Being aimed at the inside wall wrinkling and sinking phenomenon of palladium-yttrium alloy thin wall spiral tube used for preparation of high purity hydrogen, extraction of hydrogen isotope, and purification and separ...Being aimed at the inside wall wrinkling and sinking phenomenon of palladium-yttrium alloy thin wall spiral tube used for preparation of high purity hydrogen, extraction of hydrogen isotope, and purification and separation of hydrogen in the winding process, this article analyzed the reasons for above phenomena, established a numerical simulation model of winding process of above tube, using elastic-plastic Finite Element method analyzed the max. tensile stress and max. compression stress and their locations, thereby provides a theory base for the control of working forming course of thin wall spiral tube.展开更多
The correction method uses the static pressures measured near the tunnelwalls during model tests as boundary conditions. It is required that the flow near thewalls is subsonic and the freestream Mach number is less th...The correction method uses the static pressures measured near the tunnelwalls during model tests as boundary conditions. It is required that the flow near thewalls is subsonic and the freestream Mach number is less than 1. It is still valid whenthere are shock waves and supersonic pockets near the model as long as shock waves donot extend to walls, and the method is applicable to various ventilated wall or solid walltest sections. Corrections for three models tested abroad are in quite good agreementwith NASA's results, which are obtained by a nonhnear correction method. Thepresnet method has been apphed to B737 inodel tcsted in CARDC 1.2 m wind tunnel.The results show that this method is suitable for transonic wall interference correctionfor high aspect ratio airplane tests.展开更多
特高压(ultra high voltage,UHV)换流站阀厅的金属屋面系统在风荷载作用下易发生屋面表层风揭事故。为深入探讨该类建筑屋面的风压极值特性,基于风洞试验分别探讨了大气边界层(atmospheric-boundary-layer,ABL)风、壁面射流、均匀湍流...特高压(ultra high voltage,UHV)换流站阀厅的金属屋面系统在风荷载作用下易发生屋面表层风揭事故。为深入探讨该类建筑屋面的风压极值特性,基于风洞试验分别探讨了大气边界层(atmospheric-boundary-layer,ABL)风、壁面射流、均匀湍流三种风场作用下的屋面风压特性,比较了平均风剖面、风速、风向、湍流强度等因素对屋面风压的影响。结果表明:阀厅屋盖迎风前缘负风压最大,且控制风向角在45°左右;壁面射流风场下平均风压系数与脉动风压系数均超过大气边界层风场的结果;风速对阀厅屋盖的负风压系数均值和极值影响较小,而湍流度对风压系数的极值影响较大;大气边界风场时,JGJ/T 481—2019《屋盖结构风荷载标准》的最不利风压系数建议值偏于安全;而在壁面射流风场下,阀厅屋盖全风向最不利风压系数在所有区域都大于JGJ/T 481—2019的建议值,设计中应加以重视。展开更多
in this paper a method is outlined to compute wall-interferenee in closedlow speed wind tunnel for 3D high lift test using wall pressure at optimum points andthe influence function (WPIF method for short). The experim...in this paper a method is outlined to compute wall-interferenee in closedlow speed wind tunnel for 3D high lift test using wall pressure at optimum points andthe influence function (WPIF method for short). The experimental results of a high liftmodel in small wind tunnel are corrected by applying the WPIF method. The correctedresults are compared with the wall interference-free data of this high lift model in largewind tunnel. It is shown that the WPIF method is desirable for the correction of lift,drag and pitch moment.展开更多
Due to excessive displacements of tall buildings occasioned by lateral loads, lateral load resisting systems are usually provided to curtail the load effect. The resistance may be offered by Frame Action, Shear Walls,...Due to excessive displacements of tall buildings occasioned by lateral loads, lateral load resisting systems are usually provided to curtail the load effect. The resistance may be offered by Frame Action, Shear Walls, or combined Walls and Frames (also known as Dual System). In this study, finite element based software, ETABS, was used to generate and analyse three-dimensional building models for the assessment of the relative effectiveness of the various lateral load resisting systems. Three models were used, one each for the three resisting systems. Each model consisted of three samples representing three different building heights of 45 m, 75 m, and 99 m. Wind Design Spreadsheet complying with the appropriate British Standards was used to compute preliminary wind load coefficients using the wind speed values from the relevant wind isopleth map of Nigeria as primary data. Lateral wind load was then applied at floor levels of each of the building samples. Each building sample was subjected to three-dimensional analysis for the determination of both the lateral displacements of storey tops and interstorey drifts. The results of the work showed that the dual system was the most efficient lateral-load resisting system based on deflection criterion, as they yielded the least values for lateral displacements and inter-storey drifts. The moment frame was the least stiff of the resisting systems, yielding the highest values of both the lateral displacement and the inter-storey drift.展开更多
This paper introduces the method of coal dust treatment in crushing station and the present situation of dust removal system in typical open-pit coal mine crushing station in China,and expounds the research idea of de...This paper introduces the method of coal dust treatment in crushing station and the present situation of dust removal system in typical open-pit coal mine crushing station in China,and expounds the research idea of determining comprehensive dust removal(suppression)system in crushing station inspired by the working principle of"range hood".Based on the design example and link optimization of the crush-ing station of open-pit coal mine I of Thar coalfield,this paper finally draws some conclusions on the key technologies of dust removal(suppression)system of open-pit coal mine crushing station.This study has certain reference value for the technical innovation of dust removal(suppression)system in crushing station,the realization of green mining in"crushing link",and the reduction and avoidance of ecological environment pollution in mining area.展开更多
文摘Being aimed at the inside wall wrinkling and sinking phenomenon of palladium-yttrium alloy thin wall spiral tube used for preparation of high purity hydrogen, extraction of hydrogen isotope, and purification and separation of hydrogen in the winding process, this article analyzed the reasons for above phenomena, established a numerical simulation model of winding process of above tube, using elastic-plastic Finite Element method analyzed the max. tensile stress and max. compression stress and their locations, thereby provides a theory base for the control of working forming course of thin wall spiral tube.
