There were four doublets in the Mssbauer spectrum of cucumber (Cucumis sativus L.) photosystemⅡ (PSⅡ) particles. According to the value of isomer shift and quadrupole splitting, they represented oxidized cytochrome ...There were four doublets in the Mssbauer spectrum of cucumber (Cucumis sativus L.) photosystemⅡ (PSⅡ) particles. According to the value of isomer shift and quadrupole splitting, they represented oxidized cytochrome b559 (Cyt_b559), reduced Cyt_b559, Fe 3+ _quinone (Q) complex, and Fe 2+ _Q complex respectively. After water_stress, the electron transport rate between Q A (primary quinone electron acceptor of PSⅡ)/Q B(secondary quinone electron acceptor of PSⅡ) was affected and the absorption doublets of Fe 2+ disappeared, suggesting that the reduced Cyt_b559 and Fe 2+ _Q complex had been oxidized. The results indicated that water_stress had changed the redox status of iron in the iron_quinone complex. Iron took part in electron transport through the change from a state of reduction to oxidation.展开更多
The M?ssbauer spectra of natural megacrystal clinopyroxene are usually fitted by 4 sets of symmetric doublets, A-A', B-B', C-C' and D-D', respectively, in terms of increasing Qs value in literature. Bu...The M?ssbauer spectra of natural megacrystal clinopyroxene are usually fitted by 4 sets of symmetric doublets, A-A', B-B', C-C' and D-D', respectively, in terms of increasing Qs value in literature. But the assignments of those doublets are quite different, except the D-D' doublet assigned to Fe3+at the lattice site M***1 in previous papers. Particularly, the assignment and interpretation of the C-C' doublet are diverse.展开更多
If recoilless fraction fa is available, the optimum absorber thickness dopt can be calculated by maximizing the signal to noise ratio or Q factor. In this work,an approach presented is to get experimental Qexp as a fu...If recoilless fraction fa is available, the optimum absorber thickness dopt can be calculated by maximizing the signal to noise ratio or Q factor. In this work,an approach presented is to get experimental Qexp as a function of the thickness,andthen fitting Qexp by its theoretical expression gives fa value. At last the dopt value is deduced from a maximum on the fitted curve.In such a way, thicknesses of six specimens with quadrupole or magnetic hyperfinc splitting were optimized.展开更多
Magnetic properties of nanocrystalline Fe_~60 Cr_~40 powders prepared by mechanical alloying in vacuum and air were investigated by utilizing the measurements of magnetization, X-ray diffraction, and ~ ~57 Fe Mssbauer...Magnetic properties of nanocrystalline Fe_~60 Cr_~40 powders prepared by mechanical alloying in vacuum and air were investigated by utilizing the measurements of magnetization, X-ray diffraction, and ~ ~57 Fe Mssbauer spectrum. The results show that the Fe_~60 Cr_~40 powders keep the bcc structure during milling in air and vacuum. The saturation magnetization of the Fe_~60 Cr_~40 powders milled in vacuum and air decreases with the increase of the milling time up to 45 h. The decrease of saturation magnetization of the Fe_~60 Cr_~40 powders milled in vacuum is due to the formation of Fe-Cr solid solution, while in air it is due to the formation of paramagnetic disorder structure and solid solution.展开更多
The technique of mechanical alloying(MA) for preparing amorphous Fe-Zr-B-(Cu) alloys has been studied The structure of samples was analysed by X-ray diffractometry, electron microscopy and Mssbauer spectroscopy.The re...The technique of mechanical alloying(MA) for preparing amorphous Fe-Zr-B-(Cu) alloys has been studied The structure of samples was analysed by X-ray diffractometry, electron microscopy and Mssbauer spectroscopy.The results show that Fe78Zr10B12 sample of a nearly complete amorphous phase may be prepared but in Fe91Zr7B2 sample metastable b c c phase was obtained Using the same procedure a mixture of amorphous phase and α-Fe(Zr, B) was generated in Fe85Zr7B8. Furthermore,the results of Mssbauer reveal that there are two kinds of short-range ordered phases in the sample. While adding Iat% Cu in Fe78Zr10B12 or Fe85Zr7B8 sample, it is found that the hyperfine field of amorphous phases decreases significantly.展开更多
文摘There were four doublets in the Mssbauer spectrum of cucumber (Cucumis sativus L.) photosystemⅡ (PSⅡ) particles. According to the value of isomer shift and quadrupole splitting, they represented oxidized cytochrome b559 (Cyt_b559), reduced Cyt_b559, Fe 3+ _quinone (Q) complex, and Fe 2+ _Q complex respectively. After water_stress, the electron transport rate between Q A (primary quinone electron acceptor of PSⅡ)/Q B(secondary quinone electron acceptor of PSⅡ) was affected and the absorption doublets of Fe 2+ disappeared, suggesting that the reduced Cyt_b559 and Fe 2+ _Q complex had been oxidized. The results indicated that water_stress had changed the redox status of iron in the iron_quinone complex. Iron took part in electron transport through the change from a state of reduction to oxidation.
基金supported by the National Natural Science Foundation Grant 49673186.
文摘The M?ssbauer spectra of natural megacrystal clinopyroxene are usually fitted by 4 sets of symmetric doublets, A-A', B-B', C-C' and D-D', respectively, in terms of increasing Qs value in literature. But the assignments of those doublets are quite different, except the D-D' doublet assigned to Fe3+at the lattice site M***1 in previous papers. Particularly, the assignment and interpretation of the C-C' doublet are diverse.
文摘If recoilless fraction fa is available, the optimum absorber thickness dopt can be calculated by maximizing the signal to noise ratio or Q factor. In this work,an approach presented is to get experimental Qexp as a function of the thickness,andthen fitting Qexp by its theoretical expression gives fa value. At last the dopt value is deduced from a maximum on the fitted curve.In such a way, thicknesses of six specimens with quadrupole or magnetic hyperfinc splitting were optimized.
文摘Magnetic properties of nanocrystalline Fe_~60 Cr_~40 powders prepared by mechanical alloying in vacuum and air were investigated by utilizing the measurements of magnetization, X-ray diffraction, and ~ ~57 Fe Mssbauer spectrum. The results show that the Fe_~60 Cr_~40 powders keep the bcc structure during milling in air and vacuum. The saturation magnetization of the Fe_~60 Cr_~40 powders milled in vacuum and air decreases with the increase of the milling time up to 45 h. The decrease of saturation magnetization of the Fe_~60 Cr_~40 powders milled in vacuum is due to the formation of Fe-Cr solid solution, while in air it is due to the formation of paramagnetic disorder structure and solid solution.
文摘The technique of mechanical alloying(MA) for preparing amorphous Fe-Zr-B-(Cu) alloys has been studied The structure of samples was analysed by X-ray diffractometry, electron microscopy and Mssbauer spectroscopy.The results show that Fe78Zr10B12 sample of a nearly complete amorphous phase may be prepared but in Fe91Zr7B2 sample metastable b c c phase was obtained Using the same procedure a mixture of amorphous phase and α-Fe(Zr, B) was generated in Fe85Zr7B8. Furthermore,the results of Mssbauer reveal that there are two kinds of short-range ordered phases in the sample. While adding Iat% Cu in Fe78Zr10B12 or Fe85Zr7B8 sample, it is found that the hyperfine field of amorphous phases decreases significantly.
