Similarity model tests of movement and deformation of coal-rock mass below stopes

For a study of the movement and deformation of coal-rock mass and low protected seams below a stope,as well as for fracture developments and rules of evolution of permeability,we designed a plane strain model test stand to carry out model tests of similar materials in order to improve the effect of gas drainage from low protected seams and to measure the movement and deformation of coal-rock mass using a method of non-contact close-range photogrammetry.Our results show that 1) using paraffin melting to take the place of coal seam mining can satisfy the mining conditions of a protective seam;2) coal-rock mass under goafs has an upward movement after the protective seam has been mined,causing floor heaving;3) low protected seams become swollen and deformed,providing a good pressure-relief effect and causing the coal-rock mass under both sides of coal pillars to become deformed by compression and 4) the evolution of permeability of low protected seams follows the way of initial values→a slight decrease→a great increase→stability→final decrease.Simultaneously,the coefficient of air permeability increased at a decreasing rate with an increase in interlayer spacing.

Experimental Study on Anchoring Physical Properties of Different Anchoring Lengths Coupled with Temperature and Pressure

Aiming at deep roadway anchorage solids, laboratory similar model tests were used to reveal the mechanical properties of anchorage solids with different anchorage lengths under the coupling effect of temperature and pressure, and SPSS statistical analysis software was used to conduct linear regression analysis of the ultimate anchorage force obtained from the tests. The results show that: through multiple linear regression analysis, the influence degree of temperature and pressure coupling on the ultimate anchorage force is arranged in order of anchoring length > surrounding rock strength > temperature > side pressure coefficient, and the linear regression equation of the model is obtained. Compared with the linear regression equation of simulation results, the model has a high explanatory ability.

Active video games in fully immersive virtual reality elicit moderate-to-vigorous physical activity and improve cognitive performance in sedentary college students

Background:Active video games are a new method for increasing physical activity(PA).Fully immersive virtual reality(VR)is a hardware device on which an active video game can run.Active(video games in)VR(AVR),might increase immersion,game engagement,and moderate-to-vigorous PA(MVPA),thereby yielding greater exercise-related benefits,e.g.,cognitive performance.Methods:We examined the induction of MVPA via an AVR and a sedentary VR(SVR)as well as the effects of VR play on cognitive performance,which was monitored using 2 different methods.Each of 29 sedentary college students attended three 20-min laboratory sessions(AVR,SVR,or control)in a randomized order;during the control session,they sat quietly doing nothing.A fully immersive headset was used for the 2 video game sessions.We monitored and computed participants’PA using hip-wom accelerometers(wGT3 x-bt;ActiGraph,Pensacola,FL,USA)and a heart rate band(Polar H7;Polar,Kempele,Finland).After each session,the participants completed a mnemonic similarity test(MST)to measure recognition memory.They also filled out a motion sickness questionnaire and an abbreviated game experience questionnaire.Results:The AVR session induced a significantly greater heart rate and more time spent in MVPA than did either of the other 2 sessions regardless of the PA monitoring method.AVR elicited greater game experience questionnaire-assessed sensory and imaginative immersion,challenge,and positive affect than did SVR.The mnemonic similarity test recognition score was marginally higher post-AVR session than it was post-SVR session.Conclusion:AVR elicited MVPA without a significant increase in motion sickness and induced a better game experience and better borderline cognitive performance than did SVR.

Similar simulation study on the deformation and failure of surrounding rock of a large section chamber group under dynamic loading

Large and super-large section chamber groups in coal mines are frequently affected by dynamic loads resulting from production activities such as roadway driving and blasting.The stability of the surrounding rock is poor,and it is difficult to control.In this paper,a similar simulation test was used to study the deformation and evolution laws of the surrounding rock of a triangle-shaped chamber group under different dynamic loads.The results showed that under dynamic loading,the vertical stress of the surrounding rock of the chamber group increased in an oscillatory form.The maximum stress concentration coefficient reached 4.09.The damage degree of the roof was greater than that of the two sides.The deformation of the roof was approximately 1.2 times that of the two sides.For the chamber closer to the power source,the stress oscillation amplitude of the surrounding rock was larger,and the failure was more serious.The force of the anchorage structure showed a phased increasing characteristic;additionally,the force of the anchorage structure on the adjacent side of the chambers was greater than that on the other side.This study reveals the deformation and failure evolution laws of the surrounding rock of large section chamber groups under dynamic loading.

Experimental research on coal seam similar material proportion and its application

In this paper, the optimization design of the low strength mechanical test and orthogonal test have been analyzed in order to simulate the mechanical properties of thick and extra-thick coal seam accurately in a similar material simulation test. The results show that the specimen can reach a wider range of strength when cement has been used compared to that of gypsum, suggesting that cement is more suitable for making coal seam in similar material simulation tests. The uniaxial compressive strength is more sensitive to cement than coal or sand. The proportion of coal and sand do not play a decisive role in uniaxial compressive strength. The uniaxial compressive strength and specimen density decrease as the mass percent of coal and aggregate–binder ratio rise. There is a positive correlation between uniaxial compressive strength and density. The No. 5 proportion(cement: sand: water: activated carbon: coal = 6:6:7:1.1:79.9)was chosen to be used in the similar material simulation test of steeply dipping and extra-thick coal seam with a density of 0.913 g/cm^3 and an uniaxial compressive strength of 0.076 MPa which are in accordance with the similarity theory. The phenomenon of overburden stratum movement, fracture development and floor pressure relief were obtained during the similar material simulation test by using the proportion.

Influence of dynamic pressure on deep underground soft rock roadway support and its application

Due to high ground stress and mining disturbance, the deformation and failure of deep soft rock roadway is serious, and invalidation of the anchor net-anchor cable supporting structure occurs. The failure characteristics of roadways revealed with the help of the ground pressure monitoring. Theoretical analysis was adopted to analyze the influence of mining disturbance on stress distribution in surrounding rock,and the change of stress was also calculated. Considering the change of stress in surrounding rock of bottom extraction roadway, the displacement, plastic zone and distribution law of principal stress difference under different support schemes were studied by means of FLAC3D. The supporting scheme of U-shaped steel was proposed for bottom extraction roadway that underwent mining disturbance. We carried out a similarity model test to verify the effect of support in dynamic pressure. Monitoring results demonstrated the change rules of deformation and stress of surrounding rock in different supporting schemes. The supporting scheme of U-shaped steel had an effective control on deformation of surrounding rock. The scheme was successfully applied in underground engineering practice, and achieved good technical and economic benefits.