High-Sensitivity Acquisition of Ultrahigh Dynamic Direct Sequence Spread Spectrum Signals in Space Communications

According to the requirements of the high-sensitivity acquisition of Direct Sequence Spread Spectrum(DSSS) signals under ultrahigh dynamic environments in space communications, a three-dimensional joint search of the phase of Pseudo-Noise-code(PN-code),Doppler frequency and its rate-of-change is presented to achieve high sensitivity in sensing high-frequency dynamics. By eliminating the correlation peak loss caused by ultrahigh Doppler frequency and its rate-of-change offset,the proposed method improves the acquisition sensitivity by increasing the non-coherent accumulation time. The validity of the algorithm is proved by theoretical analysis and simulation results. It is shown that signals with a carrier- to-noise ratio as low as 39 dBHz can be captured with high performance when the Doppler frequency is up to ±1 MHz and its rate-of-change is up to ±200 kHz/s.

Non-Supervised Learning for Spread Spectrum Signal Pseudo-Noise Sequence Acquisition

An idea of estimating the direct sequence spread spectrum（DSSS） signal pseudo-noise（PN） sequence is presented. Without the apriority knowledge about the DSSS signal in the non-cooperation condition, we propose a self-organizing feature map（SOFM） neural network algorithm to detect and identify the PN sequence. A non-supervised learning algorithm is proposed according the Kohonen rule in SOFM. The blind algorithm can also estimate the PN sequence in a low signal-to-noise（SNR） and computer simulation demonstrates that the algorithm is effective. Compared with the traditional correlation algorithm based on slip-correlation, the proposed algorithm＇s bit error rate（BER） and complexity are lower.

Bayesian decision-based pattern recognition on spectrum signal of metal transfer modes

A software system of pattern recognition on spectrum signal of metal transfer mode has been developed using Visual Basic under Windows environment. On the basis of the coincidence relation between the spectrum signal and metal transfer mode, according to the geometrical pattern feature of the spectrum signal, several key characteristic parameters are extracted. The correspondent recognition function and a minimum distance classifier have been constructed based on Bayesian decision theory. The results show that using this system, the metal transfer mode of MIG, MAG, CO2 welding can be recognized automatically which provides the basis for automatically controlling of the metal gas arc welding metal transfer.

SENSORING DROPLET SPRAY TRANSFER IN MIG WELDING BASED ON ARC SPECTRUM SIGNAL

The method to detect droplet transfer by means of arc spectrum, while the experiment sets, testing principle and data processing procedure,are presented. The experiment and analysis results show that arc spectrum signal can be utilized to detect and measure the transfer procedure, the transfer modes and the transfer parameters. The arc spectrum signal enjoys excellent quality with high signal amplitude. Each transfer mode has its specific typical signal mode, and the pulse outline corresponds to an integrated transferring procedure of one droplet. All these features of arc spectrum signal can be easily applied hi the control of transfer procedure,the identification and stabilization of transfer mode and the measurement of transfer parameters.

Signal-purity-spectrum-based colored deconvolution

Signal to noise ratio （SNR） and resolution are two important but contradictory characteristics used to evaluate the quality of seismic data. For relatively preserving SNR while enhancing resolution, the signal purity spectrum is introduced, estimated, and used to define the desired output amplitude spectrum after deconvolution. Since a real reflectivity series is blue rather than white, the effects of white reflectivity hypothesis on wavelets are experimentally analyzed and color compensation is applied after spectrum whitening. Experiments on real seismic data indicate that the cascade of the two processing stages can improve the ability of seismic data to delineate the geological details.

一种基于Spectrum原子的雷达辐射源信号识别方法

为了提高雷达辐射源信号的正确识别率以满足现代电子对抗的需求,该文提出了一种新的雷达辐射源信号识别方法。在过完备多尺度Spectrum原子库基础上,采用匹配追踪(MP)方法对信号进行原子分解,并通过FFT降低MP搜索过程的时间复杂性,在此基础上,对本征Spectrum原子参数进行有效降维,提取具有分类意义的原子特征向量,同步实现信号的自动分类和参数估计。实验结果表明,该方法在低信噪比环境下不仅可以获得高的信号类别正确识别率,同时具有准确的参数估计结果,证实了所提出方法的有效性。

A Neural Network Approach to Blind Estimation of PN Spreading Sequence in DS/SS Signals

In this paper, a new approach is proposed to estimate pseudo noise(PN) sequence in the lower SNR DS/SS signals blindly. This method utilizes the characteristics of self-organization, principal components analysis and extraction of unsupervised neural networks adequately, in addition to its higher-speed operation ability, successfully solve the difficult problem about PN sequence blind estimation. The theoretic analysis and experimental results show that this approach can work very well on lower SNR input signals.

