Treatment of Dye Wastewater by Using a Hybrid Gas/Liquid Pulsed Discharge Plasma Reactor

A hybrid gas/liquid pulsed discharge plasma reactor using a porous ceramic tube is proposed for dye wastewater treatment. High voltage pulsed discharge plasma was generated in the gas phase and simultaneously the plasma channel was permeated through the tiny holes of the ceramic tube into the water phase accompanied by gas bubbles. The porous ceramic tube not only separated the gas phase and liquid phase but also offered an effective plasma spreading channel. The effects of the peak pulse voltage, additive gas varieties, gas bubbling rate, solution conductivity and TiO2 addition were investigated. The results showed that this reactor was effective for dye wastewater treatment. The decoloration efficiency of Acid Orange II was enhanced with an increase in the power supplied. Under the studied conditions, 97% of Acid Orange II in aqueous solution was effectively decolored with additive oxygen gas, which was 51% higher than that with argon gas, and the increasing 02 bubbling rate also benefited the decoloration of dye wastewater. Water conductivity had a small effect on the level of decoloration. Catalysis of TiO2 could be induced by the pulsed discharge plasma and addition of TiO2 aided the decoloration of Acid Orange II.

Regeneration of Acid Orange 7 Exhausted Granular Activated Carbon Using Pulsed Discharge Plasmas

In this paper, a pulsed discharge plasma （PDP） system with a multi-needle-to-plate electrodes geometry was set up to investigate the regeneration of acid orange 7 （AO7） exhausted granular activated carbon （GAC）. Regeneration of GAC was studied under different conditions of peak pulse discharge voltage and water pH, as well as the modification effect of GAC by the pulse discharge process, to figure out the regeneration efficiency and the change of the GAC structure by the PDP treatment. The obtained results showed that there was an appropriate peak pulse voltage and an optimal initial pH value of the solution for GAC regeneration. Analyses of scanning electron microscope （SEM）, Boehm titration, Brunauer-Emmett-Teller （BET）, Horvath-Kawazoe （HK）, and X-ray Diffraction （XRD） showed that there were more mesopore and macropore in the regenerated GAC and the structure turned smoother with the increase of discharge voltage; the amount of acidic functional groups on the GAC surface increased while the amount of basic functional groups decreased after the regeneration process. From the result of the XRD analysis, there were no new substances produced on the GAC after PDP treatment.

Kinetic analysis of soil contained pyrene oxidation by a pulsed discharge plasma process

A pulsed discharge plasma（PDP） reactor with net anode and net cathode was established for investigating the pyrene degradation in soil under different pulse peak voltage,air flow rate,pyrene content in soil,initial p H value and initial water content of the soil.Pyrene oxidation within the 60 min discharge time was fitting according to the pseudo-first order equation and the corresponding reaction kinetics constants（k values） were calculated.The obtained results show that pyrene oxidation under all the different reaction conditions obeyed the pseudo-first order equation well.Higher pulsed peak voltage and appropriate air flow rate were in favor of the increase of reaction rate of pyrene oxidation.A higher k value could be achieved in the lower initial pyrene content（the value was 100 mg kg^-1）.The k value of pyrene oxidation in the case of p H=4 was 11.2 times higher than the value obtained under the condition of p H=9,while the initial water content of the soil also has a large effect on the oxidation rate of pyrene due to the effect of PDP.

Exploration of a MgO cathode for improving the intensity of pulsed discharge plasma at atmosphere

With regard to the lower density and energy of electrons in pulsed discharge plasma （PDP） at atmosphere, leading to the lower energy utilization of plasma, we propose a MgO cathode to enhance the plasma intensity according to field emission principle. The MgO cathode is prepared by an electro-depositing MgO film on a stainless steel plate. This way, the positive charges come to the cathode and accumulate on the surface of the MgO film, leading to the enhancement of the electric field intensity between the cathode and MgO film, and result in the strong emission of secondary electrons from the MgO cathode. As a result, the intensity of plasma can be enhanced. Herein, the effect of the MgO cathode on the intensity of PDP is investigated. It was shown that the discharge peak current was improved by 20% compared with that of without the MgO cathode. With increasing the MgO film thickness, discharge intensity, including the peak current, transforming charge and spectrum intensity first increased and then decreased. Higher enhancement of peak current, transforming charge and spectrum intensity were acquired with a higher peak voltage. Compared to a cathode without MgO film, the ozone production is higher with MgO cathode employed. The research proposes a novel approach for improving the intensity of discharge plasma, and also provides a reference for further application of PDP.

