H-infinity control for networked control systems (NCS) with time-varying delays

This paper discusses H-infinity state feedback control for a networked control system with time-varying delays. Based on the flee-weighing matrix method, a dehy-dependent stability criterion satisfying a prescribed H-infinity norm bound is presented for an NCS with unknown, time-varying and bounded delays. And then, the criterion is transformed into sufficient conditions based on linear matrix inequalities for H-infinity control. The conditions thus obtained are also used to design an H-infinity state feedback controller. This design method is further extended to solve the design problem of robust H-infinity state feedback control. A numerical example demonstrates the validity of the method.

D-stability and disturbance attenuation properties fornetworked control systems： switched system approach

Both D-stability and finite L2-gain properties are studiedfor a class of uncertain discrete-time systems with timevaryingnetwork-induced delays. By using coordinate transformand delay partition, the D-stability and H∞ performance problemsfor such networked control systems （NCSs） are equivalentlytransferred into the corresponding problems for switching systemswith arbitrary switching. Then, a sufficient condition for the existenceof the robust D-stabilizing controllers is derived in termsof linear matrix inequality （LMI）, and the design method is alsopresented for the state feedback controllers which guarantee thatall the closed-loop poles remain inside the specified disk D（α,r）and the desired disturbance attenuation level. Finally, an illustrativeexample is given to demonstrate the effectiveness of the proposedresults.

Performance analysis of a class of networked control systems under data rate constraints

In networked control system (NCS) where control loop is closed over communication network, limited data rate may deteriorate control performance even destabilize the control system. In this paper, performance analysis of a typical second-order control system with data rate constraints is conducted, and the concept of critical data rate (CDR) is presented. In order to find the CDR in NCS, an approximate searching method is proposed to guarantee acceptable control performance.

Signal difference-based deadband H_∞ control approach for networked control systems with limited resources

This paper investigates a signal difference-based dead- band H∞ control approach for networked control systems （NCSs） with limited resources. The effects of variable network-induced de- lays, sampling intervals and data transmitting deadbands are con- sidered simultaneously and the model of the NCS is presented. A Lyapunov functional is adopted, which makes full use of the network characteristic information including the bounds of net- work delay （BND）, the bounds of sampling interval （BSI） and the bounds of transmission deadband （BTD）. In the meanwhile, the new H∞ performance analysis and controller design conditions for the NCSs are proposed, which describe the relationship of BND, BSI, BTD and the system＇s performance. Three examples are used to illustrate the advantages of the proposed methods. The results have shown that the proposed method not only effectively reduces the data traffic, but also guarantees the system asymptotically sta- ble and achieves the prescribed H∞ disturbance attenuation level.

Research on robust fault-tolerant control for networked control system with packet dropout

A kind of networked control system with network-induced delay and packet dropout, modeled on asynchronous dynamical systems was tested, and the integrity design of the networked control system with sensors failures and actuators failures was analyzed using hybrid systems technique based on the robust fault-tolerant control theory. The parametric expression of controller is given based on the feasible solution of linear matrix inequality. The simulation results are provided on the basis of detailed theoretical analysis, which further demonstrate the validity of the proposed schema.

Fault-Tolerant Control Research for Networked Control System under Communication Constraints

Implementing a control system over a communication network induces inevitable time delays that may degrade performance and even cause instability. One of the most effective ways to reduce the negative effect of delays on the performance of networked control system (NCS) is to reduce network traffic. In this paper, adjustable deadbands are explored as a solution to reduce network traffic in NCS. A method of fault-tolerant control of networked control system is presented, which takes into account system response as well as network traffic. The integrity design for a kind of NCS with sensor failures and actuator failures is analyzed based on robust fault-tolerant control theory and information scheduling. After detailed theoretical analysis, the paper also provides the simulation results, which further validate the proposed scheme.

