In this paper, we analyze the effect of both deter- ministic and random perturbations of a regular multi-layered elastic structure on its stop band properties. The tool of choice is the transfer matrix method, which i...In this paper, we analyze the effect of both deter- ministic and random perturbations of a regular multi-layered elastic structure on its stop band properties. The tool of choice is the transfer matrix method, which is both versatile and easy to implement. In both cases, we find that the stop-bands widen. We observe the appearance of very narrow pass-bands within the stop-bands, which can be observed in other instances in optics.展开更多
We investigate the guiding modes of spoof surface plasmon polaritons （SPPs） on a symmetric ultra-thin plasmonic structure. From the analysis, we deduce the operating frequency region of the single-mode propagation. ...We investigate the guiding modes of spoof surface plasmon polaritons （SPPs） on a symmetric ultra-thin plasmonic structure. From the analysis, we deduce the operating frequency region of the single-mode propagation. Based on this property, a spoof SPPs lowpass filter is then constituted in the microwave frequency. By introducing a transmission zero at the lower frequency band using a pair of stepped-impedance stubs, a wide passband filter is further realized. The proposed filter is fed by.a transducer composed of a microstrip line with a flaring ground. The simulated results show that the presented filter has an extremely wide upper stopband in addition to excellent passband filtering characteristics such as low loss, wide band, and high square ratio. A prototype passband filter is also fabricated to validate the predicted performances. The proposed spoof-SPPs filter is believed to be very promising for other surface waveguide components in microwave and terahertz bands.展开更多
A TTF-type coaxial higher order modes （HOM） coupler has been used in a TESLA 9 cell cavity. It is impossible to measure the stop band characteristics of the HOM coupler with the cavity. A measurement device for the ...A TTF-type coaxial higher order modes （HOM） coupler has been used in a TESLA 9 cell cavity. It is impossible to measure the stop band characteristics of the HOM coupler with the cavity. A measurement device for the coaxial transmission line type for the HOM coupler has been designed at Peking University. Experimentally it was shown that the average voltage standing wave ratio of the coaxial transmission line is smaller than 1.08. The experimental results of the stop band characteristics of the TTF-type HOM coupler have been fitted for the simulation. This paper describes the design of the measurement device and discusses the experimental and simulation results of stop band characteristics of the HOM coupler.展开更多
A terahertz（THz） waveguide band-pass filter using an iris inductive window coupled structure was designed and fabricated.The filter was designed at0.22 THz with a pass band of 20 GHz.The measured results show that t...A terahertz（THz） waveguide band-pass filter using an iris inductive window coupled structure was designed and fabricated.The filter was designed at0.22 THz with a pass band of 20 GHz.The measured results show that the center frequency is 0.218 THz with a pass band of 0.205 THz to 0.231 THz,the minimum insertion loss is 1.26 d B at 0.224 THz,and the return loss is less than 13.1 d B.The stop-band suppression is65.6 d B at 0.193 THz and 51.8 d B at 0.243 THz,respectively,which means a good performance of high stop-band suppression.A good agreement exists between the measured S-parameters and the simulated ones,especially in the upper band.The proposed THz waveguide filter has potential applications in THz communications.展开更多
A new technique for the conversion of ladder based filter into CFOA based filter has been proposed. The technique uses signal flow graph and converts the existing LC ladder based filter into band pass & band stop ...A new technique for the conversion of ladder based filter into CFOA based filter has been proposed. The technique uses signal flow graph and converts the existing LC ladder based filter into band pass & band stop configurations. The design of band pass and band stop filter has been realized using the proposed technique. The proposed configuration is implemented using CFOA as an active device and all the capacitors are grounded. CFOA based circuits have greater linearity, high dynamic rate, high slew rate and high signal bandwidth. Simulation has been carried out using simulation software P Spice (v10.1). The simulation results have been demonstrated and discussed.展开更多
A rectangular waveguide band-stop filter using electromagnetic crystals (EMXT) surface as the top and bottom walls is presented in this letter. The EMXT surface has a band gap that can prevent electromagnetic wave fro...A rectangular waveguide band-stop filter using electromagnetic crystals (EMXT) surface as the top and bottom walls is presented in this letter. The EMXT surface has a band gap that can prevent electromagnetic wave from propagating along the waveguide. Dispersion properties of the waveguide filter are analyzed using an approximated lumped-element circuit model. A W-band prototype based on the proposed waveguide filter is designed and characterized. The experimental results show a rejection band centered at 97 GHz and a rejection level of 16 dB.展开更多
