ANALYSIS OF THE EFFECT OF THE TRUNCATED SCAN PLANE IN TIME-DOMAIN NEAR-FIELD MEASUREMENTS

The thought and formulation for near-field far-field transformation based on the direct time-domain computation scheme are given. The effect of the truncated scan plane is investigated by simulating time-domain measurement of an open-ended waveguide antenna, and a simple and effective criterion is derived for removing the truncation errors in the practical time-domain near-field measurements.

Particle Velocity Sensor and Its Application in Near-Field Noise Scanning Measurement

The Particle Velocity Sensor (PVS) is a kind of acoustic transducer which measures the particle velocity directly with figure-of-eight directivity. This paper proposes a near-field noise scanning technology based on the research of PVS, pressure-particle velocity (P-U) probe, and its application in noise source identification. Firstly, the principle and characteristics of PVS are presented. Secondly, a P-U probe is designed on the basis of PVS development. Finally, the noise measurement experiment for a single source is arranged and conducted. The result shows that the proposed P-U probe performs well in near-field noise source identification and localization.

THE STUDY ON MEASURING TECHNIQUE OF PARTIAL DISCHARGE IN GAS INSULATED SWITCHGEAR USING ULTRA HIGH FREQUENCY METHOD WITH EXTERNAL SENSORS

Objective In order to find early latent faults and prevent catastrophic failures, diagnosis of insulation condition by measuring technique of partial discharge(PD) in gas insulated switchgear (GIS) is applied in this paper, which is one of the most basic ways for diagnosis of insulation condition. Methods Ultra high frequency(UHF) PD detection method by using internal sensors has been proved efficient, because it may avoid the disturbance of corona, but the sensor installation of this method will be limited by the structure and operation condition of GIS. There are some of electromagnetic (E-M) waves leak from the place of insulation spacer, therefore, the external sensors UHF measuring PD technique is applied, which isn't limited by the operation condition of GIS. Results This paper analyzes propagated electromagnetic (E-M) waves of partial discharge pulse excited by using the finite-difference time-domain (FDTD) method. The signal collected at the outer point is more complex than that of the inner point, and the signals' amplitude of outer is about half of the inner, because it propagates through spacer and insulation slot. Set up UHF PD measuring system. The typical PD in 252kV GIS bus bar was measured using PD detection UHF technique with external sensors. Finally, compare the results of UHF measuring technique using external sensors with the results of FDTD method simulation and the traditional IEC60270 method detection. Conclusion The results of experiment shows that the UHF technique can realize the diagnosis of insulation condition, the results of FDTD method simulation and the result UHF method detection can demonstrate each other, which gives references to further researches and application for UHF PD measuring technique.

Far-Field Pattern Reconstruction from Positioning Errors Affected Near-Field Data Acquired via Helicoidal Scanning

In this paper, an effective technique to compensate the positioning errors in a near-field—far-field (NF-FF) transformation with helicoidal scanning for elongated antennas is presented and validated both numerically and experimentally. It relies on a nonredundant sampling representation of the voltage measured by the probe, obtained by considering the antenna as enclosed in a cylinder ended in two half-spheres. An iterative scheme is used to reconstruct the helicoidal NF data at the points fixed by the representation from the acquired irregularly spaced ones. Once the helicoidal data have been retrieved, those needed by a classical NF-FF transformation with cylindrical scanning are efficiently evaluated by using an optimal sampling interpolation algorithm. Some numerical tests, assessing the accuracy of the approach and its stability with respect to random errors affecting the data, are reported. Experimental tests performed at the Antenna Characterization Lab of the University of Salerno further confirm the validity of the proposed technique.

Spherical Near-Field - Far-Field Transformation for Quasi-Planar Antennas from Irregularly Spaced Data

An effective near-field - far-field (NF - FF) transformation with spherical scanning for quasi-planar antennas from irregularly spaced data is developed in this paper. Two efficient approaches for evaluating the regularly spaced spherical samples from the nonuniformly distributed ones are proposed and numerically compared. Both the approaches rely on a nonredundant sampling representation of the voltage measured by the probe, based on an oblate ellipsoidal modelling of the antenna under test. The former employs the singular value decomposition method to reconstruct the NF data at the points fixed by the nonredundant sampling representation and can be applied when the irregularly acquired samples lie on nonuniform parallels. The latter is based on an iterative technique and can be used also when such a hypothesis does not hold, but requires the existence of a biunique correspondence between the uniform and nonuniform samples, associ- ating at each uniform sampling point the nearest irregular one. Once the regularly spaced spherical samples have been recovered, the NF data needed by a probe compensated NF - FF transformation with spherical scanning are efficiently evaluated by using an optimal sampling interpolation algorithm. It is so possible to accurately compensate known posi- tioning errors in the NF - FF transformation with spherical scanning for quasi-planar antennas. Some numerical tests assessing the accuracy and the robustness of the proposed approaches are reported.