The Catalytic Effect of Metal Ions on the Degradation of 4-Chlorophenol Induced by an Aqueous Pulsed Discharge Plasma

The influence of metal ions, such as Fe^2＋, Fe^3＋, Cu^2＋ and Mn^2＋, on 4-CP degrada-tion was investigated in an aqueous pulsed discharge plasma system with or without the addition of a TiO2 photo-catalyst. From an analysis of the pseudo first-order rate constant （kcp） and energy efficiency （G50%） for 4-CP degradation, the experimental results show that the degrada- tion of 4-CP is much enhanced in the presence of ferrous ions at the optimal concentration of 0.2-0.8 mmol/L or 0.2 mmol/L in an aqueous pulsed discharge plasma without or with the TiO2 system, respectively, and the enhancement is ascribed to plasma induced Fenton and photo-Fenton reactions. Meanwhile, the rank of such metal ions for catalytic effect on 4-CP degradation was Fe^2＋〉 Fe^3＋ 〉 Cu^2＋ 〉 Mn^2＋ and Fe^2＋ 〉 Fe^3＋ 〉 Mn^2＋ 〉 Cu^2＋ for the former and the latter systems, respectively, and the reasons behind this were discussed through the analysis of active species, especially hydrogen peroxide.

Comparative study on the degradation of phenol by a high-voltage pulsed discharge above a liquid surface and under a liquid surface

The degradation of phenol by pulsed discharge plasma above a liquid surface(APDP) and under a liquid surface(UPDP) was compared.The effects of discharge voltage,discharge distance,initial solution conductivity and initial p H on the removal of phenol were studied.It was concluded that the removal of phenol increases with increasing discharge voltage and with decreasing discharge distance in both APDP and UPDP systems.An increase in the initial solution’s conductivity has a positive effect in the APDP system but a negative effect in the UPDP system.In addition,alkaline conditions are conducive to the degradation of phenol in the APDP system,while acidic conditions are conducive in the UPDP system.Free radical quenching experiments revealed that ·O-2has an important influence on the degradation of phenol in the APDP system,while ·OH plays a key role in the UPDP system.This paper verifies the differences in the two discharge methods in terms of phenol removal.

A comparative study on the activity of TiO_2 in pulsed plasma under different discharge conditions

In the present study,a combination of pulsed discharge plasma and TiO2（plasma/TiO2）has been developed in order to study the activity of TiO2by varying the discharge conditions of pulsed voltage,discharge mode,air flow rate and solution conductivity.Phenol was used as the chemical probe to characterize the activity of TiO2in a pulsed discharge system.The experimental results showed that the phenol removal efficiency could be improved by about 10%by increasing the applied voltage.The phenol removal efficiency for three discharge modes in the plasma-discharge-alone system was found to be highest in the spark mode,followed by the spark–streamer mode and finally the streamer mode.In the plasma/TiO2system,the highest catalytic effect of TiO2was observed in the spark–streamer discharge mode,which may be attributed to the favorable chemical and physical effects from the spark–streamer discharge mode,such as ultraviolet light,O3,H2O2,pyrolysis,shockwaves and high-energy electrons.Meanwhile,the optimal flow rate and conductivity were 0.05 m^3l^（-1）and 10μS cm^（-1）,respectively.The main phenolic intermediates were hydroquinone,catechol,and p-benzoquinone during the discharge treatment process.A different phenol degradation pathway was observed in the plasma/TiO2system as compared to plasma alone.Analysis of the reaction intermediates demonstrated that p-benzoquinone reduction was selectively catalyzed on the TiO2surface.The effective decomposition of phenol constant（De）increased from 74.11%to 79.16%when TiO2was added,indicating that higher phenol mineralization was achieved in the plasma/TiO2system.

