Model tests on XCC-piled embankment under dynamic train load of high-speed railways

Piled embankments,which offer many advantages,are increasingly popular in construction of high-speed railways in China.Although the performance of piled embankment under static loading is well-known,the behavior under the dynamic train load of a high-speed railway is not yet understood.In light of this,a heavily instrumented piled embankment model was set up,and a model test was carried out,in which a servo-hydraulic actuator outputting M-shaped waves was adopted to simulate the process of a running train.Earth pressure,settlement,strain in the geogrid and pile and excess pore water pressure were measured.The results show that the soil arching height under the dynamic train load of a high-speed railway is shorter than under static loading.The growth trend for accumulated settlement slowed down after long-term vibration although there was still a tendency for it to increase.Accumulated geogrid strain has an increasing tendency after long-term vibration.The closer the embankment edge,the greater the geogrid strain over the subsoil.Strains in the pile were smaller under dynamic train loads,and their distribution was different from that under static loading.At the same elevation,excess pore water pressure under the track slab was greater than that under the embankment shoulder.

Experimental study on dynamic load magnification factor for ballastless track-subgrade of high-speed railway

The magnitude of dynamic load produced by high-speed trains depends on many factors,of which train speed is the most critical one.However,it is quite difficult to determine the effect of train speed on dynamic load using the theoretical methods due to the complexity of the interaction between vehicle and track-subgrade.Thus large-scale model test has gradually become an important approach for studying dynamic responses of ballastless track-subgrade of high-speed railway.In this study,a full-scale model of ballastless track-subgrade was constructed in accordance with the design and construction standards for Shanghai-Nanjing intercity high-speed railway line firstly.Then,the dynamic strain of slab and the dynamic earth pressure of subgrade were measured by conducting single wheel axle excitation test.In addition,the relationship between the dynamic load magnification factor（DLF） and the train speed was obtained.Finally,the DLF of track-subgrade under different train speeds was proposed,similar to that given by German Railway Standard.

Analysis of nonlinear settlement for an unsaturated soil under stage continuous loading

A new approach was proposed to describe settlement behavior of an unsaturated soil with subgrade filling for high-speed railway. Firstly, based on Terzaghi consolidation theory, equations considering the variation coefficient of consolidation with void ratio and saturation for consolidation of an unsaturated soil under stage continuous loading were derived, and according to analytical solutions of equations, a formula for settlement computation under stage continuous loading was obtained. Then, combined with the width-to-height ratio of subgrade to compute ground reaction, and by means of in-situ plate loading curves, a correctional approach was presented for the analysis of nonlinear settlement of foundation. Also, the comparison between calculated and measured loadsettlement behavior for an unsaturated soil in Qingdao-Ji'nan high-speed railway was given to demonstrate the effectiveness and accuracy of the proposed approach. It can be noted that the presented solution can be used to predict the settlement of an unsaturated soil foundation under stage continuous loading in engineering design.

DAMAGE TOLERANCE ANALYSIS ON HOLLOW AXLES OF HIGH SPEED MOTOR TRAINS

According to the rules of UIC515-3, the service loads of the axles are defined, which include some different loads cases as follows： the static loads; the impact loads resulted from running through the rail joints and unevenness rails; the loads through curves and from braking. Through the calculating and analysis, the stress distribution of the hollow axles is obtained for 200 km/h high speed motor trains used in China. At the same time, the fatigue crack growth of hollow axles is studied, and the initial surface cracks of 2 mm depth caused by hard objects strike or the other causes are discussed. On the basis of the linear elastic fracture mechanics theory, the stress intensity factor of the crack of the geometry transition outside the wheel seat is also studied. Associated with fatigue crack propagation equation and the corresponding crack propagation threshold, the crack propagation characteristics under different shapes are calculated. Then the running distances are educed with different shapes propagating to the critical length, and the estimation of the residual lives about hollow axles which are the reference values of examine and repair limit of the hollow axle is given.