We present the acoustic band gaps （ABGs） for a geometry of three-dimensional complex acoustic crystals： the NaCl-type structure. By using the super cell method based on the plane-wave expansion method （PWE）, we s...We present the acoustic band gaps （ABGs） for a geometry of three-dimensional complex acoustic crystals： the NaCl-type structure. By using the super cell method based on the plane-wave expansion method （PWE）, we study the three configurations formed by water objects （either a sphere of different sizes or a cube） located at the vertices of simple cubic （SC） lattice and surrounded by mercury background. The numerical results show that ABGs larger than the original SC structure for all the three configurations can be obtained by adjusting the length-diameter ratio of adjacent objects but keeping the filling fraction （f = 0.25） of the unit cell unchanged. We also compare our results with that of 3D solid composites and find that the ABGs in liquid composites are insensitive to the shapes as that in the solid composites. We further prove that the decrease of the translation group symmetry is more efficient in creating the ABGs in 3D water-mercury systems.展开更多
The influences of the configurational disorders on phononic band gaps and on waveguide modes are investigated for the two-dimensional phononic crystals consisting of water cylinders periodically arrayed in mercury. Tw...The influences of the configurational disorders on phononic band gaps and on waveguide modes are investigated for the two-dimensional phononic crystals consisting of water cylinders periodically arrayed in mercury. Two types of configurational disorders, relevant to the cylinder position and cylinder size respectively, are taken into account. It is found that the phononic band gap and the guide band are sensitive to the disorders, and generally become narrower with the increasing disorders. It is also found that the waveguide side walls without disorder can significantly prevent the guide modes in the waveguide from influence by the disorders in the crystals to a large amount.展开更多
In this paper, an antenna with reconfigurable band notches, for cognitive radio applications, is proposed. The antenna can be operated as ultra wideband, and is reconfigurable in terms of the ability to select a notch...In this paper, an antenna with reconfigurable band notches, for cognitive radio applications, is proposed. The antenna can be operated as ultra wideband, and is reconfigurable in terms of the ability to select a notched band in the SRR resonant frequency. The reconfigurable band notches are induced using a band-stop filter based on split-ring resonators (SRRs), and are controlled using electronic switches mounted over the SRRs. For this sake, the design of the band-stop filter is proposed. A prototype of filter is fabricated and measured. The incorporation of a band-stop filter, into a wideband antenna, is then looked into. The proposed antenna is designed and simulated using Ansoft HFSS. A prototype of the antenna is fabricated and measured. A good analogy between simulated and measured results is obtained.展开更多
基金a Marie Curie Transfer of Knowledge Fellowship of the European Community's Sixth Framework Programme under contract number(MTKD-CT-2004-509809)
文摘In this paper, we analyze the effect of both deter- ministic and random perturbations of a regular multi-layered elastic structure on its stop band properties. The tool of choice is the transfer matrix method, which is both versatile and easy to implement. In both cases, we find that the stop-bands widen. We observe the appearance of very narrow pass-bands within the stop-bands, which can be observed in other instances in optics.
基金Project supported by the Key Grant Project of Ministry of Education of China(Grant No.313029)the FDCT Research Grant from Macao Science and Technology Development Fund,China(Grant No.051/2014/A1)the Multi-Year Research Grant from University of Macao,Macao SAR,China(Grant No.MYRG2014-00079-FST)
文摘We investigate the guiding modes of spoof surface plasmon polaritons （SPPs） on a symmetric ultra-thin plasmonic structure. From the analysis, we deduce the operating frequency region of the single-mode propagation. Based on this property, a spoof SPPs lowpass filter is then constituted in the microwave frequency. By introducing a transmission zero at the lower frequency band using a pair of stepped-impedance stubs, a wide passband filter is further realized. The proposed filter is fed by.a transducer composed of a microstrip line with a flaring ground. The simulated results show that the presented filter has an extremely wide upper stopband in addition to excellent passband filtering characteristics such as low loss, wide band, and high square ratio. A prototype passband filter is also fabricated to validate the predicted performances. The proposed spoof-SPPs filter is believed to be very promising for other surface waveguide components in microwave and terahertz bands.
