Diagnostic efficacy of virtual organ computer-assisted analysis in measuring the volume ratio of subchorionic hematoma with serum progesterone

BACKGROUND Subchorionic hematoma(SCH)is a common complication in early pregnancy characterized by the accumulation of blood between the uterine wall and the chorionic membrane.SCH can lead to adverse pregnancy outcomes such as miscarriage,preterm birth,and other complications.Early detection and accurate assessment of SCH are crucial for appropriate management and improved pregnancy outcomes.AIM To evaluate the diagnostic efficacy of virtual organ computer-assisted analysis(VOCAL)in measuring the volume ratio of SCH to gestational sac(GS)combined with serum progesterone on early pregnancy outcomes in patients with SCH.METHODS A total of 153 patients with SCH in their first-trimester pregnancies between 6 and 11 wk were enrolled.All patients were followed up until a gestational age of 20 wk.The parameters of transvaginal two-dimensional ultrasound,including the circumference of SCH(Cs),surface area of SCH(Ss),circumference of GS(Cg),and surface area of GS(Sg),and the parameters of VOCAL with transvaginal three-dimensional ultrasound,including the three-dimensional volume of SCH(3DVs)and GS(3DVg),were recorded.The size of the SCH and its ratio to the GS size(Cs/Cg,Ss/Sg,3DVs/3DVg)were recorded and compared.RESULTS Compared with those in the normal pregnancy group,the adverse pregnancy group had higher Cs/Cg,Ss/Sg,and 3DVs/3DVg ratios(P<0.05).When 3DVs/3DVg was 0.220,the highest predictive performance predicted adverse pregnancy outcomes,resulting in an AUC of 0.767,and the sensitivity,specificity were 70.2%,75%respectively.VOCAL measuring 3DVs/3DVg combined with serum progesterone gave a diagnostic AUC of 0.824 for early pregnancy outcome in SCH patients,with a high sensitivity of 82.1%and a specificity of 72.1%,which showed a significant difference between AUC.CONCLUSION VOCAL-measured 3DVs/3DVg effectively quantifies the severity of SCH,while combined serum progesterone better predicts adverse pregnancy outcomes.

Thermal Analysis of Organic Light Emitting Diodes Based on Basic Heat Transfer Theory

We investigate the thermal characteristics of standard organic light-emitting diodes （OLEDs） using a simple and clear 1D thermal model based on the basic heat transfer theory. The thermal model can accurately estimate the device temperature, which is linearly with electrical input power. The simulation results show that there is almost no temperature gradient within the OLED device working under steady state conditions. Furthermore, thermal analysis simulation results show that the surface properties （convective heat transfer coetficient and surface emissivity） of the substrate or cathode can significantly affect the temperature distribution of the OLED.

Clinical analysis of different periods of liver transplantation at an organ transplantation centre

Objective To summarize our clinical experience in liver transplantation while considering the background in this filed in China. Methods Ninety-five patients who had received liver transplantation from April 1993 to March 2002 were analyzed retrospectively. Three periods were defined objectively as period Ⅰ(1993-1997),Ⅱ(1999) and Ⅲ(2000 -2002). Operative techniques, recipients, original diseases, complications and survival rates were compared among the three periods. Results Malignant liver lesions were the main cause for liver transplantation in period Ⅰ and Ⅱ. The ratio of number of malignant disease to total recipients decreased gradually from period Ⅰ to Ⅱ (100%, 53% and 35%, respectively). The 1-year survival rate in patients with benign liver disease was 85 % and the total operative mortality was 5% in period Ⅲ. The incidence of hepatitis B virus reactivation or reinfection was 24% twelve months after liver transplantation. Vascular complication decreased but biliary complications did

Compositional and Structural Difference of Fulvic Acid from Black Soil Applied with Different Organic Materials: Assessment After Three Years

Knowledge of different effects of various organic materials on soil humic substance is important for both environmental safety and sustainable agriculture.A pot experiment was conducted at Jilin Agricultural University,Jilin Province in northeast China to discover the influence of herb residue,animal excrement,woody residue,animal remnant on fulvic acid（FA） composition and structure using differential thermal analysis-thermogravimetric（DTA-TG）,fourier transform infrared spectroscopy（FTIR） and elemental analysis.DTA-TG showed the range of peak temperature in the first exothermic reaction increased following the trend： CK〉herb residue〉animal excrement〉woody residue=animal remnant,and the most weight loss was observed in animal excrement.Moreover,the second exothermic reaction of CK-and animal excrement-FA was presented as double peaks,the order of weight loss in that area was animal remnant〉CK〉woody residue〉animal excrement〉herb residue.According to FTIR,herb residue displayed higher adsorption intensity at 2 950,1 420,1 240 and 1 030 cm-1,animal excrement was in reverse.At the same time,herb residue-and animal excrement-FA had an absorption peak at 1 720 cm-1,while other organic materials didn＇t have this peak.As elemental analysis showed,FA isolated from various treatments was significantly distinct.It was clearly shown from our results that FA composition and structure in amended soils may be affected in different ways and at various extents on dependence of the nature and origin of amendment.

