Satellited CoNiCrAlY–Al_(2)O_(3)feedstocks with 2wt%, 4wt%, and 6wt% oxide nanoparticles and pure CoNiCrAlY powder were deposited by the high-velocity oxy fuel process on an Inconel738 superalloy substrate. The oxida...Satellited CoNiCrAlY–Al_(2)O_(3)feedstocks with 2wt%, 4wt%, and 6wt% oxide nanoparticles and pure CoNiCrAlY powder were deposited by the high-velocity oxy fuel process on an Inconel738 superalloy substrate. The oxidation test was performed at 1050℃ for 5, 50, 100,150, 200, and 400 h. The microstructure and phase composition of powders and coatings were characterized by scanning electron microscopy and X-ray diffraction, respectively. The bonding strength of the coatings was also evaluated. The results proved that with the increase in the percentage of nanoparticles(from 2wt% to 6wt%), the amount of porosity(from 1vol% to 4.7vol%), unmelted particles, and roughness of the coatings(from 4.8 to 8.8 μm) increased, and the bonding strength decreased from 71 to 48 MPa. The thicknesses of the thermally grown oxide layer of pure and composite coatings(2wt%, 4wt%, and 6wt%) after 400 h oxidation were measured as 6.5, 5.5, 7.6, and 8.1 μm, respectively.The CoNiCrAlY–2wt% Al_(2)O_(3)coating showed the highest oxidation resistance due to the diffusion barrier effect of well-dispersed nanoparticles. The CoNiCrAlY–6wt% Al_(2)O_(3)coating had the lowest oxidation resistance due to its rough surface morphology and porous microstructure.展开更多
Fine powders of γ-Fe_2O_3,doped with Y_2O_3,CeO_2,Eu_2O_3 or Tb_2O_3 have been prepared by the chemical co-precipitation method.The sensitivity of gas sensation has been measured with respect to the relative resist- ...Fine powders of γ-Fe_2O_3,doped with Y_2O_3,CeO_2,Eu_2O_3 or Tb_2O_3 have been prepared by the chemical co-precipitation method.The sensitivity of gas sensation has been measured with respect to the relative resist- ance change in the ceramic matrix upon introduction of inflammable gases.The structure of the materials has been studied with X-ray diffraction spectroscopy(XRD),electron diffraction spectroscopy( ED) and transmis- sion electron microscopy(TEM).The addition of rare earth oxides,which improves ceramic microstructure of γ-Fe_2O_3,improves gas sensitivity of γ-Fe_2O_3.The stability can be increased because of the increase of phase transition temperature.In addition,the selectivity of gas sensation of γ-Fe_2O_3 can be improved because of the variation of rare earth oxides.展开更多
α-Fe_2O_3 nanocrystal was encapsulated by a block-copolymer, hydroxylated poly (styrene-b- butadiene-styrene) (HO-SBS) to fabricate composite microspheres with α-Fe_2O_3 cores and HOSBS shell. Its film fabricated o...α-Fe_2O_3 nanocrystal was encapsulated by a block-copolymer, hydroxylated poly (styrene-b- butadiene-styrene) (HO-SBS) to fabricate composite microspheres with α-Fe_2O_3 cores and HOSBS shell. Its film fabricated on n-Si wafer acts as the insulator layer in the metal-insulator- semiconductor(MIS) structure. The capacitance-voltage (C-V) properties were measured to characterize the composite particulate films.展开更多
A heat-resistant dispersion-strengthening nano-Al_2O_3/Cu composite with highstrength and high electric conductivity was fabricated in a multiplex medium. The internaloxidation product, microstructures and properties ...A heat-resistant dispersion-strengthening nano-Al_2O_3/Cu composite with highstrength and high electric conductivity was fabricated in a multiplex medium. The internaloxidation product, microstructures and properties of the composite, and the process flow weresystematically studied. It is confirmed that this new technique simplifies the process and improvesthe properties of the composite. X-ray analysis indicates that the alumina particles formed duringinternal oxidation consist of a large mount of gamma-Al_2O_3 and a certain amount of theta-Al_2O_3and alpha-Al_2O_3. TEM observation shows that the obtained gamma-Al_2O_3 nano-particles areuniformly distributed in the copper grains; their mean size and space between particles are 7 runand 30 nm, respectively. The main properties of the composite with 50 percent cold deformation areas follows: the electric conductivity is 51 MS/m (87 percent IACS), sigma_b = 628 MPa, and thehardness is HRB86. After annealing at 1273 K, all or most of the above properties remain, and themicrostructures are still dependent on elongated fiber-form grains.展开更多
