Characteristic evaluation of Al_2O_3/CNTs hybrid materials for micro-electrical discharge machining

The characteristic evaluation of aluminum oxide （A1203）/carbon nanotubes （CNTs） hybrid composites for micro-electrical discharge machining （EDM） was described. Alumina matrix composites reinforced with CNTs were fabricated by a catalytic chemical vapor deposition method. A1203 composites with different CNT concentrations were synthesized. The electrical characteristic of A1203/CNTs composites was examined. These composites were machined by the EDM process according to the various EDM parameters, and the characteristics of machining were analyzed using field emission scanning electron microscope （FESEM）. The electrical conductivity has a increasing tendency as the CNTs content is increased and has a critical point at 5% A1203 （volume fraction）. In the machining accuracy, many tangles of CNT in A1203/CNTs composites cause violent spark. Thus, it causes the poor dimensional accuracy and circularity. The results show that conductivity of the materials and homogeneous distribution of CNTs in the matrix are important factors for micro-EDM of A1203/CNTs hybrid composites.

Research on feed-pulse collaborative control method in micro-electrical discharge machining

Reducing the short-circuit rate and increasing the effective discharge rate are important targets for improving the servo control effect of micro-electrical discharge machining(micro-EDM),as these two indicators are closely related to the machining efficiency and quality.In this study,a feed-pulse collaborative control(FPCC)method is proposed for micro-EDM based on two dimensions(space and time).In the spatial dimension,a feed control strategy with a discharge holding process is adopted.Meanwhile,in the time dimension,a forward-looking pulse control strategy is adopted,in which the pulse interval is adjusted based on a sequence analysis of feed commands and discharge states.Process experiments are carried out to determine the key parameters used in this method,including the discharge holding threshold and pulse interval adjustment value(T_(off_(adj))).The feed smoothness and discharge sufficiency analyses of the experimental results show that compared to the traditional double threshold average voltage method,the FPCC method reduces the number of long-distance retreats by 64%and improves the effective discharge time by 40%.

Electromagnetic analysis and design of in-wheel motor of micro-electric vehicle based on Maxwell

To obtain a good drivability and high efficiency of the micro-electric vehicle, a new driving in-wheel motor design was analyzed and optimized. Maxwell software was used to build finite element simulation model of the driving in-wheel motor. The basic features and starting process were analyzed by field-circuit coupled finite element method. The internal complicated magnetic field distribution and dynamic performance simulation were obtained in different positions. No-load and load characteristics of the driving in-wheel motor was simulated, and the power consumption of materials was computed. The conformity of the final simulation results with the experimental data indicates that this method can be used to provide a theoretical basis to make further optimal design of this new driving in-wheel motor and its control system, so as to improve the starting torque and reduce torque ripple of the motor. This method can shorten the development cycle of in-wheel motors and save development costs, which has a wide range of engineering application value.

Material properties and machining performance of hybrid Ti_2AlN bulk material for micro electrical discharge machining

Mn+1AXn(MAX) phases are a family of nanolaminated compounds that possess unique combination of typical ceramic properties and typical metallic properties.As a member of MAX phase,Ti2 AlN bulk materials are attractive for some high-temperature applications.The synthesis,characteristics and machining performance of hybrid Ti2 AlN bulk materials were focused on in this work.The bulk samples mainly consisting of Ti2 AlN MAX phase with density close to theoretic one were synthesized by a spark plasma sintering method.Scanning electron microscopy results indicate homogenous distribution of Ti2 AlN grains in the samples.Micro-hardness values are almost constant under different loads (6-6.5 GPa).A machining test was carried out to compare the effect of material properties on micro-electrical discharge machining (micro-EDM) performance for Ti2 AlN bulk samples and Ti6242 alloy.The machining performance of the Ti2 AlN sample is better than that of the Ti6242 alloy.The inherent mechanism was discussed by considering their electrical and thermal conductivity.