Stability analysis of networked control systems with time-varying sampling periods

In this paper, we present an interval model of networked control systems with time-varying sampling periods and time-varying network-induced delays and discuss the problem of stability of networked control systems using Lyapunov stability theory. A sufficient stability condition is obtained by solving a set of linear matrix inequalities. In the end, the illustrative example demonstrates the correctness and effectiveness of the proposed approach.

Fault Tolerant Control for Networked Control Systems with Packet Loss and Time Delay

In this paper,a fault tolerant control with the consideration of actuator fault for a networked control system （NCS） with packet loss is addressed.The NCS with data packet loss can be described as a switched system model.Packet loss dependent Lyapunov function is used and a fault tolerant controller is proposed respectively for arbitrary packet loss process and Markovian packet loss process.Considering a controlled plant with external energy-bounded disturbance,a robust H ∞ fault tolerant controller is designed for the NCS.These results are also expanded to the NCS with packet loss and networked-induced delay.Numerical examples are given to illustrate the effectiveness of the proposed design method.

Linearizing Control of Induction Motor Based on Networked Control Systems

A new approach to speed control of induction motors is developed by introducing networked control systems （NCSs） into the induction motor driving system. The control strategy is to stabilize and track the rotor speed of the induction motor when the network time delay occurs in the transport medium of network data. First, a feedback linearization method is used to achieve input-output linearization and decoupling control of the induction motor driving system based on rotor flux model, and then the characteristic of network data is analyzed in terms of the inherent network time delay. A networked control model of an induction motor is established. The sufficient condition of asymptotic stability for the networked induction motor driving system is given, and the state feedback controller is obtained by solving the linear matrix inequalities （LMIs）. Simulation results verify the efficiency of the proposed scheme.

Guaranteed Cost Active Fault-tolerant Control of Networked Control System with Packet Dropout and Transmission Delay

The problem of guaranteed cost active fault-tolerant controller （AFTC） design for networked control systems （NCSs） with both packet dropout and transmission delay is studied in this paper. Considering the packet dropout and transmission delay, a piecewise constant controller is adopted. With a guaranteed cost function, optimal controllers whose number is equal to the number of actuators are designed, and the design process is formulated as a convex optimal problem that can be solved by existing software. The control strategy is proposed as follows： when actuator failures appear, the fault detection and isolation unit sends out the information to the controller choosing strategy, and then the optimal stabilizing controller with the smallest guaranteed cost value is chosen. Two illustrative examples are given to demonstrate the effectiveness of the proposed approach. By comparing with the existing methods, it can be seen that our method has a better performance.

Research on Network Delays of Networked Control Systems

In networked control systems (NCS), the main problem is time delays induced by communication network, which can deteriorate the performance of the systems, even cause the systems instability. If we know the exact network delays, we can compensate for their effect by modifying the parameters of the controller. Hence how to get the knowledge of these delays in the network is critical. This paper analyzed the different characteristics of network delays from sensor to controller and from controller to actuator and presented the methods of online evaluation of these delays. The experiment shows these methods are valid.

Fault detection for networked systems subject to access constraints and packet dropouts

This paper addresses the problem of fault detection（FD） for networked systems with access constraints and packet dropouts.Two independent Markov chains are used to describe the sequences of channels which are available for communication at an instant and the packet dropout process,respectively.Performance indexes H∞ and H_ are introduced to describe the robustness of residual against external disturbances and sensitivity of residual to faults,respectively.By using a mode-dependent fault detection filter（FDF） as residual generator,the addressed FD problem is converted into an auxiliary filter design problem with the above index constraints.A sufficient condition for the existence of the FDF is derived in terms of certain linear matrix inequalities（LMIs）.When these LMIs are feasible,the explicit expression of the desired FDF can also be characterized.A numerical example is exploited to show the usefulness of the proposed results.

