Quantum-dot Semiconductor Optical Amplifiers in State Space Model

A state space model(SSM) is derived for quantum-dot semiconductor optical amplifiers(QD-SOAs).Rate equations of QD-SOA are formulated in the form of state update equations,where average occupation probabilities along QD-SOA cavity are considered as state variables of the system.Simulations show that SSM calculates QD-SOA′s static and dynamic characteristics with high accuracy.

Analytic approach to the small-signal frequency response of saturated semiconductor optical amplifiers using multisection model

An analytic solution derived by multisection model to the small-signal frequency response （SSFR） of wavelength conversion based on cross-gain modulation （XGM） in semiconductor optical amplifiers （SOAs） is presented. The result contains details that can affect the characteristics of SSFR significantly more than previous ones.

All-optical error-bit amplitude monitor based on NOT and AND gates in cascaded semiconductor optical amplifiers

This paper proposes and simulates a novel all-optical error-bit amplitude monitor based on cross-gain modulation and four-wave mixing in cascaded semiconductor optical amplifiers （SOAs）, which function as logic NOT and logic AND, respectively. The proposed scheme is successfully simulated for 40 Gb/s return-to-zero （RZ） signal with different duty cycles. In the first stage, the SOA is followed by a detuning filter to accelerate the gain recovery as well as improve the extinction ratio. A clock probe signal is used to avoid the edge pulse-pairs in the output waveform. Among these RZ formats, 33% RZ format is preferred to obtain the largest eye opening. The normalized error amplitude, defined as error bit amplitude over the standard mark amplitude, has a dynamic range from 0.1 to 0.65 for all RZ formats. The simulations show small input power dynamic range because of the nonlinear gain variation in the first stage. This scheme is competent for nonreturn-to-zero format at 10Gb/s as well.

Reconfigurable all-optical dual-directional half-subtractor for high-speed differential phase shift keying signal based on semiconductor optical amplifiers

All-optical digital logic elementary circuits are the building blocks of many important computational operations in future high-speed all-optical networks and computing systems. Multifunetional and reconfigurable logic units are essential in this respect. Employing the demodulation properties of delay interferometers for input differential phase shift keying signals and the gain saturation effect in two parallel semiconductor optical amplifiers, a novel design of 40 Cbit/s reconfigurable all-optical dual-directional half-subtractor is proposed and demonstrated. All output logic results show that the scheme achieves over 11=dB extinction ratio, clear and wide open eye diagram, as well as low polarization dependence （〈 1 dB）, without using any additional input light beam. The scheme may provide a promising candidate for future ultrafast all-optical signal processing applications.

All-Optical Sampling Using Nonlinear Polarization Rotation in a Single Semiconductor Optical Amplifier

We propose a novel all-optical sampling method using nonlinear polarization rotation in a semiconductor optical amplifier. A rate-equation model capable of describing the all-optical sampling mechanism is presented in this paper. Based on this model, we investigate the optimized operating parameters of the proposed system by simulating the output intensity of the probe light as functions of the input polarization angle, the phase induced by the polarization controller, and the ori- entation of the polarization beam splitter. The simulated results show that we can obtain a good linear slope and a large linear dynamic range,which is suitable for all-optical sampling. The operating power of the pump light can be less than lmW. The presented all-optical sampling method can potentially operate at a sampling rate up to hundreds GS/s and needs low optical power.

Design of Tensile Strained InGaAsP/InGaAsP MQW for 1.55μm Polarization Independent Semiconductor Optical Amplifier

The theoretical optimization of tensile strained InGaAsP/InGaAsP MQW for 1.55μm windows polarization-independent semiconductor optical amplifier is reported.The valence-band structure of the MQW is calculated by using k·p method,in which 6×6 Luttinger effective-mass Hamiltonian is taken into account.The polarization dependent optical gain is calculated with various well width,strain,and carrier density.

An Electroabsorption Modulator Monolithically Integrated with a Semiconductor Optical Amplifier and a Dual-Waveguide Spot-Size Converter

A semiconductor optical amplifier and electroabsorption modulator monolithically integrated with a spotsize converter input and output is fabricated by means of selective area growth,quantum well intermixing,and asymmetric twin waveguide technology. A 1550-1600nm lossless operation with a high DC extinction ratio of 25dB and more than 10GHz 3dB bandwidth are successfully achieved. The output beam divergence angles of the device in the horizontal and vertical directions are as small as 7.3°× 18.0°, respectively, resulting in a 3.0dB coupling loss with a cleaved single-mode optical fiber.

