Analysis of railway subgrade frost heave deformation based on GPS

In order to analyze the connection between the railway subgrade frost heave deformation and temperature variation, five GPS stations＇ data were used to monitor the deformation on a certain section of railway subgrade in northeast China. GAMIT software is used to process the data, providing daily solution, daytime solution and nighttime solution. Vertical trends of these five stations were analyzed to investigate frost heave effect on railway subgrade deformation. The results show that the temperature difference between daytime and night induces stations, significant vertical displacement, and the temperature difference between seasons causes settlement of station which appears linear trend.

Numerical simulation on flow field,wind erosion and sand sedimentation patterns over railway subgrades

The railway subgrades in the sandy areas act as an obstacle interfering wind-blown sand,causing sand erosion and sedimentation,which can disrupt the safe and stable operation of the railway system.Most previous studies mainly focus on the flow field around railway subgrades,however,the real erosion and sedimentation patterns are rarely studied.This study aims to analyze the erosion and sand sedimentation patterns of wind-blown sand over the subgrades with different heights and steel rails using the ratio of the wall shear stress to the critical value of erosion shear stress.Results show that wind erosion near the top of the upwind slope of the embankment and the shoulder on the upwind side are more severe,and the severity increases with an increase in the height of the embankment.With the increase of wind velocity,sand sedimentation both on the windward and leeside of the subgrade decreases and wind erosion by reverse flow occur.This study indicates that railways in sandy areas should be constructed with a moderate subgrade height(4 m).

Numerical simulation of vibrational response characteristics of railway subgrades with insulation boards

This study presents a numerical method based on the surface temperature data and the ground temperature increase in Daqing for predicting temperature field distribution in the Binzhou Railway subgrade and analyzing the temporal and spatial distribution of freeze−thaw status of railway subgrade.The calibrated numerical method is applied to simulate the temperature field distribution and roadbed vibrational response of the railway subgrade with a thermal insulation layer at different seasons.The results show the following:(1)The thermal insulation layer can remarkably increase the soil temperature below it and maximum frost depth in the subgrade.(2)Thermal insulation can effectively reduce the subgrade vibration and protect it from frost damage.(3)Given that the strength requirements are met,the insulation layer should be buried as shallow as possible to effectively reduce the subgrade vibration response.The research findings provide theoretical support for the frost damage prevention of railway subgrades in seasonally frozen regions.

Summary of research on frost heave for subgrade in seasonal frozen ground

The building of railways on seasonally frozen ground is inevitable as China pursues economic development and the improvement of its citizens'living standards.However,railway construction in seasonally frozen soil areas is often faced with frost heave,leading to uneven subgrades which seriously threaten traffic safety.This article summarizes extant research results on frost heave mechanism,frost heave factors,and anti-frost measures of railway subgrades in seasonally frozen soil areas.

Application of automated cone penetrometer for railway investigation using correlations with DCPI and deflection modulus

Portable in-situ devices have been used for characterizing low accessible field,such as the railway subgrade.In this study,the automated cone penetrometer(ACP)was designed for the application on the railway subgrade.ACP is composed of the cone tip,driving rod,and hydraulic hammer system.The hydraulic motor lifts and drops the 294.3 N hammer from a height of 200 mm such that the potential energy of 58.9 N m impacts the driving rod.The N-value(NACP)from the ACP test was compared with the dynamic cone penetration index(DCPI)from the dynamic cone penetrometer(DCP)test.The test results show that the NACP and DCPI profiles show opposite trend owing to the inverse concept of the unit.From the correlation of DCPI and NACP,the limitation of DCPI reveals owing the minimum manually measured value of 1 mm/blow.Additionally,the evaluation of the deflection modulus(EFWD)using NACP is more efficient than that using DCPI.Based on the result of this study,we suggest that ACP can be used for strength and stiffness evaluation of railway subgrade rapidly and reliably.

Dynamic behaviour of weathered red mudstone in Sichuan(China)under triaxial cyclic loading

The construction of a high-speed railway(HSR) in Southwest China is being hindered by a severe shortage of high-quality subgrade materials. However, red mudstone is widely distributed in the Sichuan Basin of China. The ability to use weathered red mudstone(WRM) to fill subgrade beds by controlling its critical stress and cumulative strain would enable substantial savings in project investments and mitigate damage to the ecological environment. To better understand the dynamic behaviour of WRM, both monotonic and cyclic triaxial tests were performed. The evolution of the cumulative strain vs. increased loading cycles was measured. The influences of confining pressure and loading cycles on the dynamic modulus, damping ratio, critical cyclic stress ratio(CSR), and dynamic stress level(DSL) were investigated. The relationship between the CSR and loading cycles under different failure strain criteria(0.1%-1.0%) was analysed. The prediction model of cumulative strain was also evaluated. The results indicated that the shear strength of WRM sufficiently meets the static strength requirements of subgrade. The critical dynamic stress of WRM can thus satisfy the dynamic stress-bearing requirement of the HSR subgrade. The critical CSR decreases and displays a power function with increasing confining pressure. As the confining pressure increases, the DSL remains relatively stable, ranging between 0.153 and 0.163. Furthermore, the relationship between the dynamic strength and loading cycles required to cause failure was established. Finally, a newly developed model for determining cumulative strain was established. A prediction exercise showed that the model is in good agreement with the experimental data.

Experimental study on permanent deformation characteristics of coarse-grained soil under repeated dynamic loading

Practical assessment of subgrade settlement induced by train operation requires developing suitable models capable of describing permanent deformation characteristics of subgrade filling under repeated dynamic loading.In this paper,repeated load triaxial tests were performed on coarse-grained soil(CGS),and the axial permanent strain of CGS under different confining pressures and dynamic stress amplitudes was analysed.Permanent deformation behaviors of CGS were categorized based on the variation trend of permanent strain rate with accumulated permanent strain and the shakedown theory.A prediction model of permanent deformation considering stress state and number of load cycles was established,and the ranges of parameters for different types of dynamic behaviors were also divided.The results indicated that the variational trend of permanent strain rate with accumulated permanent strain can be used as a basis for classifying dynamic behaviors of CGS.The stress state(confining pressure and dynamic stress amplitude)has significant effects on the permanent strain rate.The accumulative characteristics of permanent deformation of CGS with the number of load cycles can be described by a power function,and the model parameters can reflect the influence of confining pressure and dynamic stress amplitude.The study’s results could help deepen understanding of the permanent deformation characteristics of CGS.