On-off keying (OOK) is one of the modulation schemes for non-coherent impulse radio Ultra-wideband systems. In this paper, the utilization of the kurtosis detector (KD) and fourth power detector (FD) receivers for OOK...On-off keying (OOK) is one of the modulation schemes for non-coherent impulse radio Ultra-wideband systems. In this paper, the utilization of the kurtosis detector (KD) and fourth power detector (FD) receivers for OOK signaling is introduced. We investigate the effect of integration interval and the optimum threshold on the performance of energy detector (ED), KD and FD receivers. The semi analytic expression of BER is obtained by using generalized extreme value distribution function for KD and FD receivers. From performance point of view, the simulation results show that FD receiver outperforms KD and ED receivers. In contrast, the sensitivity to the optimum threshold is greatly reduced in KD receiver compared to ED and FD receivers.展开更多
This paper presents the design and implementation of a digitally calibrated CMOS wideband radio frequency(RF) root-mean-square(RMS) power detector for high accuracy RF automatic gain control(AGC).The proposed RMS powe...This paper presents the design and implementation of a digitally calibrated CMOS wideband radio frequency(RF) root-mean-square(RMS) power detector for high accuracy RF automatic gain control(AGC).The proposed RMS power detector demonstrates accurate power detection in the presence of process,supply voltage, and temperature(PVT) variations by employing a digital calibration scheme.It also consumes low power and occupies a small chip area.The measurement results show that the scheme improves the accuracy of the detector to better than 0.3 dB over the PVT variations and wide operating frequency range from 0.2 to 0.8 GHz.Implemented in a 0.18μm CMOS process and occupying a small die area of 263×214μm^2,the proposed digitally calibrated CMOS RMS power detector only consumes 1.6 mA in power detection mode and 2.1 mA in digital calibration mode from a 1.8 V supply voltage.展开更多
A design of high dynamic range linear radio frequency power detector （PD）, aimed for transmitter carrier leakage suppression is presented in this paper. Based on the logarithmic amplifier principle, this detector ut...A design of high dynamic range linear radio frequency power detector （PD）, aimed for transmitter carrier leakage suppression is presented in this paper. Based on the logarithmic amplifier principle, this detector utilizes the successive detection method to achieve a high dynamic range in the radio frequency band. In order to increase sensitivity, a low noise amplifier （LNA） is placed in the front of this detector. DC coupling is adopted in this architecture to reduce parasitics and save area, but this will unavoidably cause DC offsets in the circuit which are detrimental to the dynamic range. So a DC offset cancelling （DCOC） technique is proposed to solve the problem. Finally, this detector was fabricated in the SMIC 0.13μm CMOS process. The measured results show that it achieves a wide dynamic range of 50 dB/40 dB with log errors in 4-1 dB at 900 MHz/2 GHz, while draws 16 mA from a 1.5 V power supply. The active chip area is 0.27×0.67 mm2.展开更多
An E-band high speed power detector MMIC using 0.1 μm pHEMT technology has been designed, manufactured and experimentally characterized. By employing a 4-way quadrature structure for phase cancellation, the first, se...An E-band high speed power detector MMIC using 0.1 μm pHEMT technology has been designed, manufactured and experimentally characterized. By employing a 4-way quadrature structure for phase cancellation, the first, second and third harmonics can be suppressed and the ripple at the output is minimized. Compared to conventional topology with a low pass filter, a short response time and high speed performance of demodulation can be reached. Simulated results indicate that the detector is capable of demodulating an on-off keying signal at a data rate up to 5 Gbps. The fabricated chip occupies 1× 1.5 mm2 and the on-wafer measurement shows a return loss of less than -15 dB, responsivity better than 700 mV/mW and dynamic range of more than 25 dB over 70 to 90 GHz.展开更多
1GME037MV is the thrust wear detector of turbine.Before the turbine run up,the value of this channel often fluctuated.The engineer checked the channel,terminal,continuity,insulation,and driver and so on,no problem was...1GME037MV is the thrust wear detector of turbine.Before the turbine run up,the value of this channel often fluctuated.The engineer checked the channel,terminal,continuity,insulation,and driver and so on,no problem was found.At last,when disconnecting the end of the detector from the driver,then re-connected the end to the driver,the channel value is OK,after a while it became wrong again.Measured the resistance of the detector,it is 13O hm when the channel is OK,and 76 Ohm when the channel is wrong.According to the result of the checked,the conclusion is the character of the detector had changed.Both the measured value GME037MV and GME038MV are high 0.7mm,the turbine will trip,In the end the detector of GME037MV was replaced when the unit shut down.展开更多
文摘On-off keying (OOK) is one of the modulation schemes for non-coherent impulse radio Ultra-wideband systems. In this paper, the utilization of the kurtosis detector (KD) and fourth power detector (FD) receivers for OOK signaling is introduced. We investigate the effect of integration interval and the optimum threshold on the performance of energy detector (ED), KD and FD receivers. The semi analytic expression of BER is obtained by using generalized extreme value distribution function for KD and FD receivers. From performance point of view, the simulation results show that FD receiver outperforms KD and ED receivers. In contrast, the sensitivity to the optimum threshold is greatly reduced in KD receiver compared to ED and FD receivers.