Wide-Band Polarization-Independent Semiconductor Optical Amplifier Gate with Tensile-Strained Quasi-Bulk InGaAs

A semiconductor optical amplifier gate based on tensile strained quasi bulk InGaAs is developed.At injection current of 80mA,a 3dB optical bandwidth of more than 85nm is achieved due to dominant band filling effect.Moreover,the most important is that very low polarization dependence of gain (<0 7dB),fiber to fiber lossless operation current (70～90mA) and a high extinction ratio (>50dB) are simultaneously obtained over this wide 3dB optical bandwidth (1520～1609nm) which nearly covers the spectral region of the whole C band (1525～1565nm) and the whole L band (1570～1610nm).The gating time is also improved by decreasing carrier lifetime.The wide band polarization insensitive SOA gate is promising for use in future dense wavelength division multiplexing (DWDM) communication systems.

Towards 640 Gbit/s wavelength conversion based on nonlinear polarization rotation in a semiconductor optical amplifier

Taking into account ultra-fast carrier dynamics, this paper models 640 Gbit/s wavelength conversion scheme based on nonlinear polarization rotation （NPR） in a single semiconductor optical amplifier （SOA） and investigates the performance of this kind of wavelength conversion scheme in detail. In this model, two carrier temperature equations are introduced to substitute two energy density equations, which reduce the complexity of calculation in comparison with the previous model. The temporary gain and phase shift dynamics induced by ultra-short optical pulses are numerically simulated and the simulated results are qualitatively in good agreement with reported experimental results. Simulated results show that non-inverted and inverted 640 Gbit/s wavelength conversions based on NPR are achieved with clear open eye diagrams. To further investigate the performance of the non-inverted wavelength conversion scheme, the dependence of output extinction ratio （ER） on some key parameters used in simulation is illustrated. Furthermore, simulated analyses show that high performance non-inverted wavelength conversion based on NPR can be achieved by using a red-shifted filtering scheme.

Photonic multi-shape UWB pulse generation using a semiconductor optical amplifier-based nonlinear optical loop mirror

We propose and demonstrate a scheme to implement photonic multi-shape ultra-wideband（UWB） signal generation using a semiconductor optical amplifier（SOA） based nonlinear optical loop mirror（NOLM）.By employing the cross phase modulation（XPM） effect,cross gain modulation（XGM）,or both,multi-shape UWB waveforms are generated including monocycle,doublet,triplet,and quadruplet pulses.Both the shapes and polarities of the generated pulses are flexible to adjust,which may be very useful in UWB pulse shape modulation and pulse polarity modulation.

Photonic generation of power-efficient FCC-compliant ultra-wideband waveforms using semiconductor optical amplifier (SOA):theoretical analysis and experiment verification

We theoretically design a power-efficient ultra-wideband pulse generator by combining three monocycle pulses with different weights. We also experimentally demonstrate a feasible scheme to generate such power-efficient ultra-wideband waveforms using cross-phase modulation in a single semiconductor optical amplifier. The designed ultra-wideband pulse fully satisfies the requirements for the spectral mask specified by the Federal Communications Commission with high power efficiency. In the experiment, a power-efficient ultra-wideband waveform with a pulse duration of 310 ps is achieved, and the power efficiency is greatly improved compared with that of a single nlonocycle pulse or a mixture of two monoeycles.

Semiconductor Optical Amplifier and Gain Chip Used in Wavelength Tunable Lasers

The design concept of semiconductor optical amplifier(SOA)and gain chip used in wavelength tunable lasers(TL)is discussed in this paper.The design concept is similar to that of a conventional SOA or a laser;however,there are a few different points.An SOA in front of the tunable laser should be polarization dependent and has low optical confinement factor.To obtain wide gain bandwidth at the threshold current,the gain chip used in the tunable laser cavity should be something between SOA and fixed-wavelength laser design,while the fixed-wavelength laser has high optical confinement factor.Detailed discussion is given with basic equations and some simulation results on saturation power of the SOA and gain bandwidth of gain chip are shown.

Semiconductor Optical Amplifier (SOA)-Fiber Ring Laser and Its Application to Stress Sensing

We have developed a novel optical fiber ring laser using a semiconductor optical amplifier (SOA) as the gain medium, and taking advantage of polarization anisotropy of its gain. The frequency difference of the bi-directional laser is controlled by birefringence which is introduced in the ring laser cavity. The beat frequency generated by combining two counter-propagating oscillations is proportional to the birefringence, the fiber ring laser of the present study is, therefore, applicable to the fiber sensor. The sensing signal is obtained in a frequency domain with the material which causes the retardation change by a physical phenomenon to be measured. For the application to stress sensing, the present laser was investigated with a photoelastic material.

