The Conversion of Non-Dispersed Polymers into Low-Potassium Anti-Collapse Drilling Fluids

Different drillingfluid systems are designed according to mineral composition,lithology and wellbore stability of different strata.In the present study,the conversion of a non-dispersed polymer drillingfluid into a low potas-sium anti-collapsing drillingfluid is investigated.Since the two drillingfluids belong to completely different types,the key to this conversion is represented by new inhibitors,dispersants and water-loss agents by which a non-dispersed drillingfluid can be turned into a dispersed drillingfluid while ensuring wellbore stability and reason-able rheology(carrying sand—inhibiting cuttings dispersion).In particular,the(QYZ-1)inhibitors and(FSJSS-2)dispersants are used.The former can inhibit the hydration expansion capacity of clay,reduce the dynamic shear force and weaken the viscosity;the latter can improve the sealing effect and reduce thefiltrate loss.The results have shown that after adding a reasonable proportion of these substances(QYZ-1:FSJSS-2)to the non-dispersed polymer drillingfluid,while the apparent viscosity,plastic viscosity,structural viscosity andfluidity index under-went almost negligible changes,the dynamic plastic ratio increased,and thefiltration loss decreased significantly,thereby indicating good compatibility.According to the tests(conducted in the Leijia area),the density was 1.293 g/cm3,and after standing for 24 h,the SF(static settlement factor)was 0.51.Moreover,thefiltration loss was reduced to 4.0 mL,the rolling recovery rate reached 96.92%,with excellent plugging and anti-collapse performances.

Synthesis and Flocculation of Polyacrylamide with Low Water Absorption for Non-dispersible Underwater Concrete

The polyacrylamide which is directly added into concrete shows strong water absorption property.Thus the construction of underwater constructure would demand high amount of water,resulting in poor workability of concrete and strength shrinkage after hardening.Herein,a kind of anionic polyacrylamide(APAM)grafted with water reducing functional group(-COOH)was synthesized at low temperatures by partial factor design and response surface design.The structure and morphology of APAM were characterized by UV,FTIR and SEM methods.The experimental results show that the molecular weight of the synthesized APAM could reach 11 million,under the condition that the temperature was 35℃,the pH value was 8,the monomer concentration was 27wt%,the initiator dosage was 0.6wt%,and the monomer ratio(n(AM):n(AA))was 3.When the APAM was applied into the underwater slurry,it presented good flocculation and low water demand.When the dosage was 1%of the mass of the cement,the water demand increased by 12%,which could meet the self-leveling and anti-dispersity of the underwater slurry at the same time.This technology provides technical guidance for the large-scale industrial production of polyacrylamide for underwater concrete construction while achieving environmental protection during production.

Preparation of High Performance Non-dispersible Concrete

A new-type underwater non-dispersible concrete admixture NDA was prepared,its function mechanism was analyzed,and C40 high performance non-dispersible underwater concrete was manufactured by applying NDA.The results indicate that NDA has a suitable workability,low strength loss,and excellent anti-dispersion;the fresh non-dispersible underwater concrete with NDA has high anti-dispersion,excellent workability such as self-compacting and not bleeding;hardened non-dispersible underwater concrete with NDA has a high strength,high durability such as high anti-abrasion,impermeability and anticorrosion.

Analysis on Pore Structure of Non-Dispersible Underwater Concrete in Saline Soil Area

In this paper,mercury intrusion porosimetry(MIP)is used to test the pore structure of non-dispersible underwater concrete so as to study the influence of pouring and curing environment,age and slag powder on the pore characteristics of concrete,analyze the pore characteristics,porosity and pore distribution of concrete in different hydration stages,and reveal the relationship between pore structure and permeability of concrete.The results show that the pore-size distribution of concrete in fresh water condition is better than that in sulfate environment and mixed salt environment,and therefore,sulfate as well as mixed salt are not conducive to the development of pore structure of non-dispersible underwater concrete;chlorine salt has little effect on the pore structure of nondispersible underwater concrete;under the three conditions of sulfate,chlorine and mixed salt,the porosity of concrete mixed with slag powder is lower than that of concrete without slag powder.The results indicate that the addition of slag powder can ameliorate the pore size distribution of non-dispersed underwater concrete,reduce the porosity,and make the concrete structure more compact,which is beneficial to improve the permeability resistance of concrete at the macro level.

