Study on the Propagation Law of Shock Wave Pressure in Tunnels with Different Materials

The propagation of shock wave pressure in the tunnel is greatly affected by the tunnel structure,shape,material and other factors,and there are great differences in the propagation law of shock wave pressure in different kinds of tunnels.In order to study the propagation law of shock wave pressure in tunnels with different materials,taking the long straight tunnel with the square section as an example,the AUTODYN software is used to simulate the explosion of TNT in the concrete,steel and granite tunnel,and study on the variation law of shock wave pressure in tunnels with different materials.By using dimensional analysis and combined with the results of numerical simulation,a mathematical model of the propagation law of shock wave pressure in the tunnel is established,and the effectiveness of the mathematical model is verified by making the explosion test of the warhead in the reinforce concrete tunnel.The results show that the same mass of TNT explodes in the tunnel with different materials,and the shock wave overpressure peak at the same measuring point is approximate in the near field.However,there is a significant difference in the middle-far fields from the explosion center,the shock wave overpressure peak in the steel tunnel is 20.76%and 34.82%higher than that of the concrete and the granite tunnel respectively,and the shock wave overpressure peak in the concrete tunnel is 24.91%higher than that in the granite tunnel.Through the experimental verification,getting the result that the maximum relative deviation between the measured value and the calculated value of the shock wave overpressure peak is 11.85%.Therefore,it is proved that the mathematical model can be used to predict the shock wave overpressure peak in the tunnel with different materials,and it can provide some reference for the power evaluation of warhead explosion in the tunnel.

Numerical simulation of hydraulic fracture propagation in laminated shale reservoirs

The main area of the Jiaoshiba anticline of the Fuling shale gas field was taken as the research object,laboratory rock mechanical experiments and direct shear experiments were conducted to clarify the mechanical anisotropy characteristics and parameters of rock samples with rich beddings.Based on the experimental results,a 3D fracture propagation model of the target reservoir taking mechanical anisotropy,weak bedding plane and vertical stress difference into account was established by the discrete element method to analyze distribution patterns of hydraulic fractures under different bedding densities,mechanical properties,and fracturing engineering parameters(including perforation clusters,injection rates and fracturing fluid viscosity).The research results show that considering the influence of the weak bedding plane and longitudinal stress difference,the interlayer stress difference 3–4 MPa in the study area can control the fracture height within the zone of stress barrier,and the fracture height is less than 40 m.If the influence of the weak bedding plane is not considered,the simulation result of fracture height is obviously higher.Although the opening of high-density bedding fractures increases the complexity of hydraulic fractures,it significantly limited the propagation of fracture height.By reducing the number of clusters,increasing the injection rate,and increasing the volume and proportion of high-viscosity fracturing fluid in the pad stage,the restriction on fracture height due to the bedding plane and vertical stress difference can be reduced,and the longitudinal propagation of fractures can be promoted.The fracture propagation model was used to simulate one stage of Well A in Fuling shale gas field,and the simulation results were consistent with the micro-seismic monitoring results.