Underwater hybrid near-field acoustical holography based on the measurement of vector hydrophone array

Hybrid near-field acoustical holography(NAH) is developed for reconstructing acoustic radiation from a cylindrical source in a complex underwater environment. In hybrid NAH,we combine statistically optimized near-field acoustical holography(SONAH) and broadband acoustical holography from intensity measurements(BAHIM) to reconstruct the underwater cylindrical source field. First,the BAHIM is utilized to regenerate as much acoustic pressures on the hologram surface as necessary,and then the acoustic pressures are taken as input to the formulation implemented numerically by SONAH. The main advantages of this technology are that the complex pressure on the hologram surface can be reconstructed without reference signal,and the measurement array can be smaller than the source,thus the practicability and efficiency of this technology are greatly enhanced. Numerical examples of a cylindrical source are demonstrated. Test results show that hybrid NAH can yield a more accurate reconstruction than conventional NAH. Then,an experiment has been carried out with a vector hydrophone array. The experimental results show the advantage of hybrid NAH in the reconstruction of an acoustic field and the feasibility of using a vector hydrophone array in an underwater NAH measurement,as well as the identification and localization of noise sources.

Development and prospect of near-field optical measurements and characterizations

Scanning near-field optical microscopy （SNOM） is an ideal experimental measuring system in nano-optical measurements and characterizations. Besides microscopy with resolution beyond the diffraction limit, spectroscope with nanometer resolution and other instruments with novel performances have been indispensable for researches in nano-optics and nanophotonics. This paper reviews the developing history of near-field optical （NFO） measuring method and foresees its prospects in future. The development of NFO measurements has gone through four stages, including optical imaging with super resolution, near-field spectroscopy, measurements ofnanooptical parameters, and detections of near-field interac- tions. For every stage, research objectives, technological properties and application fields are discussed.

The application of laser reflective tomography in near-field measurements of ultrasonic transducers

With Laser Reflective Tomography（LRT）,the near fields of ultrasonic transducers were measured and analyzed.The principle of LRT measurement of ultrasonic field distribution was introduced and an experimental system was set up.Acoustic pressure of a multiple element piston transducer was measured by using of a laser vibrometer.Its distribution in amplitude and phase was obtained.The acoustic pressure in the same region was measured with a needle hydrophone to validate the LRT method.Furthermore,through reconstruction of acoustic fields,it indicated that LRT method is suitable for predicting the distribution on transducers＇surface and conditions of active elements.

Study on Wave Added Resistance of a Deep-V Hybrid Monohull Based on Panel Method

In this paper, a panel method based on three dimensional potential flow theory is used to study the problem of wave added resistance. The time-domain motion response of Wigely III ship in head waves is calculated by AQWA, and then the wave added resistance of ship is obtained by near-field pressure integration method. By comparing the calculated results with the experimental data in literature, it is shown that the variation trend and peak value are in good agreement, and the accuracy and efficiency meet the research requirements. Based on the above mentioned method, the wave added resistance of a deep-V hybrid monohull in head waves is studied. The motions and wave added resistances of the deep-V hybrid monohull and the deep-V original ship advancing in head waves with various forward speed and wave frequencies are calculated and analyzed. The results show that the longitudinal motion response of the deep-V hybrid monohull is effectively suppressed and the wave added resistance is obviously reduced, the new type of ship has good engineering application prospects. The present method provides an approach of satisfactory accuracy and efficiency to predict wave added resistance of ships voyaging in waves.

Comprehensive analysis of two-dimensional charge transport mechanism in thin-film transistors based on random networks of single-wall carbon nanotubes using transient measurements

Understanding charge transport mechanisms in thin-film transistors based on random networks of single-wall carbon nanotubes(SWCNT-TFTs)is essential for further advances to improve the potential for various nanoelectronic applications.Herein,a comprehensive investigation of the two-dimensional(2D)charge transport mechanism in SWCNT-TFTs is reported by analyzing the temperature-dependent electrical characteristics determined from the direct-current and non-quasi-static transient measurements at 80-300 K.To elucidate the time-domain charge transport characteristics of the random networks in the SWCNTs,an empirical equation was derived from a theoretical trapping model,and a carrier velocity distribution was determined from the differentiation of the transient response.Furthermore,charge trapping and de-trapping in shallow-and deep-traps in SWCNT-TFTs were analyzed by investigating charge transport based on their trapping/de-trapping rate.The comprehensive analysis of this study provides fundamental insights into the 2D charge transport mechanism in TFTs based on random networks of nanomaterial channels.

Optical response of tunable terahertz plasmon in a grating-gated graphene transistor

Tunable terahertz plasmon in a graphene-based device with a grating serving as a top gate is studied. Transmission spectra exhibit a distinct peak in the terahertz region when the terahertz electric field is perpendicular to the grating fingers.Our results show that the extinction in the transmission of single-layer graphene shields beyond 80%. Electronic results further show that the graphene plasmon can be weakly adjusted by tuning the gate voltage. Theoretical calculation also implies that the plasmon frequency of graphene can fall into the terahertz region of 1–2 THz by improving the sustaining ability and capacitance of the top gate.

Comparison Between the Audible Noises Generated from Single Corona Source Under DC and AC Corona Discharge

The corona-generated audible noise(AN)factor is an important consideration in the design and operation of ultrahigh voltage direct current(DC)and alternate current(AC)transmission lines.Due to the differences in discharge process and corona-generated space charges between the DC and AC corona discharge,the audible noise from DC and AC corona has different characteristics.This paper conducts a series of experiments by measuring the time-domain waveforms of the audible noise from a single corona source under DC and AC voltage.Sound pressure pulses are extracted from a correlation analysis,and then a detailed comparison of the basic characteristics of DC and AC corona-generated AN in time-domain and frequency spectrum is given.Results from this paper stand to contribute to an explanation of existing results in AN measurement and analysis from DC and AC transmission lines.