Atmospheric transmission algorithm for pulsed X-rays from high-altitude nuclear detonations based on scattering correction

In high-altitude nuclear detonations,the proportion of pulsed X-ray energy can exceed 70%,making it a specific monitoring signal for such events.These pulsed X-rays can be captured using a satellite-borne X-ray detector following atmospheric transmission.To quantitatively analyze the effects of different satellite detection altitudes,burst heights,and transmission angles on the physical processes of X-ray transport and energy fluence,we developed an atmospheric transmission algorithm for pulsed X-rays from high-altitude nuclear detonations based on scattering correction.The proposed method is an improvement over the traditional analytical method that only computes direct-transmission X-rays.The traditional analytical method exhibits a maximum relative error of 67.79% compared with the Monte Carlo method.Our improved method reduces this error to within 10% under the same conditions,even reaching 1% in certain scenarios.Moreover,its computation time is 48,000 times faster than that of the Monte Carlo method.These results have important theoretical significance and engineering application value for designing satellite-borne nuclear detonation pulsed X-ray detectors,inverting nuclear detonation source terms,and assessing ionospheric effects.

Design of Time-Resolved Shifted Dual Transmission Grating Spectrometer for the X-Ray Spectrum Diagnostics

A new time-resolved shifted dual transmission grating spectrometer （SDTGS） is designed and fabricated in this work. This SDTGS uses a new shifted dual transmission grating （SDTG） as its dispersive component, which has two sub transmission gratings with different line densities, of 2000 lines/mm and 5000 lines/mm. The axes of the two sub transmission gratings in SDTG are horizontally and vertically shifted a certain distance to measure a broad range of 0.1-5 keV time-resolved X-ray spectra. The SDTG has been calibrated with a soft X-ray beam of the synchrotron radiation facility and its diffraction efficiency is also measured. The designed SDTGS can take full use of the space on a record panel and improve the precision for measuring spatial and temporal spectrum simultaneously. It will be a promising application for accurate diagnosis of the soft X-ray spectrum in inertial confinement fusion.

Theory and verification of moiréfringes for x-ray three-phase grating interferometer

Dual-phase and three-phase grating x-ray interference is a promising new technique for grating-based x-ray differential phase contrast imaging.Dual-phase grating interferometers have been relatively completely studied and discussed.In this paper,the corresponding imaging fringe formula of the three-phase grating interferometer is provided.At the same time,the similarities and differences between the three-phase grating interferometer and the dual-phase grating interferometer are investigated and verified,and that the three-phase grating interferometer can produce large-period moiréfringes without using the analyzing grating is demonstrated experimentally.Finally,a simple method of designing three-phase grating and multi-grating imaging systems from geometric optics based on the thin-lens theory of gratings is presented.These theoretical formulas and experimental results provide optimization tools for designing three-phase grating interferometer systems.

A rapid and convenient experimental method of absolutely calibrating transmission of x-ray flat-response filter

We develop a rapid and convenient experimental method of absolutely calibrating the transmission of an x-ray flatresponse filter. The calibration experiment is performed on a small laser-target facility, and a set of high resolution holographic flat-field grating spectrometers is used as a discrimination system of the laser-produced x-ray source. Given that the holographic flat-field grating has a relatively large width, the grating is divided into two regions for use in that direction,where one region has the filter added and the other region does not. The filter transmission is determined by dividing the x-ray signal counts detected when the filter is in the line of sight by those detected when the filter is out of the line of sight.We find that the calibration results of this experiment agree with the calibration results using a synchrotron radiation source,as well as simulation results. Our method is not only highly reliable but also rapid and convenient.

Extraordinary optical transmission through metal gratings with single and double grooved surfaces

We investigate the transmission properties of a normally incident TM plane wave through metal films with periodic parabolic-shaped grooves on single and double surfaces using the finite-difference-time-domain method. Nearly zero transmission efficiency is found at wavelengths corresponding to surface plasmon excitation on a fiat surface in the case where the single surface is grooved. Meanwhile, resonant excitation of surface plasmon polariton （SPP） Bloch modes leads to a strong transmission peak at slightly larger wavelengths. When the grating is grooved on double surfaces, the transmission enhancement can be dramatically improved due to the resonant tunnelling between SPP Bloch modes.

