Experimental analysis of the slip sinkage effect based on real vehicle test

To improve the semi-empirical model, the slip sinkage effect is analyzed based on the real vehicle test. A dynamic testing system is used to gain the dynamic responses of wheel-soil interactions, The Gauss-Newton algorithm is adopted to estimate the undetermined parameters involved in the slip sinkage models. Wong＇s original model is compared with three typical slip sinkage models on the prediction performance of a drawbar pull. The maximum error rate, root mean squared error and correlation coefficient are utilized to evaluate the performance. The results indicate that the slip sinkage models outperform Wong＇s model and greatly improve the prediction accuracy. Lyasko＇s model is confirmed as an outstanding one for its comprehensive performance. Hence, the existence of the slip sinkage effect is validated. Lyasko＇s model is selected as an optimal one for the practical evaluation of military vehicle trafficability.

Comparison of Block Design Nonparametric Subset Selection Rules Based on Alternative Scoring Rules

This article compares the size of selected subsets using nonparametric subset selection rules with two different scoring rules for the observations. The scoring rules are based on the expected values of order statistics of the uniform distribution (yielding rank values) and of the normal distribution (yielding normal score values). The comparison is made using state motor vehicle traffic fatality rates, published in a 2016 article, with fifty-one states (including DC as a state) and over a nineteen-year period (1994 through 2012). The earlier study considered four block design selection rules—two for choosing a subset to contain the “best” population (i.e., state with lowest mean fatality rate) and two for the “worst” population (i.e., highest mean rate) with a probability of correct selection chosen to be 0.90. Two selection rules based on normal scores resulted in selected subset sizes substantially smaller than corresponding rules based on ranks (7 vs. 16 and 3 vs. 12). For two other selection rules, the subsets chosen were very close in size (within one). A comparison is also made using state homicide rates, published in a 2022 article, with fifty states and covering eight years. The results are qualitatively the same as those obtained with the motor vehicle traffic fatality rates.

Video-based measurement and data analysis of traffic flow on urban expressways

A new video-based measurement is proposed to collect and investigate traffic flow parameters. The output of the measurement is velocity-headway distance data pairs. Because density can be directly acquired by the reciprocal of headway distance, the data pairs have the advantage of better simultaneity than those from common detectors. By now, over 33 000 pairs of data have been collected from two road sections in the cities of Shanghai and Zhengzhou. Through analyzing the video files recording traffic movements on urban expressways, the following issues are studied：laws of vehicle velocity changing with headway distance, proportions of di0erent driving behaviors in the traffic system, and characteristics of traffic flow in snowy days. The results show that the real road traffic is very complex, and factors such as location and climate need to be taken into consideration in the formation of traffic flow models.

A Comparison of Machine Learning Techniques in the Carpooling Problem

Urban traffic congestion is a severe and widely studied problem over the decade because of the negative impacts. However, in recent years some approaches emerge as proper and suitable solutions. The Carpooling initiative is one of the most representative efforts to propitiate a responsible use of particular vehicles. Thus, the paper introduces a carpooling model considering the users’ preference to reach an appropriate match among drivers and passengers. In particular, the paper conducts a study of 6 of the most avid classified techniques in machine learning to create a model for the selection of travel companions. The experimental results show the models’ precision and assess the best cases using Friedman’s test. Finally, the conclusions emphasize the relevance of the proposed study and suggest that it is necessary to extend the proposal with more drives and passengers’ data.

Influence of traffic on the temperature field of tunnel in cold region:A case study on the world’s longest highway spiral tunnel

The impact of the piston wind caused by vehicle traffic on the temperature field distribution of the tunnel cannot be ignored,especially in spiral tunnels,where the temperature field distribution is more complicated than that in straight tunnels.Based on the world’s longest highway spiral tunnel,this study explores the influence of traffic on the temperature fields of spiral and straight tunnels,and proposes a new design method for laying length of insulation layer.The results show that traffic has a significant effect on the temperature field dis-tribution in the tunnel.The influence degree of different traffic elements decreases in the following order:average vehicle speed>daily traffic>morning rush hour>evening rush hour.The temperature field distribution of spiral tunnels is asymmetry on the left and right compared with straight tunnels,while the influence degree of traffic on the outside of spiral tunnels is similar to that of straight tunnels.Due to the difference of wind direction and traffic direction at different tunnel openings,an asymmetric insulation layer laying method is proposed.It is suggested that the lengths of the insulation layers of the Jinjiazhuang Tunnel should be 1200 m for the right tunnel inlet,700 m for the right tunnel outlet,700 m for the left tunnel inlet,and 1400 m for the left tunnel outlet.

An estimation of vehicle kilometer traveled and on-road emissions using the traffic volume and travel speed on road links in Incheon City

The objective of this study is to estimate the vehicle kilometer traveled（VKT） and on-road emissions using the traffic volume in urban. We estimated two VKT; one is based on registered vehicles and the other is based on traffic volumes. VKT for registered vehicles was 2.11 times greater than that of the applied traffic volumes because each VKT estimation method is different. Therefore, we had to define the inner VKT is moved VKT inner in urban to compare two values. Also, we focused on freight modes because these are discharged much air pollutant emissions. From analysis results, we found middle and large trucks registered in other regions traveled to target city in order to carry freight, target city has included many industrial and logistics areas. Freight is transferred through the harbors,large logistics centers, or via locations before being moved to the final destination. During this process, most freight is moved by middle and large trucks, and trailers rather than small trucks for freight import and export. Therefore, these trucks from other areas are inflow more than registered vehicles. Most emissions from diesel trucks had been overestimated in comparison to VKT from applied traffic volumes in target city. From these findings, VKT is essential based on traffic volume and travel speed on road links in order to estimate accurately the emissions of diesel trucks in target city. Our findings support the estimation of the effect of on-road emissions on urban air quality in Korea.

Range-rate tradeoffs in the communication between LED traffic lights and vehicles

Visible light communication between light emitting diode(LED) traffic lights and vehicles with a receiving photodiode front-end is developed for intelligent transportation systems. In this letter, the communication data rates for different ranges are evaluated. The data rates are based on real scenarios of the background noise and path losses and are experimentally obtained with a testing system built upon commercial offthe-shelf components. Comparisons of range-rate performance for different average noise levels are also conducted with the use of red/yellow/green LED lights. Results show that achieving the data rates of kilobits per second at a communication range of hundred meters is possible under the ordinary noise scenario, a finding that is highly significant for practical applications.