Semiconductor optical amplifier used as regenerator for degraded differential phase-shift keying signals

Phase and amplitude regeneration are necessary for degraded differential phase-shift keying communication sys- tems. This paper proposes a regenerator based on semiconductor optical amplifier for differential phase-shift keying signals. The key regeneration mechanism is theoretically analysed. The effectiveness of semiconductor optical amplifier based regenerator is demonstrated by comparing the bit error rate and eye diagrams before and after regeneration for 40-Cbit/s differential phase-shift keying 1080-km transmission systems. The results show that regeneration effects are very well. Bit error rate is tess than 10-12 with the regenerator.

All-optical XNOR and AND gates simultaneously realized in a single semiconductor optical amplifier with improved dynamics

All-optical XNOR and AND logic gates using four-wave mixing （FWM） and cross-gain modulation （XGM） in a single semiconductor optical amplifier （SOA） with improved dynamics are simultaneously realized. By numerical simulation, the effects of the input optical wave powers and injection current on the critical factors of the logic gate performances, such as the ON-OFF contrast ratio, the power-output level of the logic ＇1＇, and the difference between power outputs of the logic ＇1＇, are investigated in detail. In addition, the effect of the counter-propagating CW pump on the gain recovery is analysed.

Optimization of regenerator based on semiconductor optical amplifier for degraded differential phase shift keying signal

Real time phase regeneration is necessary for degraded phase modulation format optical communication systems. A regenerator based on the discrimitive gain effect of a semiconductor optical amplifier was proposed in recent years. In this paper, for this type of regenerator, its optimal working condition is found by solving the dynamic equations which describe the variance of the optical field and carrier density in the semiconductor optical amplifier by the finite difference method. The results show that the optimal improvement of signal Q factor can reach more than 2.2 dB.

A High Efficiency Wavelength Conversion Scheme Based on Four Wave Minxing in a Semiconductor Optical Amplifier

A new approach of all optical wavelength converter based on four wave mixing (FWM) in a semiconductor optical amplifier (SOA) with the conjugate wave reflected by a fiber Bragg grating (FBG) and then amplified by the SOA is reported. By adjusting the pump power, the conversion efficiency could be improved 7～10dB with signal to background noise ratio (SBR) deteriorated 1～2dB, compared with traditional single pump four wave mixing.

10-Gb/s Transmission in WDM PON Employing Reflective Semiconductor Optical Amplifier and Fibre Bragg Grating Equaliser

We propose a 10-Gb/s Wavelength- Division-Multiplexed Passive Optical Network （WDM-PON） scheme with upstream transmi- ssion employing Reflective Semiconductor Op- tical Amplifier （RSOA） and Fibre Bragg Gra- ting （FBG） optical equaliser. Transmissions of 10-Gb/s non return-to-zero signals using a 1.2- GHz RSOA and FBG optical equaliser with different setups are demonstrated. Significant performance improvement and 40-kin standard single mode fibre transmission are achieved using FBG optical equaliser and Remotely Pum- ped Erbium-Doped Fibre Amplifier （RP-EDFA）, where they are used to equalise the output of the band-limited RSOA and amplify the seed light and upstream signal, respectively.

Device Design and Characteristics for SOA-basedAll Optical Signal 2R Regeneration

A new scheme based on SOA-MZI for all-optical 2R regeneration is proposed. The characteristics of gain and switching window of this device are investigated in detail. Numerical simulation results indicate that the nonlinear gain compression, the time delay between the input optical signal and the width of the optical pulse are essential parameters for a good performance of all-optical 2R regeneration.

Investigation on performance of all optical buffer with large dynamical delay time based on cascaded double loop optical buffers

Optical buffers are critical for optical signal processing in future optical packet-switched networks. In this paper, a theoretical study as well as an experimental demonstration on a new optical buffer with large dynamical delay time is carried out based on cascaded double loop optical buffers （I：）LOBs）. It is found that pulse distortion can be restrained by a negative optical control mode when the optical packet is in the loop. Noise analysis indicates that it is feasible to realise a large variable delay range by cascaded DLOBs. These conclusions are validated by the experiment system with 4-stage cascaded DLOBs. Both the theoretical simulations and the experimental results indicate that a large delay range of 1-9999 times the basic delay unit and a fine granularity of 25 ns can be achieved by the cascaded DLOBs. The performance of the cascaded DLOBs is suitable for the all optical networks.