Influences of fillet radius and draft angle on local loading process of titanium alloy T-shaped components

In order to study influences of geometric parameters on the T-shaped components local loading process, a new mathematical model considering the fillet radius and draft angle was established by using the slab method. The results obtained by the mathematical model agree with the data form experiment and numerical simulation, and the results are closer to the experimental and simulation results. The influence of draft angle may be neglected under the forming conditions used. The influence of fillet radius is notable, especially in the case that the ratio of fillet radius to rib width is less than 0.75.

ANALYSIS OF MECHANICS IN BALL SPINNING OF THIN-WALLED TUBE

Ball spinning is applied to manufacturing thin-walled tube with high precision and high mechanical properties. On the basis of plastic mechanics, by simplifying ball spinning of thin-walled tube as plane strain problem, slab method is used for the purpose of calculating the contact deformation pressure. The spinning force components, the torsional moment, the deformation power and the deformation work are calculated further as well. The influence of the two important process parameters such as the feed ratio and the ball diameter on the spinning force components is analyzed in order to further control the spinning force components by regulating the two process variables during the ball spinning process. The stress and strain state in deformable zone as well as mechanics boundary conditions in ball spinning are obtained. The effect of the three spinning force components on the formability of the spun part is analyzed and validated through the ball spinning experiments. The theoretical and experimental results show that the radial spinning component plays a significant role in ball spinning of thin-walled tube, and the mechanics situation in backward ball spinning contributes to enhancing the plasticity of the metal material, but that in forward ball spinning contributes to advancing the axial flow of the metal material.

Analysis of Rolling Pressure in Asymmetrical Rolling Process by Slab Method

The plane strain asymmetrical rolling was analyzed using slab method. The contact arc was replaced by parabola, and the constant surface friction status was adopted during the analysis. The deformation area was divided into three zones according to the direction of the friction. Then, the three zones were studied, respectively. A rolling force model and a rolling torque model were developed based on the analysis, and they were used to analyze the influ- ence of asymmetrical rolling factors on deformation area and unit pressure if they had good precision which was determined by comparing the calculated results with the measured ones.

Slab Analysis of Large Cylindrical Shell Rolling

Considering the characteristics of large cylindrical shell rolling, such as double driving rolls, asymmetrical rolling and huge workpiece, a slab method was developed to establish the rolling force model. In this model, the non- uniform normal and shear stresses and the upper and lower surface temperatures of the workpiece were taken into ac- count. Moreover, the flow stress model, considering the dynamic recovery and dynamic recrystallization behaviors of the material, was established. The rolling pressure distribution, the rolling force, the rolling torque and the neutral points could be calculated quickly and easily by the roiling force model. The predicted results were shown to be in good agreement with the measured values, which indicated that the model can satisfy the requirement of industrial application.