Comparison of three-dimensional fluorescence analysis methods for predicting formation of trihalomethanes and haloacetic acids

This work investigated the application of several fluorescence excitation–emission matrix analysis methods as natural organic matter（NOM） indicators for use in predicting the formation of trihalomethanes（THMs） and haloacetic acids（HAAs）. Waters from four different sources（two rivers and two lakes） were subjected to jar testing followed by 24 hr disinfection by-product formation tests using chlorine. NOM was quantified using three common measures： dissolved organic carbon, ultraviolet absorbance at 254 nm, and specific ultraviolet absorbance as well as by principal component analysis, peak picking,and parallel factor analysis of fluorescence spectra. Based on multi-linear modeling of THMs and HAAs, principle component（PC） scores resulted in the lowest mean squared prediction error of cross-folded test sets（THMs： 43.7（μg/L）^2, HAAs： 233.3（μg/L）^2）. Inclusion of principle components representative of protein-like material significantly decreased prediction error for both THMs and HAAs. Parallel factor analysis did not identify a protein-like component and resulted in prediction errors similar to traditional NOM surrogates as well as fluorescence peak picking. These results support the value of fluorescence excitation–emission matrix–principal component analysis as a suitable NOM indicator in predicting the formation of THMs and HAAs for the water sources studied.

Chemical characteristics and source apportionment of PM_(2.5) between heavily polluted days and other days in Zhengzhou, China

PM（2.5） samples were collected in Zhengzhou during 3 years of observation, and chemical characteristics and source contribution were analyzed. Approximately 96% of the daily PM（2.5） concentrations and annual average values exceeded the Chinese National Ambient Air Quality Daily and Annual Standards, indicating serious PM（2.5） pollution. The average concentration of water-soluble inorganic ions was 2.4 times higher in heavily polluted days（daily PM32.5 concentrations ＆gt; 250 μg/mand visibility ＆lt; 3 km） than that in other days, with sulfate, nitrate, and ammonium as major ions. According to the ratio of NO-3/SO2-4,stationary sources are still the dominant source of PM（2.5） and vehicle emission could not be ignored. The ratio of secondary organic carbon to organic carbon indicated that photochemical reactivity in heavily polluted days was more intense than in other days.Crustal elements were the most abundant elements, accounting for more than 60% of 23 elements. Chemical Mass Balance results indicated that the contributions of major sources（i.e., nitrate, sulfate, biomass, carbon and refractory material, coal combustion, soil dust,vehicle, and industry） of PM（2.5） were 13%, 16%, 12%, 2%, 14%, 8%, 7%, and 8% in heavily polluted days and 20%, 18%, 9%, 2%, 27%, 14%, 15%, and 9% in other days, respectively.Extensive combustion activities were the main sources of polycyclic aromatic hydrocarbons during the episode（Jan 1-9, 2015） and the total benzo[a]pyrene equivalency concentrations in heavily polluted days present significant health threat. Because of the effect of regional transport, the pollution level of PM（2.5） in the study area was aggravated.

Identifying the major fluorescent components responsible for ultrafiltration membrane fouling in different water sources

Three-dimensional fluorescence excitation–emission matrix（EEM） coupled with parallel factor analysis（PARAFAC） was performed for a total of 18 water samples taken from three water sources（two lakes and one wastewater treatment plant（WWTP） secondary effluent）,with the purpose of identifying the major ultrafiltration（UF） membrane foulants in different water sources. Three fluorescent components（C1, C2 and C3） were identified,which represented terrestrially derived humic-like substances（C1）, microbially derived humic-like substances（C2）, and protein-like substances（C3）. The correlations between the different fluorescent components and UF membrane fouling were analyzed. It was shown that for the WWTP secondary effluent, all three components（C1, C2 and C3） made a considerable contribution to the irreversible and total fouling of the UF membrane.However, for the two lakes, only the C3 exhibited a strong correlation with membrane fouling, indicating that the protein-like substances were the major membrane foulants in the lake waters. Significant attachment of C1, C2 and C3 to the UF membrane was also confirmed by mass balance analyses for the WWTP secondary effluent; while the attachment of C1 and C2 was shown to be negligible for the two lakes. The results may provide basic formation for developing suitable fouling control strategies for sustainable UF processes.

A new technique helps to uncover unknown peptides and disinfection by-products in water

Environmental water samples can be extremely complex,with potentially thousands of molecules that can derive from natural organic matter（NOM）and thousands that derive from anthropogenic contaminants.As complex as these samples are,drinking water can be even more complex.Due to disinfectants that are used to treat drinking water（e.g.,chlorine,chloramines,

Boron Oxide Glasses and Nanocomposites: Synthetic, Structural and Statistical Approach

Three different precursors of boron-aqua and glycerol solutions of boric acid and ethanol solution of trimethyl borate were used for the preparation of organic–inorganic advanced materials. The films and bulk materials samples were heat treated at 100, 400, 800？C for 2 h. The hybrid samples were stable and transparent until 100？C. The further increase of temperature to 400？C led to destruction of samples, and at 800？C they were molten. The structural changes during the pyrolysis were studied by Fourier transform infrared spectroscopy, differential thermal analysis, and X-ray diffraction. Details of surface morphology were observed by scanning electron microscopy. The obtained BO_3 and BO_4 groups were identified in the molten materials after pyrolysis. The quantities and order of borate structural units as well as residual carbon in the networks depended on boron precursor type. PVA/PEG/B_2O_3 hybrid materials were proved to be appropriate precursors for synthesizing borate and carboborate glass and carbon/borate glass nanocomposites. To access the impact of the experimental conditions on the structural changes of the nanocomposites, cluster analysis of the IR-spectral data was used as a classification method.