Approach to blind estimation of the PN sequence in DS-SS signals with residual carrier

This paper presents an approach of singular value de- composition plus digital phase lock loop to solve the difficult problem of blind pseudo-noise （PN） sequence estimation in low signal to noise ratios （SNR） direct sequence spread spectrum （DS-SS） signals with residual carrier. This approach needs some given parameters, such as the period and code rate of PN sequence. The received signal is firstly sampled and divided into non-overlapping signal vectors according to a temporal window, whose duration is two periods of PN sequence. An autocorrelation matrix is then computed and accumulated by those signal vectors one by one. The PN sequence with residual carrier can be estimated by the principal eigenvector of the autocorrelation matrix. Further more, a digital phase lock loop is used to process the estimated PN sequence, it estimates and tracks the residual carrier and removes the residual carrier in the end. Theory analysis and computer simulation results show that this approach can effectively realize the PN sequence blind estimation from the input DS-SS signals with residual carrier in lower SNR.

Fast method for spreading sequence estimation of DSSS signal based on maximum likelihood function

To estimate the spreading sequence of the direct sequence spread spectrum (DSSS) signal, a fast algorithm based on maximum likelihood function is proposed, and the theoretical derivation of the algorithm is provided. By simplifying the objective function of maximum likelihood estimation, the algorithm can realize sequence synchronization and sequence estimation via adaptive iteration and sliding window. Since it avoids the correlation matrix computation, the algorithm significantly reduces the storage requirement and the computation complexity. Simulations show that it is a fast convergent algorithm, and can perform well in low signal to noise ratio (SNR).

Neural network approach to blindestimation of PN spreading sequence in lower SNR DS/SS signals

An approach based on discrete Karhunen-Loeve transformation of the DS/SS signals is proposed to estimate PN sequence in lower S/N ratio DS/SS signals. Characteristics of self-organization and principle components extraction of unsupervised neural networks are exploited adequately. Theoretical analysis and experimental results are provided to show that this approach can work well on the lower S/N ratio input signals.

A new approach to detecting weak signal in strong noise based on chaos system control

In this paper, a chaos system and proportional differential control are both used to detect the frequency of an unknown signal. In traditional methods the useful signal is obtained through the Duffing equation or other chaotic oscillators. But these methods are too complex because of using a lot of chaos oscillators. In this paper a new method is presented that uses the Rossler equation and proportional differential control to detect a weak signal frequency. Substituting the detected signal frequency into the RSssler equation leads the Rossler phase state to be considerably changed. The chaos state can be controlled through the proportional differential method. Through its phase diagram and spectrum analysis, the unknown frequency is obtained. The simulation results verify that the presented method is feasible and that the detection accuracy is higher than those of other methods.

Radar Signal Recognition by CWD Picture Features

In this paper a system for automatic recognition of radar waveform is introduced. This technique is used in many spectrum management, surveillance, and cognitive radio and radar applications. For instance the transmitted radar signal is coded into six codes based on pulse compression waveform such as linear frequency modulation (LFM), Frank code, P1, P2, P3 and P4 codes, the latter four are poly phase codes. The classification system is based on drawing Choi Willliams Distribution (CWD) picture and extracting features from it. In this study, various new types of features are extracted from CWD picture and then a pattern recognition method is used to recognize the spectrum. In fact, signals from CWD picture are defined using biometric techniques. We also employ false reject rate (FRR) and false accept rate (FAR) which are two types of fault measurement criteria that are deploy in biometric papers. Fairly good results are obtained for recognition of Signal to Noise Ratio (-11 dB).

