these samples was done by using X-ray diffraction, scanning electron microscope and Fourier transform IR techniques. The XRD analysis of the synthesized ferrite confirms the formation of cubic spinel structure of ferrite. The influence of Nd3+substitution on various structural parameters of Mg-Cd ferrites was reported. IR study indicates the spectra contain two intense absorption bands around 600 and 400 cm^(-1) in addition with four extra bands. The magnetic properties of all ferrites were studied by using a vibration sample magnetometer.The crystallite and grain size dependant magnetic properties are observed. The composition Mg_(0.6)Cd_(0.4)Nd_(0.03)Fe_(1.97)O_4 has better magnetic properties that can be used in recording media. The fast synthesis of spinel ferrites is yielded due to use of the microwave sintering technique. 展开更多
关键词 mg-nd-cd ferrite Rare earth Microwave sintering IR study Coercive force
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部