Microstructure and mechanical properties of Ti/Al/Ti clad plates prepared via powder-in-tube method

The Ti/Al/Ti clad plates exhibit a broad spectrum of potential applications.However,the conventional techniques of hot-pressing composite and explosive composite are intricate and environmentally hazardous.A novel method was introduced for preparing clad plates,namely,the powder-in-tube method.This method involves a combination of cold rolling,annealing at a temperature of 550℃,and double rolling.The morphology of the intermetallic compound layer was analyzed through the utilization of interface stripping test,tensile test,and microscopic characterization.The interface morphology,interface bonding properties,tensile fracture structures,and properties of plates under the first and second rolling were compared,along with the effects of intermetallic compounds on the interface properties.The results indicate that the powder-in-tube method,when annealed at 550℃,can produce a composite plate featuring a complete and uniform Ti/Al interface.The obtained plate exhibits a peeling strength of 21.5 N/mm,tensile strength of 424 MPa,and elongation of 11.5%.Furthermore,a systematic analysis was conducted to determine the causes of performance degra-dation observed during annealing at temperatures of 600 and 650℃.

High critical current density in powder-in-tube processed MgB_2/Ta/Cu wire

The magnetization of dense MgB2/Ta/Cu wires prepared by the powder-in-tube method is measured by a SQUID magnetometer. The results indicate that the critical temperature of MgB2/Ta/Cu is around 38.4 K with a sharp transition width of 0.6 K. The MgB2/Ta/Cu wire shows a strong flux pinning and the critical current density is higher than 105 A/cm2 (5 K, self-field) and 104 A/cm2 (20 K, 1 T). Also, the irreversibility field of the sample reaches 6.6 T at 5 K.

Experiment and Simulation for Rolling of Diamond–Cu Composites

We demonstrate an innovative preparation approach of diamond/Cu composites by powder-in-tube technique and rolling. A small copper tube was loaded with Ti- and Cu-coated diamond particles, mad then the diamond particles were combined with Cu matrix by composite rolling. The morphology and element distribution of the interface between diamond and Cu were determined by scanning electron microscopy and energy-dispersive spectrometer. Finite element method （FEM） simulation was used to analyze the rolling process associated with experiment by DEFORM-3D. The final experimental results showed that homogeneous distribution of diamond particles could be observed in the center layer of the composites. According to the contrast experiments, the sample, whose diamond particle size is 0.12-0.15 mm and thickness of pre-rolling is 1.2 mm, showed relatively complete morphologies and homogeneous distribution. Experimental results indicated a poor efficacy of excessive rolling reduction. The thermal conductivity of the composites is about 453 W （m K）-1 by theoretical calculation. For FEM simulation, roiling strain and temperature field of the composites were simulated by DEFORM-3D. Simulation results were interpreted, and numerical results verified the reliability of the model. The simulation predicted that the local area of large strain, indicative of the strain along the thickness direction, could be intensified by adding diamond particles.