对Ni Cr Fe V Ga系合金进行了X射线衍射和热机械分析(TMA)。结果表明,在室温至940℃范围内,合金的晶格点阵参数逐渐增大,线胀系数为正;在940～1150℃范围内,合金的晶格点阵参数逐渐降低,线胀系数为负,进行了K效应转变。用热力学理论对...对Ni Cr Fe V Ga系合金进行了X射线衍射和热机械分析(TMA)。结果表明,在室温至940℃范围内,合金的晶格点阵参数逐渐增大,线胀系数为正;在940～1150℃范围内,合金的晶格点阵参数逐渐降低,线胀系数为负,进行了K效应转变。用热力学理论对实验结果进行了解释。展开更多
The corrosion behavior of the new Ni-Cr-Fe base superalloy GH984G in a synthetic coal ash and flue gas environments was studied at 700 ℃. The results showed that the corrosion rate was slow during the initial corrosi...The corrosion behavior of the new Ni-Cr-Fe base superalloy GH984G in a synthetic coal ash and flue gas environments was studied at 700 ℃. The results showed that the corrosion rate was slow during the initial corrosion stage, then followed by a stage of faster mass loss. During the corrosion test, the scale trended to spall slightly, resulting in the formation of corrosion pits on the sample surfaces. The main corrosion products were identified as NiFeCrO4 and a small amount of Cr2O3. The scale microstructure involved the presence of three corrosion layers. The outer layer contained Cr, Ni, Fe, O and a small amount of S. Many micro-cracks were detected in the Cr-rich intermediate oxide layer. The inner corrosion layer was thin and rich in S. Internal sulfidation and internal oxidation occurred in the substrate. Because of its relatively high Cr content, the GH984G superalloy exhibited a good corrosion resistance under the test conditions.展开更多
基金financially supported by National Science Foundation of China (Grant No. 51161022)the Science and Technology Foundation of Department of Education of Jiangxi Province, China (Nos. DB201301133, 201301050)
文摘The corrosion behavior of the new Ni-Cr-Fe base superalloy GH984G in a synthetic coal ash and flue gas environments was studied at 700 ℃. The results showed that the corrosion rate was slow during the initial corrosion stage, then followed by a stage of faster mass loss. During the corrosion test, the scale trended to spall slightly, resulting in the formation of corrosion pits on the sample surfaces. The main corrosion products were identified as NiFeCrO4 and a small amount of Cr2O3. The scale microstructure involved the presence of three corrosion layers. The outer layer contained Cr, Ni, Fe, O and a small amount of S. Many micro-cracks were detected in the Cr-rich intermediate oxide layer. The inner corrosion layer was thin and rich in S. Internal sulfidation and internal oxidation occurred in the substrate. Because of its relatively high Cr content, the GH984G superalloy exhibited a good corrosion resistance under the test conditions.
基金Project(51974048) supported by the National Natural Science Foundation of ChinaProject(CQBX202225) supported by Postdoctoral Innovation Talent Program of Chongqing,ChinaProject(CSTB2023NSCQ-BHX0166) supported by Natural Science Foundation of Chongqing,China。
