Clean Separation Process of Chabocuo Saline Lake in Tibet

1 Introduction Chabocuo Lake is located in the territory of Gaize County Ali area Tibet,the altitude of the lake-surface is4505 m with a total area of 32 Km2.It is a typical sulfate type saline and rich in boron and lithium.In the natural evaporation process,several mineral sylvites cocrystallize out,thus increases the difficulties for separating and

Mixed-conducting ceramic–carbonate membranes exhibiting high CO2/O2 permeation flux and stability at high temperatures

This investigation demonstrates the feasibility to fabricate high quality ceramic–carbonate membranes based on mixed-conducting ceramics.Specifically,it is reported the simultaneous CO2/O2 permeation and stability properties of membranes constituted by a combination of ceramic and carbonate phases,wherein the microstructure of the ceramic part is composed,in turn,of a mixture of fluorite and perovskite phases.These ceramics showed ionic and electronic conduction,and at the operation temperature,the carbonate phase of the membranes is in liquid state,which allows the transport of CO32-and O2–species via different mechanisms.To fabricate the membranes,the ceramic powders were uniaxially pressed in a disk shape.Then,an incipient sintering treatment was carried out in such a way that a highly porous ceramic was obtained.Afterwards,the piece is densified by the infiltration of molten carbonate.Characterization of the membranes was accomplished by SEM,XRD,and gas permeation techniques among others.Thermal and chemical stability under an atmosphere rich in CO2 was evaluated.CO2/O2 permeation and long-term stability measurements were conducted between 850 and 940℃.The best permeation–separation performance of membranes of about 1 mm thickness,showed a maximum permeance flux of about 4.46×10^–7 mol·m^–2·s^–1·Pa^–1 for CO2 and 2.18×10^–7 mol·m^–2·s^–1·Pa^–1 for O2 at 940℃.Membranes exhibited separation factor values of 150–991 and 49–511 for CO2/N2 and O2/N2 respectively in the studied temperature range.Despite long-term stability test showed certain microstructural changes in the membranes,no significant detriment on the permeation properties was observed along 100 h of continuous operation.

Greenhouse gas emissions from different pig manure management techniques： a critical analysis

Manure management is the primary source of greenhouse gas （GHG） emissions from pig farming, which in turn accounts for 18% of the total global GHG emissions from the livestock industry. In this review, GHG emissions （N20 and CH4 emissions in particular） from individual pig manure （PGM） management practices （European practises in particular） are systematically analyzed and discussed. These manure management practices include manure storage, land application, solid/liquid separation, anaerobic digestion, composting and aerobic wastewater treatment. The potential reduction in net GHG emissions by changing and optimising these techniques is assessed. This review also identifies key research gaps in the literature including the effect of straw covering of liquid PGM storages, the effect of solid/liquid separation, and the effect of dry anaerobic digestion on net GHG emissions from PGM management. In addition to identifying these research gaps, several recommendations including the need to standardize units used to report GHG emissions, to account ~br indirect N20 emissions, and to include a broader research scope by conducting detailed life cycle assessment are also discussed. Overall, anaerobic digestion and compositing to liquid and solid fractions are best PGM management practices with respect to their high GHG mitigation potential.

Covering α-Fe2O3 protection layer on the surface of p-Si micropillar array for enhanced photoelectrochemical performance

The spontaneous oxidation process of pristine silicon （Si） limits its application as photocatalyst or electrode in aqueous solution or moist air. Covering a protection layer on Si surface is an effective approach to overcome this disadvantage. In this paper, α-Fe2O3 is demonstrated to be an excellent alternative as a protection material, α-Fe2O3 layer was deposited around each p-type Si micropillar （SiMP） in well-ordered array by chemical bath ＂deposition ＂method. The diameter of SiMP was 3 μm and the thickness of α-Fe2O3 layer was about 20 nm. The photoeletrochemical stability of SiMP/α-Fe2O3 was proved by 10 circles cyclic voltammetr7 testing. Compared with SiMP, its optical absorption and photocurrent density improved 2 times and 4 times, respectively, and its onset potential for hydrogen evolution moved positively about 0.4 V. These improved performances could be ascribed to the enhanced photogenemted-charge-separation efficiency deriving from built-in electric field at the interface between Si and α-Fe2O3. The above results show an effective strategy to utilize Si material as photocatalyst or electrode in aqueous solution or moist air.