Effect of GGBS on performance deterioration of non-dispersible underwater concrete in saline soil

In saline soil areas,there are a large number of ions in soil or water environments,such as Cl^(-)and SO_(4)^(2-),which have strong corrosive interactions with buildings.To study the deterioration of non-dispersible underwater concrete in sulfate,chloride,and mixed salt environments,the compressive strength and deterioration resistance coefficient of the studied concrete mixed with different amounts of ground granulated blast-furnace slag(GGBS)were analyzed in this paper.At the same time,the micro morphology and corrosion products distribution of the studied concrete were observed by means of SEM,plus XRD diffraction,TG-DTG and FT-IR analyses to explore the influence of corrosive solutions on the hydration products of concrete.We also analyzed the mechanism of improving the deterioration resistance of the studied concrete by adding GGBS in a saline soil environment.The results show that the compressive strength of the studied concrete in a chloride environment was close to that in a fresh water environment,which means that chloride has no adverse effect on compressive strength.The deterioration of the studied concrete was most serious in a sulfate environment,followed by mixed salt environment,and the lowest in a chloride environment.In addition,by adding GGBS,the compressive strength and deterioration resistance of the studied concrete could be effectively improved.

Cross-interference correction and simultaneous multi-gas analysis based on infrared absorption

In this paper, we present simultaneous multiple pollutant gases （CO2, CO, and NO） measurements by using the non-dispersive infrared （NDIR） technique. A cross-correlation correction method is proposed and used to correct the cross-interferences among the target gases. The calculation of calibration curves is based on least-square fittings with third-order polynomials, and the interference functions are approximated by linear curves. The pure absorbance of each gas is obtained by solving three simultaneous equations using the fitted interference functions. Through the interference correction, the signal created at each filter channel only depends on the absorption of the intended gas. Gas mixture samples with different concentrations of CO2, CO, and NO are pumped into the sample cell for analysis. The results show that the measurement error of each gas is less than 4.5%.

Extraction of Neodymium by Emulsion-Liquid-Membrane within Hollow-Fiber-contactor and Its Mass Transfer Properties

A non-dispersive extraction technique, using an emulsion liquid membrane within a hollow-fiber-contactor for the extraction and enrichment of Nd^3＋ from the dilute feed aqueous, was applied. The emulsion system is consisted of span80 [ sorbitian monooleate], paraffin oil, D2EHPA [ 2-（ 2-ethylhexyl- phosphonic acid）], kerosene as well as HCl solution. The extraction under various conditions such as the span80 concentrations, the flow rate of aqueous, the extraction time and HCl concentrations in receiving phase were studied. Results show that the lower the flow rates of aqueous are, the higher the extraction percentage and enrichment-fold are, and the extraction percentage increases with the increasing of HCl concentrations. When the initial Nd^3＋ concentration in feed is maintained at 1000 mg· L^-1 and the emulsion is recycled with 70 times by a counter-flow,

A low-cost in-situ CO_(2) sensor based on a membrane and NDIR for long-term measurement in seawater