Electrical Characteristics of Pulsed Corona Discharge Plasmas in Chitosan Solution

Pulsed discharge plasma has exhibited active potential to prepare low molecular weight chitosan. In the present study, the viscosity of ehitosan solution was decreased noticeably after treated with pulsed corona discharge plasma. An experimental investigation on electrical characteristics of pulsed corona discharge plasma in chitosan solution was conducted with a view toward getting insight into discharge process. Factors affecting I-V curve, single pulse injec- tion energy and pulse width were studied. Experimental results showed positive effect of pulsed peak voltage on discharge plasma in chitosan solution. Pulse-forming capacitor greatly influenced the discharge form, and 4 nF was observed as a suitable value for efficiently generating stable discharge plasmas. As the electrode distance was larger than 10 ram, it had slight impact on dis- charge plasma due to the excellent conductive-property of chitosan solution. The injection energy significantly increased with air flow rate, while the pulse width hardly changed as the air flow rate increased from 0.5 m^3/h to 1.0 m^3/h. This study is expected to provide reference for promoting the application of pulsed corona discharge plasma to ehitosan solution treatment.

Study on the plasma generation characteristics of an induction-triggered coaxial pulsed plasma thruster

At present,spark plugs are used to trigger discharge in pulsed plasma thrusters（PPT）,which are known to be life-limiting components due to plasma corrosion and carbon deposition.A strong electric field could be formed in a cathode triple junction（CTJ） to achieve a trigger function under vacuum conditions.We propose an induction-triggered electrode structure on the basis of the CTJ trigger principle.The induction-triggered electrode structure could increase the electric field strength of the CTJ without changing the voltage between electrodes,contributing to a reduction in the electrode breakdown voltage.Additionally,it can maintain the plasma generation effect when the breakdown voltage is reduced in the discharge experiments.The induction-triggered electrode structure could ensure an effective trigger when the ablation distance of Teflon increases,and the magnetic field produced by the discharge current could further improve the plasma density and propagation velocity.The induction-triggered coaxial PPT we propose has a simplified trigger structure,and it is an effective attempt to optimize the micro-satellite thruster.

Yield of H_2O_2 in Gas-Liquid Phase with Pulsed DBD

Electric discharge in water can generate a large number of oxidants such as ozone, hydrogen peroxide and hydroxyl radicals. In this paper, a non-thermal plasma processing system was established by means of pulsed dielectric barrier discharge in gas-liquid phase. The electrodes of discharge reactor were staggered. The yield of H2O2 was enhanced after discharge. The effects of discharge time, discharge voltage, frequency, initial pH value, and feed gas were investigated. The concentration of hydrogen peroxide and ozone was measured after discharge. The experimental results were fully analyzed. The chemical reaction equations in water were given as much as possible. At last, the water containing Rhodamine B was tested in this system. The degradation rate came to 94.22% in 30 min.

Experimental study of NO_2 reduction in N_2/Ar and O_2/Ar mixtures by pulsed corona discharge

Non-thermal plasma technology has been regarded as a promising alternative technology for NOx removal. The understanding of NO2 reduction characteristics is extremely important since NO2 reduction could lower the total NO oxidation rate in the plasma atmosphere. In this study, NO2 reduction was experimentally investigated using a non-thermal plasma reactor driven by a pulsed power supply for different simulated gas compositions and operating parameters. The NO2 reduction was promoted by increasing the specific energy density （SED）, and the highest conversion rates were 33.7%, 42.1% and 25.7% for Ar, N2/Ar and O2/Ar, respectively. For a given SED, the NO2 conversion rate had the order N2/Ar 〉 Ar 〉 02/Ar. The highest energy yield of 3.31 g/kWh was obtained in N2/Ar plasma and decreased with increasing SED; the same trends were also found in the other two gas compositions. The conversion rate decreased with increasing initial NO2 concentration. Furthermore, the presence of N2 or O2 led to different reaction pathways for NO2 conversion due to the formation of different dominating reactive radicals.

Temperature and electron density of soil plasma generated by LA-FPDPS

Electron temperature and electron number density are important parameters in the characterization of plasma. In this paper the electron temperature and electron number density of soil plasma generated by laser ablation combined with nanosecond discharge spark at different discharge voltages have been studied. Saha-Boltzmann plot and Stark broadening are used to determine the temper- ature and electron number density. It is proved that local thermal equilibrium is fulfilled in the nanosecond spark enhanced plasma. The enhanced optical emission, signal to noise ratio and the stability in term of the relative standard deviation of signal intensity at different spark voltages were investigated in detail. A relative stable discharge process was observed with use of a 10 kV discharge voltage under the carried experimental configuration.