文摘The correction method uses the static pressures measured near the tunnelwalls during model tests as boundary conditions. It is required that the flow near thewalls is subsonic and the freestream Mach number is less than 1. It is still valid whenthere are shock waves and supersonic pockets near the model as long as shock waves donot extend to walls, and the method is applicable to various ventilated wall or solid walltest sections. Corrections for three models tested abroad are in quite good agreementwith NASA's results, which are obtained by a nonhnear correction method. Thepresnet method has been apphed to B737 inodel tcsted in CARDC 1.2 m wind tunnel.The results show that this method is suitable for transonic wall interference correctionfor high aspect ratio airplane tests.
文摘特高压(ultra high voltage,UHV)换流站阀厅的金属屋面系统在风荷载作用下易发生屋面表层风揭事故。为深入探讨该类建筑屋面的风压极值特性,基于风洞试验分别探讨了大气边界层(atmospheric-boundary-layer,ABL)风、壁面射流、均匀湍流三种风场作用下的屋面风压特性,比较了平均风剖面、风速、风向、湍流强度等因素对屋面风压的影响。结果表明:阀厅屋盖迎风前缘负风压最大,且控制风向角在45°左右;壁面射流风场下平均风压系数与脉动风压系数均超过大气边界层风场的结果;风速对阀厅屋盖的负风压系数均值和极值影响较小,而湍流度对风压系数的极值影响较大;大气边界风场时,JGJ/T 481—2019《屋盖结构风荷载标准》的最不利风压系数建议值偏于安全;而在壁面射流风场下,阀厅屋盖全风向最不利风压系数在所有区域都大于JGJ/T 481—2019的建议值,设计中应加以重视。
文摘in this paper a method is outlined to compute wall-interferenee in closedlow speed wind tunnel for 3D high lift test using wall pressure at optimum points andthe influence function (WPIF method for short). The experimental results of a high liftmodel in small wind tunnel are corrected by applying the WPIF method. The correctedresults are compared with the wall interference-free data of this high lift model in largewind tunnel. It is shown that the WPIF method is desirable for the correction of lift,drag and pitch moment.
文摘Due to excessive displacements of tall buildings occasioned by lateral loads, lateral load resisting systems are usually provided to curtail the load effect. The resistance may be offered by Frame Action, Shear Walls, or combined Walls and Frames (also known as Dual System). In this study, finite element based software, ETABS, was used to generate and analyse three-dimensional building models for the assessment of the relative effectiveness of the various lateral load resisting systems. Three models were used, one each for the three resisting systems. Each model consisted of three samples representing three different building heights of 45 m, 75 m, and 99 m. Wind Design Spreadsheet complying with the appropriate British Standards was used to compute preliminary wind load coefficients using the wind speed values from the relevant wind isopleth map of Nigeria as primary data. Lateral wind load was then applied at floor levels of each of the building samples. Each building sample was subjected to three-dimensional analysis for the determination of both the lateral displacements of storey tops and interstorey drifts. The results of the work showed that the dual system was the most efficient lateral-load resisting system based on deflection criterion, as they yielded the least values for lateral displacements and inter-storey drifts. The moment frame was the least stiff of the resisting systems, yielding the highest values of both the lateral displacement and the inter-storey drift.
文摘This paper introduces the method of coal dust treatment in crushing station and the present situation of dust removal system in typical open-pit coal mine crushing station in China,and expounds the research idea of determining comprehensive dust removal(suppression)system in crushing station inspired by the working principle of"range hood".Based on the design example and link optimization of the crush-ing station of open-pit coal mine I of Thar coalfield,this paper finally draws some conclusions on the key technologies of dust removal(suppression)system of open-pit coal mine crushing station.This study has certain reference value for the technical innovation of dust removal(suppression)system in crushing station,the realization of green mining in"crushing link",and the reduction and avoidance of ecological environment pollution in mining area.
