La(O,F)BiSe2 is a layered superconductor and has the same crystal structure with La(O,F)BiS2. We investigate the electronic structure of La(O,F)BiSe2 using the angle-resolved photoemission spectroscopy. Two elec...La(O,F)BiSe2 is a layered superconductor and has the same crystal structure with La(O,F)BiS2. We investigate the electronic structure of La(O,F)BiSe2 using the angle-resolved photoemission spectroscopy. Two electron-like Fermi surfaces around X(π, 0) are observed, corresponding to the electron doping of 0.23 per Bi site. We clearly resolve anisotropic band splitting along both Г-X and M-X due to the cooperative effects of large spin-orbit coupling and interlayer coupling. Moreover, we observe an almost non-dispersive electronic state around -0.2 eV between the electron-like bands. This state vanishes after in-situ K evaporation, indicating that it could be the localized surface state caused by defects on the cleaved surface.展开更多
The ground-state energy level (GEL) and electron distribution of GaAs pseudomorphic high-electron-mobility transistors (PHEMTs) are analyzed by a self-consistent solution to the Schrodinger-Poisson equations. The ...The ground-state energy level (GEL) and electron distribution of GaAs pseudomorphic high-electron-mobility transistors (PHEMTs) are analyzed by a self-consistent solution to the Schrodinger-Poisson equations. The indium composition and thickness of the InGaAs channel are optimized according to the GEL position. The GEL position is not in direct proportion to 1/d^2 (d is the channel thickness) by considering the influence of electron distribution in the InGaAs channel. Indium composition 0.22 and channel thickness 9 nm are obtained by considering the mismatch between InGaAs and AlGaAs. Several PHEMT samples are grown according to the theoretical results and mobility 6300 cm^2 /V.s is achieved.展开更多
To obtain the peak response at 532nm, narrow-band response GaA1As photocathodes with two GaAIAs ac- tive layers of different aluminum compositions are designed in consideration of the maximum absorptivity and quantum ...To obtain the peak response at 532nm, narrow-band response GaA1As photocathodes with two GaAIAs ac- tive layers of different aluminum compositions are designed in consideration of the maximum absorptivity and quantum efficiency. The transmission-mode and the corresponding reflective-mode photocathodes are grown by metalorganic chemical vapor deposition. The results indicate that the peak response and the cut-off wavelength occur at 532nm for the two kinds of photocathodes respectively. The response of the reflection-mode photoeath- ode is an order of magnitude higher than that of the transmission-mode photocathode, whereas the better growth quality and the thicker second GaAIAs active layer can improve the transmission-mode response.展开更多
The pressure-induced structural transitions of ZnTe are investigated at pressures up to 59.2 GPa in a diamond anvil cell by using synchrotron powder x-ray diffraction method. A phase transition from the initial zinc b...The pressure-induced structural transitions of ZnTe are investigated at pressures up to 59.2 GPa in a diamond anvil cell by using synchrotron powder x-ray diffraction method. A phase transition from the initial zinc blende (ZB, ZnTe-Ⅰ) structure to a cinnabar phase (ZnTe-Ⅱ) is observed at 9.6 GPa, followed by a high pressure orthorhombic phase (ZnTe-Ⅲ) with Cmcm symmetry at 12.1 GPa. The ZB, cinnabar (space group P3121), Cmcm, P31 and rock salt structures of ZnTe are investigated by using density functional theory calculations. Based on the experiments and calculations, the ZnTe-Ⅱ phase is determined to have a cinnabar structure rather than a P3 1 symmetry.展开更多
Research into the fundamental properties of microcapsules and use of the results to develop a wide variety of products in industries such as printing, fast-moving consumer goods, construction, pharmaceuticals, and agr...Research into the fundamental properties of microcapsules and use of the results to develop a wide variety of products in industries such as printing, fast-moving consumer goods, construction, pharmaceuticals, and agrochemicals is a dynamic and ever-progressing field of study. For microcapsules to be effective in providing protection from harsh environments or delivering large payloads, it is essential to have a good understanding of their properties to enable quality control during formulation, storage, and applications. This review aims to outline the commonly used techniques for determining the physicochemical, struc- tural, and mechanical properties of microcapsules, and highlights the interlinked nature of these three areas with respect to the end-use industrial application. This review provides information on techniques that are well supported in the literature, and also examines microcapsule analytical techniques that will become more prevalent as a result of new technological developments or extensions from other areas of study.展开更多
This paper presents a simple and useful modeling method to acquire a dynamics model of an aerial vehicle containing unknown parameters using mechanism modeling,and then to design different identifcation experiments to...This paper presents a simple and useful modeling method to acquire a dynamics model of an aerial vehicle containing unknown parameters using mechanism modeling,and then to design different identifcation experiments to identify the parameters based on the sources and features of its unknown parameters.Based on the mathematical model of the aerial vehicle acquired by modeling and identifcation,a design for the structural parameters of the attitude control system is carried out,and the results of the attitude control flaps are verifed by simulation experiments and flight tests of the aerial vehicle.Results of the mathematical simulation and flight tests show that the mathematical model acquired using parameter identifcation is comparatively accurate and of clear mechanics,and can be used as the reference and basis for the structural design.展开更多
基金Supported by the National Basic Research Program of China under Grant Nos 2015CB921300,2013CB921700 and 2016YFA0300404the National Natural Science Foundation of China under Grant Nos 11474340,11234014,U1532267 and 11674327the Chinese Academy of Sciences under Grant No XDB07000000
文摘La(O,F)BiSe2 is a layered superconductor and has the same crystal structure with La(O,F)BiS2. We investigate the electronic structure of La(O,F)BiSe2 using the angle-resolved photoemission spectroscopy. Two electron-like Fermi surfaces around X(π, 0) are observed, corresponding to the electron doping of 0.23 per Bi site. We clearly resolve anisotropic band splitting along both Г-X and M-X due to the cooperative effects of large spin-orbit coupling and interlayer coupling. Moreover, we observe an almost non-dispersive electronic state around -0.2 eV between the electron-like bands. This state vanishes after in-situ K evaporation, indicating that it could be the localized surface state caused by defects on the cleaved surface.
