Experimental evaluation of thermolysis-driven gas emissions from LiPF6-carbonate electrolyte used in lithium-ion batteries

This paper performs an experimental evaluation of thermolysis-driven gases generated by the thermal decomposition of 1 M LiPF6+EC/DMC=1/1 v/v electrolytes at various decomposition temperatures,pyrolysis durations,and oxygen concentrations.Carried out in a home-built autoclave filled with pure helium,the experiment reveals that as the decomposition temperature increases,more types and larger quantities of gases will be released.Specifically,the experimental results demonstrate trends of logistic growth in the volume concentration of CO2,C2H6O,C2H4,CO,and C2H4O2 with the increase of decomposition temperature.With a prolonged pyrolysis duration,while volume concentrations of certain gases,such as CO2,C2H6O,C2H5F,and CO would increase,the concentration of C2H4O2 actually decreases.Moreover,concentrations of both C2H4 and C2H5F will first decrease and reach their minimum values at 1%v/v oxygen concentration,and then they would quickly climb back at higher oxygen concentrations,while the concentrations of C2H6 and C2H3F would decrease monotonically.It is envisioned that the detailed experimental results and findings on the gas generation pattern of 1 M LiPF6+EC/DMC=1/1 v/v electrolytes can facilitate the development of an early warning mechanism of thermal runaway based on gas sensing technology,which can be effectively applied to monitor the potential thermal failures of lithium-ion batteries with the same type of electrolyte and thus promote the thermal safety of battery packs in safety-critical applications.

单壁碳纳米管气体传感器在GIS局部放电检测中的应用(英文)

This paper describes a realizable fabrication method to manufacture chemical gas sensors by using singlewalled carbon nanotubes(SWCNTs).The sensors were tested for the monitoring of SF_6 decomposition gas produced by partial discharge(PD) in GIS tank.The results showed a superior sensitivity,favorable reliability and good reproducibility. For further clarifying the relativity between sensor response and partial discharge activity,the discharge in GIS tank was monitored simultaneously through conventional pulse current method and a SWCNTs gas sensor,and the measurement results were put together for comparative analysis in this paper.The sensor response showed a great dependence on partial discharge characteristics.The sensor response increased nearly linearly with limits when the energy of discharge was persistently accumulated.Partial discharge power had a great influence on the response rate and the time delay.With the increase of partial discharge power,the response rate augmented almost in proportion while the time delay gradually becomes shorter with limits.The results were quite favorable to assess the partial discharge intensity and duration to some extent.Compared with pulse current method,the sensor was predominant to detect partial discharge exposed to constantly high levels of noise.It was capable of detecting partial discharge which was too weak to be detected with pulse current method.However,the sensor response didn't show much dependency on the apparent discharge of partial discharge.

Estimation of the Type of Low Energy Discharge in GIS Adopting Characteristic Gas

In order to guarantee safe operations, low energy discharge within gas insulated switchgear （GIS） should be detected as soon as possible before they develop severely and cause final breakdown failures. This paper aims to present a GIS discharge diagnosis technique adopting gaseous decompositions. To reach this aim, needle-plate electrode and the sphere-plate electrode with metallic particles on the plate are designed to simulate two kinds of low energy discharge, namely, corona discharge and spark discharge, respectively. After sampling and analyzing the gases, different yields of gaseous by-products under different types of low energy discharge are obtained. Based on the decomposition mechanisms reported by previous researches and the experiment results, it can be concluded that S2OF10, SO2F2 , and SO2 can be used as the characteristic gas to identify low energy discharge; the increment of S2OF10 can indicate the occurrence of low energy discharges while the volume ratio between SO2F2 and SO2 can define the type of low energy discharge.