基金National Natural Science Foundation of China (10276001)
文摘A TTF-type coaxial higher order modes （HOM） coupler has been used in a TESLA 9 cell cavity. It is impossible to measure the stop band characteristics of the HOM coupler with the cavity. A measurement device for the coaxial transmission line type for the HOM coupler has been designed at Peking University. Experimentally it was shown that the average voltage standing wave ratio of the coaxial transmission line is smaller than 1.08. The experimental results of the stop band characteristics of the TTF-type HOM coupler have been fitted for the simulation. This paper describes the design of the measurement device and discusses the experimental and simulation results of stop band characteristics of the HOM coupler.
文摘A terahertz（THz） waveguide band-pass filter using an iris inductive window coupled structure was designed and fabricated.The filter was designed at0.22 THz with a pass band of 20 GHz.The measured results show that the center frequency is 0.218 THz with a pass band of 0.205 THz to 0.231 THz,the minimum insertion loss is 1.26 d B at 0.224 THz,and the return loss is less than 13.1 d B.The stop-band suppression is65.6 d B at 0.193 THz and 51.8 d B at 0.243 THz,respectively,which means a good performance of high stop-band suppression.A good agreement exists between the measured S-parameters and the simulated ones,especially in the upper band.The proposed THz waveguide filter has potential applications in THz communications.
文摘A new technique for the conversion of ladder based filter into CFOA based filter has been proposed. The technique uses signal flow graph and converts the existing LC ladder based filter into band pass & band stop configurations. The design of band pass and band stop filter has been realized using the proposed technique. The proposed configuration is implemented using CFOA as an active device and all the capacitors are grounded. CFOA based circuits have greater linearity, high dynamic rate, high slew rate and high signal bandwidth. Simulation has been carried out using simulation software P Spice (v10.1). The simulation results have been demonstrated and discussed.
文摘A rectangular waveguide band-stop filter using electromagnetic crystals (EMXT) surface as the top and bottom walls is presented in this letter. The EMXT surface has a band gap that can prevent electromagnetic wave from propagating along the waveguide. Dispersion properties of the waveguide filter are analyzed using an approximated lumped-element circuit model. A W-band prototype based on the proposed waveguide filter is designed and characterized. The experimental results show a rejection band centered at 97 GHz and a rejection level of 16 dB.
基金Supported by the National Natural Science Foundation of China under Grant No 10674032, and the Natural Science Foundation of Guangdong Province under Grant Nos 032485 and 6021480.
文摘We present the acoustic band gaps （ABGs） for a geometry of three-dimensional complex acoustic crystals： the NaCl-type structure. By using the super cell method based on the plane-wave expansion method （PWE）, we study the three configurations formed by water objects （either a sphere of different sizes or a cube） located at the vertices of simple cubic （SC） lattice and surrounded by mercury background. The numerical results show that ABGs larger than the original SC structure for all the three configurations can be obtained by adjusting the length-diameter ratio of adjacent objects but keeping the filling fraction （f = 0.25） of the unit cell unchanged. We also compare our results with that of 3D solid composites and find that the ABGs in liquid composites are insensitive to the shapes as that in the solid composites. We further prove that the decrease of the translation group symmetry is more efficient in creating the ABGs in 3D water-mercury systems.
基金Supported by the National Natural Science Foundation of China under Grant Nos 50425206, 10418014 and 10174054, the Doctoral Research Foundation of the Ministry of Education of China under Grant No 20020486013, and the Natural Science Foundation of Hunan Province under Grant No 04JJ3079.
文摘The influences of the configurational disorders on phononic band gaps and on waveguide modes are investigated for the two-dimensional phononic crystals consisting of water cylinders periodically arrayed in mercury. Two types of configurational disorders, relevant to the cylinder position and cylinder size respectively, are taken into account. It is found that the phononic band gap and the guide band are sensitive to the disorders, and generally become narrower with the increasing disorders. It is also found that the waveguide side walls without disorder can significantly prevent the guide modes in the waveguide from influence by the disorders in the crystals to a large amount.
文摘In this paper, an antenna with reconfigurable band notches, for cognitive radio applications, is proposed. The antenna can be operated as ultra wideband, and is reconfigurable in terms of the ability to select a notched band in the SRR resonant frequency. The reconfigurable band notches are induced using a band-stop filter based on split-ring resonators (SRRs), and are controlled using electronic switches mounted over the SRRs. For this sake, the design of the band-stop filter is proposed. A prototype of filter is fabricated and measured. The incorporation of a band-stop filter, into a wideband antenna, is then looked into. The proposed antenna is designed and simulated using Ansoft HFSS. A prototype of the antenna is fabricated and measured. A good analogy between simulated and measured results is obtained.