Signal characteristics of coal and rock dynamics with micro-seismic monitoring technique

In this study, differences of signal characteristics between mine shocks and coal and gas outbursts in coal mines were examined with the micro-seismic monitoring technique and time-frequency analysis. The duration of the mine shock is short while the coal and gas outburst lasts longer. The outburst consists of three stages： the pre-shock, secondary shock and main shock stage, respectively. The velocity amplitude of the mine shock is between 10 s and 10-3 m/s, which is higher than that of the outburst with the same energy level. In addition, in both cases, the correlation between the velocity amplitude and energy is positive while the correlation between the signal frequency band distribution and energy is negative. The signal frequency band of the high energy mine shock is distributed between 0 and 50 Hz, and the low energy mine shock is between 50 and 100 Hz. The fractal characteristics of mine shocks were studied based on a fractal theory. The box dimensions of high energy mine shocks are lower than the low energy ones, however, the box dimensions of outbursts are higher than that of mine shocks with the same energy level. The higher box dimensions indicate more dangerous dynamic events.

Short-time Lv transform and its application for non-linear FM signal detection

A new time-frequency transform, known as short-time Lv transform （STLVT）, is proposed by applying the inverse Lv distribution to process consecutive segments of long data sequence. Compared with other time-frequency representations, the STLVT is able to achieve better energy concentration in the time-frequency domain for signals containing multiple linear and/or non-linear frequency modulated components. The merits of the STLVT are demonstrated in terms of the effects of window length and overlap length between adjacent segments on signal energy concentration in the time-frequency domain, and the required computational complexity. An application on the spectrum sensing for cognitive ratio （CR） by using a joint use of the STLVT and Hough transform （HT） is proposed and simulated.

Highly sensitive detection of Rydberg atoms with fluorescence loss spectrum in cold atoms

Fluorescence loss spectrum for detecting cold Rydberg atoms with high sensitivity has been obtained based on lock-in detection of fluorescence of 6 P3/2 state when cooling lasers of the magneto-optical trap are modulated.The experiment results show that the signal to noise ratio has been improved by 32.64 dB when the modulation depth(converted to laser frequency)and frequency are optimized to 4 MHz and 6 kHz,respectively.This technique enables us to perform a highly sensitive non-destructive detection of Rydberg atoms.

SPATIAL SPECTRUM ESTIMATION OF COHERENT SOURCES IMPINGING ON NONUNIFORM ARRAYS

The problem of bearing estimation of coherent signal impingiog on an array ofarbitrary geometry is studied.Both approaches are developed,the first one synthesizes theobserved array data into the outputs of a linear uniform array and then processes them viaconventional techniques such as spatial smoothing etc.The second approach is based on theinvariant subspace rotation operation which is equivalent to the translational displacement ofthe artay,linearly independent signal vectors are obtained thereby to span perfectly the signalsubspace.As compared with the conventional processing techniques,the approach based oninvariant subspace rotation does not lead to an effective decrease in aperture size and thereforea decrease in resolution capability.The computer simulations are conducted to demonstrate theeffectiveness of the presented approaches.

WAVELET ANALYSIS IN TESTING SIGNALS

In this paper, Wavelet Analysis Method (WAM) is introduced to analyse the non-stationary, shock signals. The theory and construction method of wavelet, the fast algorithms of wavelet analysis are presented. As an example, the gear testing signal has been analysed by WAM, and the results of WAM are compared with that of Fourier spectrum. The advantages of WAM are clearly shown.

Research and Implementation of Text Similarity System Based on Power Spectrum Analysis

The paper proposed the research and implement of text similarity system based on power spectrum analysis. It is not difficult to imagine that the signals of brain are closely linked with writing process. So we build text modeling and set pulse signal function to get the power spectrum of the text. The specific detail is getting power spectrum from economic field to build spectral library, and then using the method of power spectrum matching algorithm to judge whether the test text belonged to the economic field. The method made text similarity system finish the function of text intelligent classification efficiently and accurately.

2-D SPATIAL-SPECTRUM ESTIMATION FORWIDE-BAND SOURCES BASED ON INTERPOLATED CIRCULAR ARRAYS

In array signal processing, 2-D spatial-spectrum estimation is required to determine DOA of multiple signals. The circular array of sensors is found to possess several nice properties for DOA estimation of wide-band sources. C. U. Padmini, et al.(1994) had suggested that the frequency-direction ambiguity in azimuth estimation of wide-baud signals received by a uniform linear array (ULA) can be avoided by using a circular array, even without the use of any delay elements. In 2-D spatial-spectrum estimation for wide-band signals, the authors find that it is impossible to avoid the ambiguity in source frequency-elevation angle pairs using a circular array. In this paper, interpolated circular arrays are used to perform 2-D spatial-spectrum estimation for wide-band sources. In the estimation, a large aperture circular array (Υ】λmin/2) is found to possess superior resolution capability and robustness.