文摘Satellited CoNiCrAlY–Al_(2)O_(3)feedstocks with 2wt%, 4wt%, and 6wt% oxide nanoparticles and pure CoNiCrAlY powder were deposited by the high-velocity oxy fuel process on an Inconel738 superalloy substrate. The oxidation test was performed at 1050℃ for 5, 50, 100,150, 200, and 400 h. The microstructure and phase composition of powders and coatings were characterized by scanning electron microscopy and X-ray diffraction, respectively. The bonding strength of the coatings was also evaluated. The results proved that with the increase in the percentage of nanoparticles(from 2wt% to 6wt%), the amount of porosity(from 1vol% to 4.7vol%), unmelted particles, and roughness of the coatings(from 4.8 to 8.8 μm) increased, and the bonding strength decreased from 71 to 48 MPa. The thicknesses of the thermally grown oxide layer of pure and composite coatings(2wt%, 4wt%, and 6wt%) after 400 h oxidation were measured as 6.5, 5.5, 7.6, and 8.1 μm, respectively.The CoNiCrAlY–2wt% Al_(2)O_(3)coating showed the highest oxidation resistance due to the diffusion barrier effect of well-dispersed nanoparticles. The CoNiCrAlY–6wt% Al_(2)O_(3)coating had the lowest oxidation resistance due to its rough surface morphology and porous microstructure.
基金The project supported by the National Natural Science Foundation of China
文摘Fine powders of γ-Fe_2O_3,doped with Y_2O_3,CeO_2,Eu_2O_3 or Tb_2O_3 have been prepared by the chemical co-precipitation method.The sensitivity of gas sensation has been measured with respect to the relative resist- ance change in the ceramic matrix upon introduction of inflammable gases.The structure of the materials has been studied with X-ray diffraction spectroscopy(XRD),electron diffraction spectroscopy( ED) and transmis- sion electron microscopy(TEM).The addition of rare earth oxides,which improves ceramic microstructure of γ-Fe_2O_3,improves gas sensitivity of γ-Fe_2O_3.The stability can be increased because of the increase of phase transition temperature.In addition,the selectivity of gas sensation of γ-Fe_2O_3 can be improved because of the variation of rare earth oxides.
基金the National Natural Science Foundation of China
文摘α-Fe_2O_3 nanocrystal was encapsulated by a block-copolymer, hydroxylated poly (styrene-b- butadiene-styrene) (HO-SBS) to fabricate composite microspheres with α-Fe_2O_3 cores and HOSBS shell. Its film fabricated on n-Si wafer acts as the insulator layer in the metal-insulator- semiconductor(MIS) structure. The capacitance-voltage (C-V) properties were measured to characterize the composite particulate films.
文摘A heat-resistant dispersion-strengthening nano-Al_2O_3/Cu composite with highstrength and high electric conductivity was fabricated in a multiplex medium. The internaloxidation product, microstructures and properties of the composite, and the process flow weresystematically studied. It is confirmed that this new technique simplifies the process and improvesthe properties of the composite. X-ray analysis indicates that the alumina particles formed duringinternal oxidation consist of a large mount of gamma-Al_2O_3 and a certain amount of theta-Al_2O_3and alpha-Al_2O_3. TEM observation shows that the obtained gamma-Al_2O_3 nano-particles areuniformly distributed in the copper grains; their mean size and space between particles are 7 runand 30 nm, respectively. The main properties of the composite with 50 percent cold deformation areas follows: the electric conductivity is 51 MS/m (87 percent IACS), sigma_b = 628 MPa, and thehardness is HRB86. After annealing at 1273 K, all or most of the above properties remain, and themicrostructures are still dependent on elongated fiber-form grains.