The multi-point simultaneous long-term measurement of CO_(2) concentration in seawater can provide more-valuable data for further understanding of the spatial and temporal distribution of CO_(2).Thus,the requirement for a low-cost sensor with high precision,low power consumption,and a small size is becoming urgent.In this work,an in-situ sensor for CO_(2) detection in seawater,based on a permeable membrane and non-dispersive infrared(NDIR)technology,is developed.The sensor has a small size(Ф66 mm×124 mm),light weight(0.7 kg in air),low power consumption(<0.9 W),low cost(<US$1000),and high-pressure tolerance(<200 m).After laboratory performance tests,the sensor was found to have a measurement range of(0–2000)×10^(-6),and the gas linear correlation R^(2) is 0.99,with a precision of about 0.98%at a sampling rate of 1 s.A comparison measurement was carried out with a commercial sensor in a pool for 7 days,and the results showed a consistent trend.Further,the newly developed sensor was deployed in Qingdao nearshore water for 35 days.The results proved that the sensor could measure the dynamic changes of CO_(2) concentration in seawater continuously,and had the potential to carry out long-term observations on an oceanic platform.It is hoped that the sensor could be applied to field ocean observations in near future.

Portable Analyzer for Rapid Analysis of Total Protein, Fat and Lactose Contents in Raw Milk Measured by Non-dispersive Short-wave Near-infrared Spectrometry

A novel portable analyzer for raw milk quality control during the material purchase at dairy plants was developed, by which the percentages（mass fraction） of main components including total protein, fat, and lactose of an unhomogenized milk sample could be determinated in 1 min with the help of non-dispersive short-wave near-infrared （NDSWNIR） spectrometry in a wavelength range from 600 nm to 1100 nm and multivariate calibration. The analyzer was designed with a single-beam optical system, which comprised a temperature control module, a multi-channel narrow-band light source（16 wavelengths）, a glass absorption cell with 15 mm sample thickness, a silicon photodiode detector, several compound lenses and a recorder module. A total of 80 raw milk samples were collected at a dairy farm twice a month for 4 months. The samples were scanned with a common UV-Vis-NIR spectrometer and analyzed according to China GB standard methods. The uninformative variables elimination（UVE） method was carried out on the spectrum data and the percentages of main components of all the samples to choose the peak emitting wavelength of each channel of the light source. Another 90 raw milk samples were collected from the same dairy farm thrice a month for 3 months. The samples were analyzed according to China GB standard methods and with the proposed analyzer. The percentages of the main components and the NDSWNIR absorption data of the samples were used for the construction and validation of the multivariate calibration model with partial least squares（PLS） method. The root-mean-square errors of prediction（RMSEP） of total protein, fat and lactose were 0.201, 0.172 and 0.247 and the coefficients of correlation（R） were 0.932, 0.981 and 0.933, respectively.

Non-dispersive solvent extraction ofp-toluic acid from purifiedterephthalic acid plant wastewater with p-xylene as extractant

Non-dispersive solvent extraction （NDSE） with p-xylene as extractant was employed as a novel separation methodto recover both ρ-toluic （PT） acid and water from purified terephthalic acid （PTA） wastewater. The mass transport behavior ofPT acid from aqueous solution to ρ-xylene was investigated by experiments and numerical simulation. Experiments showed thatNDSE is feasible and effective. Residual PT acid in the raffinate can be reduced to lower than the permitted limit of wastewaterre-use （100 g/m^3） with extraction time longer than 60 s in industrial conditions. A mathematical model of PT acid mass transportwas developed to optimize the membrane module performance. The model was validated with the experimental results withrelative errors of less than 6%. Numerical analysis for mass transfer through the lumen side, the porous membrane layer, and theshell side showed that PT acid transport in the aqueous solution is the rate determining step. The effects of the membrane andoperating parameters on membrane module performance were investigated by means of computational simulations. The keyparameters suggested for industrial NDSE design are： fiber inner radius r1=200-250 μm, extraction time tc=50-60 s, aqueous/organic volumetric ratio a/o=9.0, and temperature T-318 K.

Quantitative Structure-Activity Relationship for Some Substituted Aromatic Compounds

In recent years, since thousands of new chemicals have been produced and put into the environment, it is important for us to screen the chemicals which have potential toxicity. So QSAR (quantitative structure-activity relationship) has been widely used.