NC code generation for laser assisted turn-mill of various type of clovers and square section members

Laser assisted turning （LAT） is one of the advanced machining technologies, which uses laser power to heat the surface of a workpiece before the material is removed. It has several advantages of low manufacturing costs, high productivity and high qualities to machine difficult-to-cut materials such as silicon nitride, muUite, zirconia and Ni. A large part of studies on LAT have been focused on a round bar. With increasing demands for high quality products and high performance engineering system, the researches on LAT for clover and square section members are necessary. But, these workpieces are impossible to be machined on conventional CNC lathe and to generate NC code with current CAM softwares. As a basic research for combining LAT with a tilting index table type 5-axis machining center, i.e. laser assisted turn-mill, a new method is suggested to generate NC code that can process various types of clover and square section members through development of C＋＋ program.

Plate reinforced square hollow section X-joints subjected to in-plane moment

The static test of 13 square hollow section(SHS) X-joints with different β and different types of plate reinforcement under in-plane moment in brace was carried out. Experimental test schemes, failure modes of specimens, moment-vertical displacement curves, moment-deformation of the chord, and strain strength distribution curves were presented. The effect of β and plate reinforcement types on in-plane flexural property of SHS X-joints was studied. Results show that punching shear of chord face disappears, brace material fracture appears and concave and convex deformation of chord decrease when either collar plates or doubler plates were welded on chord face. Moment-vertical displacement curves of all specimens have obvious elastic, elastic-plastic and plastic stages. As β increases, the in-plane flexural ultimate capacity and initial stiffness of joints of the same plate reinforcement type increase, but ductility of joints decreases. With the same β, the in-plane flexural initial stiffness and ultimate capacity of doubler plate reinforced joints, collar plate reinforced joints, and unreinforced joints decrease progressively. Thickness of reinforcement plate has no obvious effect on in-plane flexural initial stiffness and ultimate capacity of joints. As thickness of reinforcement plate increases, the ductility of reinforced X-joints decreases. The concave and convex deformation of every specimen has good symmetry;as β increases, the yield and ultimate deformation of chord decrease.

Promoting hybrid twins structure to reduce yield asymmetry of rolled AZ31 plates by combining side-rolling and torsion

In this work,an as-rolled AZ31 square bar with c-axis//ND(normal direction)texture was used.Side-rolling and reciprocating torsion were performed to treat the bar.Microstructure evolution and tensile-compressive properties were investigated in detail.Initial rolled AZ31 bar exhibits a large yield asymmetry along the rolling direction(RD).Reciprocating torsion can generate extension twins to introduce twin boundaries and twin-texture.The twin structure can reduce yield asymmetry.However,only limited regions in the rolled AZ31 bar can be twinned during torsion.Pre-side-rolling along the transverse direction(TD)can generate two texture components(c-axis//TD texture and c-axis//ND texture)by introducing profuse{10–12}twins.Such dual texture components help increase the regions which are favorable for twinning during torsion.Finally,combining side-rolling and reciprocating torsion generates hybrid{10–12}twins structure on the entire cross-section,resulting in a remarkably low yield asymmetry.The relevant mechanisms were discussed in detail.