Self-organization of Reconfigurable Protocol Stack for Networked Control Systems

In networked control systems （NCS）,the control performance depends on not only the control algorithm but also the communication protocol stack.The performance degradation introduced by the heterogeneous and dynamic communication environment has intensified the need for the reconfigurable protocol stack.In this paper,a novel architecture for the reconfigurable protocol stack is proposed,which is a unified specification of the protocol components and service interfaces supporting both static and dynamic reconfiguration for existing industrial communication standards.Within the architecture,a triple-level self-organization structure is designed to manage the dynamic reconfiguration procedure based on information exchanges inside and outside the protocol stack.Especially,the protocol stack can be self-adaptive to various environment and system requirements through the reconfiguration of working mode,routing and scheduling table.Finally,the study on the protocol of dynamic address management is conducted for the system of controller area network （CAN）.The results show the efficiency of our self-organizing architecture for the implementation of a reconfigurable protocol stack.

H_∞-based fault detection for nonlinear networked systems with random packet dropout and probabilistic interval delay

The fault detection problem for the nonlinear networked control system （NCS） with packet dropout and delay is investigated. A nonlinear stochastic system model is proposed to account for the NCS with random packet dropout and network- induced non-uniformly distributed time-varying delay in both from sensor to controller （S/C） and from controller to actuator （C/A）. Based on the obtained NCS model, employing an observer-based fault detection filter as the residual generator, the addressed fault detection problem is converted into an auxiliary nonlinear H∞ control problem. Then, with the help of Lyapunov functional approach, a sufficient condition for the desired fault detection filter is constructed in terms of certain linear matrix inequalities, which depend on not only the delay interval but also the delay interval occurrence rate and successful packet communication rate. Especially, a trade-off phenomenon between the maximum allowable delay bound and successful data packet transmission rate is found, which is typically resulted from the limited bandwidth of communication networks. The effectiveness of the proposed method is demonstrated by a simulation example.

Observer-based H-infinity control in multiple channel networked control systems with random packet dropouts

This paper investigates the observer-based H-infinity control problem for networked control systems （NCSs） with random packet dropouts. A general packet dropout model with multiple independent stochastic variables in the multiple channels case is adopted to describe the data missing in the limited communication channels. With the consideration of the sensor-to-controller and controller-to-actuator packet dropouts at the same time, a new method is pro- posed based on a separation lemma to design an observer-based H-infinity controller, which exponentially stabilizes the closed-loop system in the sense of mean square and also achieves a prescribed H-infinity disturbance attenuation level. A numerical example is given to illustrate the effectiveness of the proposed control method.

Fundamental Issues in Networked Control Systems

Abstract--This paper provides a survey on modeling and theories of networked control systems （NCS）. In the first part, modeling of the different types of imperfections that affect NCS is discussed. These imperfections are quantization errors, packet dropouts, variable sampling/transmission intervals, vari- able transmission delays, and communication constraints. Then follows in the second part a presentation of several theories that have been applied for controlling networked systems. These theories include： input delay system approach, Markovian system approach, switched system approach, stochastic system approach, impulsive system approach, and predictive control approach. In the last part, some advanced issues in NCS including decentral- ized and distributed NCS, cloud control system, and co-design of NCS are reviewed. Index Terms--Decentralized networked control systems （NCS）, distributed networked control systems, network constraints, net- worked control system, quantization, time delays.

Scheduling and control co-design for Networked Wind Energy Conversion Systems

Fieldbus, industrial Ethernet that is simple, reliable, economical, and practical, is widely used in Wind Energy Conversion Systems(WECSs). These techniques belong to the field of networked control systems. Network embedding to Wind Energy Conversion Systems brings many new challenges. Implementing a control system over a communication network causes inevitable time delays that may degrade performance and can even cause instability. This work addresses challenges related to the reliable control of wind energy conversion systems, based on the theoretical framework of networked control systems. A type of WECS with network-induced delay and packet dropout is modeled and adjustable deadbands are explored as a solution to reduce network traffic in WECSs. A method to study the reliable control of WECSs is presented, which takes into account system response as well as the network environment. After detailed theoretical analysis, simulation results are provided, which further demonstrate the feasibility of the proposed scheme.