基金supported by the National High Technology Research and Development Program of China(No.2009AA011608)the Chinese National Major Science and Technology Projects Program(No.2009ZX01031-002-011-001)
文摘This paper presents the design and implementation of a digitally calibrated CMOS wideband radio frequency(RF) root-mean-square(RMS) power detector for high accuracy RF automatic gain control(AGC).The proposed RMS power detector demonstrates accurate power detection in the presence of process,supply voltage, and temperature(PVT) variations by employing a digital calibration scheme.It also consumes low power and occupies a small chip area.The measurement results show that the scheme improves the accuracy of the detector to better than 0.3 dB over the PVT variations and wide operating frequency range from 0.2 to 0.8 GHz.Implemented in a 0.18μm CMOS process and occupying a small die area of 263×214μm^2,the proposed digitally calibrated CMOS RMS power detector only consumes 1.6 mA in power detection mode and 2.1 mA in digital calibration mode from a 1.8 V supply voltage.
基金Project supported by the Important National Science & Technology Specific Projects,China(No.2010ZX03001-004)the National High Technology Research and Development Program of China(No.2009AA011605)
文摘A design of high dynamic range linear radio frequency power detector （PD）, aimed for transmitter carrier leakage suppression is presented in this paper. Based on the logarithmic amplifier principle, this detector utilizes the successive detection method to achieve a high dynamic range in the radio frequency band. In order to increase sensitivity, a low noise amplifier （LNA） is placed in the front of this detector. DC coupling is adopted in this architecture to reduce parasitics and save area, but this will unavoidably cause DC offsets in the circuit which are detrimental to the dynamic range. So a DC offset cancelling （DCOC） technique is proposed to solve the problem. Finally, this detector was fabricated in the SMIC 0.13μm CMOS process. The measured results show that it achieves a wide dynamic range of 50 dB/40 dB with log errors in 4-1 dB at 900 MHz/2 GHz, while draws 16 mA from a 1.5 V power supply. The active chip area is 0.27×0.67 mm2.
基金supported by the National High Technology Research and Development Program of China(No.2015AA01A704)
文摘An E-band high speed power detector MMIC using 0.1 μm pHEMT technology has been designed, manufactured and experimentally characterized. By employing a 4-way quadrature structure for phase cancellation, the first, second and third harmonics can be suppressed and the ripple at the output is minimized. Compared to conventional topology with a low pass filter, a short response time and high speed performance of demodulation can be reached. Simulated results indicate that the detector is capable of demodulating an on-off keying signal at a data rate up to 5 Gbps. The fabricated chip occupies 1× 1.5 mm2 and the on-wafer measurement shows a return loss of less than -15 dB, responsivity better than 700 mV/mW and dynamic range of more than 25 dB over 70 to 90 GHz.
文摘1GME037MV is the thrust wear detector of turbine.Before the turbine run up,the value of this channel often fluctuated.The engineer checked the channel,terminal,continuity,insulation,and driver and so on,no problem was found.At last,when disconnecting the end of the detector from the driver,then re-connected the end to the driver,the channel value is OK,after a while it became wrong again.Measured the resistance of the detector,it is 13O hm when the channel is OK,and 76 Ohm when the channel is wrong.According to the result of the checked,the conclusion is the character of the detector had changed.Both the measured value GME037MV and GME038MV are high 0.7mm,the turbine will trip,In the end the detector of GME037MV was replaced when the unit shut down.
