Sonocatalytic activity of LuFeO_3 crystallites synthesized via a hydrothermal route

LuFeO3 crystallites of different sizes and morphologies were synthesized via a hydrothermal route. The sonocatalytic properties of the as-synthesized samples were investigated by degrading various organic dyes, including acid orange 7 （AOT）, rhodamine B （RhB）, methyl orange （MO）, and methylene blue （MB）, under ultrasonic irradiation, revealing that they exhibit excellent sonocatalytic activity toward the degradation of these dyes. Particularly, the synthesized bar-like particles with lengths of-3 μm and widths of-1μm have the highest sonocatalytic activity, and the degradation percentage of AO7 reaches 89% after 30 min of sonocatalysis. The effects of inorganic anions such as CI-, NO3-, SO42-, PO43-, and HCO3- on the sonocatalysis efficiency were investigated. Hydroxyl radicals （·OH） detected by fiuorimetry using terephthalic acid as a probe molecule were found to be produced over the ultrasonic-irradiated LuFeO3 particles. The addition of ethanol, which acts as a· OH scavenger, leads to quenching of ＂OH radicals and a simultaneous decrease in the dye degrada- tion. This suggests that ＂OH is the dominant active species responsible for the dye degradation.

Sonocatalytic degradation of methyl orange in the presence of (nanometer and ordinary) anatase TiO_2 powders

The nanometer and ordinary anatase titanium dioxide(TiO_2) powders were adopted as the sonocatalysts for the degradation of methyl orange used as a model compound for the first time. It was found that the sonocatalytic degradation effect of methyl orange in the presence of TiO_2 powder were much better than that without TiO_2, but the sonocatalytic activity of the nanometer anatase TiO_2 particle was obviously higher than that of ordinary anatase TiO_2 particle. Although there are many factors influencing sonocatalytic degradation of methyl orange, the experimental results showed that the best degradation ratio of methyl orange could be obtained when the experimental conditions were: initial concentration 15 mg/L, nanometer anatase TiO_2 adding amount 750 mg/L, ultrasonic frequency 40 kHz, output power 50 W, pH = 3.0 and temperature 40℃ within 150 min. In addition, the catalytic activity of reused nanometer anatase TiO_2 catalyst was also studied and found to decline gradually comparing with initial nanometer anatase TiO_2 catalyst. All experiments indicated that the method of the sonocatalytic degradation of organic pollutants in the presence of TiO_2 powder was an advisable choice for non- or low-transparent organic wastewaters.

Sonocatalytic Damage of Bovine Serum Albumin (BSA) in the Presence of Nanometer Titanium Dioxide (TiO_2) Catalyst

The sonocatalytic damage of bovine serum albumin （BSA） was studied in the presence of nanometer titanium dioxide （TiO2） powders by low frequency （80 kHz） ultrasound. The destruction of secondary structure and change of α-helical structure of BSA were reflected by ultraviolet （UV） and circular dichroism （CD） spectroscopies.

Investigation on the Catalytic Behavior of Fe Loaded on Encapsulated Titanium for Sonocatalytic Degradation of Amaranth: Characterization and Reusability Study

The present study addressed the properties affecting the activity of a new heterogeneous catalyst Fe/Ti-NaY in the ultrasonic irradiated for decolorization of amaranth dye in aqueous solution. The catalyst was prepared by the ion exchange and impregnation method. Different characterization techniques, i.e. XRD, AFM, TEM and SEM/EDAX were done to characterize the properties of the fresh and used catalyst. This catalyst was able to keep its stability and high activity without any noticeable reduction in the decolorization efficiency of amaranth after three cycles of reaction. The X-ray diffraction proved the high stability and the crystallinity for the reuse catalyst. The COD removal for the fresh and used catalyst with and without calcination was 57%, 36% and 20% respectively. The hydrophilic properties of the heterogeneous catalyst increased slightly due to the loading of Ti and Fe ions.

超声辅助法合成的石墨烯-TiO_2复合材料声催化降解罗丹明B(英文)

A series of graphene-TiO2 composites was fabricated from graphene oxide and titanium n-butoxide(TNB) by an ultrasonic-assisted method.The structure and composition of the nanocomposites were characterized by Raman spectroscopy,BET surface area measurements,X-ray diffraction,transmission electron microscopy,and ultraviolet-visible absorption spectroscopy.The average size of the TiO2 nanoparticles on the graphene nanosheets was controlled at around 10-15 nm without using surfactant,which is attributed to the pyrolysis and condensation of dissolved TNB into TiO2 by ultrasonic irradiation.The catalytic activity of the composites under ultrasonic irradiation was determined using a rhodamine B(RhB) solution.The graphene-TiO2 composites possessed a high specific surface area,which increased the decolorization rate for RhB solution.This is because the graphene and TiO2 nanoparticles in the composites interact strongly,which enhances the photoelectric conversion of TiO2 by reducing the recombination of photogenerated electron-hole pairs.