If the operating voltage of anode materials is below 1.0 V versus Lit/Li,the side reaction between electrolyte and anode materials will occur extensively.Thus,high-voltage anode materials have aroused interest recentl...If the operating voltage of anode materials is below 1.0 V versus Lit/Li,the side reaction between electrolyte and anode materials will occur extensively.Thus,high-voltage anode materials have aroused interest recently.In this work,we report the preparation of PNb9O25 nanofiber via a facile electrospinning method.The PNb9O25 nanofiber shows the high rate performance and excellent cycling performance when it is used as anode in lithium ions batteries.For instance,the PNb9O25 nanofiber can deliver a capacity of 233,212.1,193.8,and 181.4 mA h g^(-1) at 0.2,1,3,and 6C,respectively.After 1000 cycles,it can reach at 134.3 mA h g^(-1) with capacity retention of 70.9%.Meanwhile,the ex situ X-ray photoelectron spectroscopy technique has been adopted to investigate the evolution in valence state of each element for PNb9O25 nanofiber.In addition,the PNb9O25 nanofiber is chosen as the anode material in lithium ion full cell in this work,demonstrating the potential for practical application.展开更多
In this paper a preliminary investigation of a novel optoelectronic polymer, poly (p-phenylene N-4-n-butylphenyl-N,N-bis- 4-vinylenephenylamine) (PNB), is reported. A single layer structure of ITO/PNB/Al was prepared ...In this paper a preliminary investigation of a novel optoelectronic polymer, poly (p-phenylene N-4-n-butylphenyl-N,N-bis- 4-vinylenephenylamine) (PNB), is reported. A single layer structure of ITO/PNB/Al was prepared via spin-coating of PNB solution as a thin film on the top of an ITO substrate, while aluminum top electrode was vacuum evaporated. Dark current- voltage characteristics of this device showed a typical rectifying behaviour. Photovoltaic response under a monochromatic illumination at 420 nm was observed, with an open circuit voltage of 0.3 V and fill factor of 0.21. Spectral response and optical absorption were found to be matched well. It was also discovered that the device showed a green electroluminescent emission at a forward bias. Turn-on voltage of the device was about 6 V and light output about 22.6 nW at a forward bias of 10 V. The work demonstrated that the PNB material might possess dual exciton sites resulting in a competition for excitons to be either separated or recombined. Both effects were associated with each other, which limited the photovoltaic or electroluminescence to some degrees.展开更多
基金NSAF joint Fund(U1830106)National Natural Science Foundation of China(U1632114,21673064)K.C.Wong Magna Fund in Ningbo University.
文摘If the operating voltage of anode materials is below 1.0 V versus Lit/Li,the side reaction between electrolyte and anode materials will occur extensively.Thus,high-voltage anode materials have aroused interest recently.In this work,we report the preparation of PNb9O25 nanofiber via a facile electrospinning method.The PNb9O25 nanofiber shows the high rate performance and excellent cycling performance when it is used as anode in lithium ions batteries.For instance,the PNb9O25 nanofiber can deliver a capacity of 233,212.1,193.8,and 181.4 mA h g^(-1) at 0.2,1,3,and 6C,respectively.After 1000 cycles,it can reach at 134.3 mA h g^(-1) with capacity retention of 70.9%.Meanwhile,the ex situ X-ray photoelectron spectroscopy technique has been adopted to investigate the evolution in valence state of each element for PNb9O25 nanofiber.In addition,the PNb9O25 nanofiber is chosen as the anode material in lithium ion full cell in this work,demonstrating the potential for practical application.
基金This work is supported by National Natural Science Foundationof China(20344002,10434030) State Key Program forBasic research of China (2003CB314707)
文摘In this paper a preliminary investigation of a novel optoelectronic polymer, poly (p-phenylene N-4-n-butylphenyl-N,N-bis- 4-vinylenephenylamine) (PNB), is reported. A single layer structure of ITO/PNB/Al was prepared via spin-coating of PNB solution as a thin film on the top of an ITO substrate, while aluminum top electrode was vacuum evaporated. Dark current- voltage characteristics of this device showed a typical rectifying behaviour. Photovoltaic response under a monochromatic illumination at 420 nm was observed, with an open circuit voltage of 0.3 V and fill factor of 0.21. Spectral response and optical absorption were found to be matched well. It was also discovered that the device showed a green electroluminescent emission at a forward bias. Turn-on voltage of the device was about 6 V and light output about 22.6 nW at a forward bias of 10 V. The work demonstrated that the PNB material might possess dual exciton sites resulting in a competition for excitons to be either separated or recombined. Both effects were associated with each other, which limited the photovoltaic or electroluminescence to some degrees.