文摘The ground-state energy level (GEL) and electron distribution of GaAs pseudomorphic high-electron-mobility transistors (PHEMTs) are analyzed by a self-consistent solution to the Schrodinger-Poisson equations. The indium composition and thickness of the InGaAs channel are optimized according to the GEL position. The GEL position is not in direct proportion to 1/d^2 (d is the channel thickness) by considering the influence of electron distribution in the InGaAs channel. Indium composition 0.22 and channel thickness 9 nm are obtained by considering the mismatch between InGaAs and AlGaAs. Several PHEMT samples are grown according to the theoretical results and mobility 6300 cm^2 /V.s is achieved.
基金Supported by the National Natural Science Foundation of China under Grant Nos 61171042 and 61301023the Introducing Talent Scientific Initial Foundation of Nanjing Institute of Technology of China under Grant Nos YKJ201320,YKJ201322,and YKJ201323
文摘To obtain the peak response at 532nm, narrow-band response GaA1As photocathodes with two GaAIAs ac- tive layers of different aluminum compositions are designed in consideration of the maximum absorptivity and quantum efficiency. The transmission-mode and the corresponding reflective-mode photocathodes are grown by metalorganic chemical vapor deposition. The results indicate that the peak response and the cut-off wavelength occur at 532nm for the two kinds of photocathodes respectively. The response of the reflection-mode photoeath- ode is an order of magnitude higher than that of the transmission-mode photocathode, whereas the better growth quality and the thicker second GaAIAs active layer can improve the transmission-mode response.
基金Supported by the National Natural Science Foundation of China under Grant No 11474280the National Basic Research Program of China under Grant No 2011CB808200the Chinese Academy of Sciences under Grant Nos KJCX2-SW-N20 and KJCX2-SW-N03
文摘The pressure-induced structural transitions of ZnTe are investigated at pressures up to 59.2 GPa in a diamond anvil cell by using synchrotron powder x-ray diffraction method. A phase transition from the initial zinc blende (ZB, ZnTe-Ⅰ) structure to a cinnabar phase (ZnTe-Ⅱ) is observed at 9.6 GPa, followed by a high pressure orthorhombic phase (ZnTe-Ⅲ) with Cmcm symmetry at 12.1 GPa. The ZB, cinnabar (space group P3121), Cmcm, P31 and rock salt structures of ZnTe are investigated by using density functional theory calculations. Based on the experiments and calculations, the ZnTe-Ⅱ phase is determined to have a cinnabar structure rather than a P3 1 symmetry.
文摘Research into the fundamental properties of microcapsules and use of the results to develop a wide variety of products in industries such as printing, fast-moving consumer goods, construction, pharmaceuticals, and agrochemicals is a dynamic and ever-progressing field of study. For microcapsules to be effective in providing protection from harsh environments or delivering large payloads, it is essential to have a good understanding of their properties to enable quality control during formulation, storage, and applications. This review aims to outline the commonly used techniques for determining the physicochemical, struc- tural, and mechanical properties of microcapsules, and highlights the interlinked nature of these three areas with respect to the end-use industrial application. This review provides information on techniques that are well supported in the literature, and also examines microcapsule analytical techniques that will become more prevalent as a result of new technological developments or extensions from other areas of study.
基金supported by the National Natural Science Foundation of China(No.11102019)
文摘This paper presents a simple and useful modeling method to acquire a dynamics model of an aerial vehicle containing unknown parameters using mechanism modeling,and then to design different identifcation experiments to identify the parameters based on the sources and features of its unknown parameters.Based on the mathematical model of the aerial vehicle acquired by modeling and identifcation,a design for the structural parameters of the attitude control system is carried out,and the results of the attitude control flaps are verifed by simulation experiments and flight tests of the aerial vehicle.Results of the mathematical simulation and flight tests show that the mathematical model acquired using parameter identifcation is comparatively accurate and of clear mechanics,and can be used as the reference and basis for the structural design.