Space-Resolved Spectrum Diagnose by Soft X-Ray Transmission Grating Spectrometer

A space-resolving transmission grating spectrometer is established on the ＂Shenguang-III＂ prototype laser facility and an iterative procedure for unfolding the X-ray spectrum with spatial resolution is described. The diagnostics is applied to measure the X-ray spectrum from laser-entered gold target and the typical space-resolved spectrum is provided. The relative standard uncertainty of the X-ray spectrum from the laser-generated plasma is also determined.

Study of transmission grating diffraction efficiencies for soft X-ray

Tansmission grating spectrometers are extensively used to measure absthlute X-ray spectra in a photon-energy range below 1000 eV. The transmission grating,as its dispersive element, must be calibrated to obtain its danaction efficiencies. Calibrations of absolute distraction efficiencies of the tlansmission grating at photon energyof 844eV have been carried out on Beliing Synchrotron mediation Facility. With theaid of grating model, all of the grating structure paraxneters have been determinedand the absolute dchaction efficiencies in a photon-energy range below 2000eV havealso been calculated and discussed.

Thermal and Transmission Properties of UV Nonlinear Optical Material——ZnCd(SCN)_4 Crystal

zinc cadmium thiocyanate (ZCTC), ZnCd(SCN)_4, has been discoveredas a UV second-order nonlinear optical coordination crystal. Titsthermal and transmission Properties are reported. The thermaldecomposition is characterized by using the X-ray Powder diffraction(XRPD) and infrared (IR) spectroscopy at room temperature. TheAbsorptions of intrinsic ions and ZCTC in a solution state arediscussed as well as Transmission properties of the ZCTC crystal. Aneffective method of reducing the surface Reflection loss of ZCTCcrystal is introduced.

Fiber Bragg grating monitors for thermal and stress of the composite insulators in transmission lines

Running composite insulators are prone to failure due to their harsh surrounding work environment, which directly affects the safe operation of transmission lines. This paper puts forward the method of using fiber Bragg grating(FBG) as the monitors to parameters correlated with thermal and stress of the composite insulators in transmission lines at working status. Firstly, monitoring points are found out by the mechanical test on composite insulator samples. Secondly, based on the monitoring theory, this paper introduces the feasibility design frame of the composite insulator with FBG implanted in the rod and the online monitor system. At last, it describes applications of this monitor system in the field of transmission lines.

Spectral analysis of the UFBG-based acousto optical modulator in V–I transmission matrix formalism

In this study, the V-I transmission matrix formalism （V-I method） is proposed to analyze the spectrum characteristics of the uniform fiber Bragg grating （FBG）-based acousto--opfic modulators （UFBG-AOM）. The simulation results demon- strate that both the amplitude of the acoustically induced strain and the frequency of the acoustic wave （AW） have an effect on the spectrum. Additionally, the wavelength spacing between the primary reflectivity peak and the secondary reflectivity peak is proportional to the acoustic frequency with the ratio 0.1425 nm/MHz. Meanwhile, we compare the amount of calculation. For the FBG whose period is M, the calculation of the V-I method is 4 × （2M-l） in addition/subtraction, 8 × （2M - 1） in multiply/division and 2M in exponent arithmetic, which is almost a quarter of the multi-film method and transfer matrix （TM） method. The detailed analysis indicates that, compared with the conventional multi-film method and transfer matrix （TM） method, the V-I method is faster and less complex.

Influence of intra-cavity loss on transmission characteristics of fiber Bragg grating Fabry–Perot cavity

A theoretical model of the fiber Bragg grating Fabry–Perot（FBG-FP） transmission spectrum considering loss of FBG and intra-cavity fiber is presented. Several types of FBG-FPs are inscribed experimentally, and their spectra are measured.The results confirm that weak intra-cavity loss is enhanced at the resonance transmission peak, that is, loss of transmission peaks is observably larger than other wavelengths. For FBG-FPs with multi resonance peaks, when the resonance peak wavelength is closer to the Bragg wavelength, the more significant loss effect of resonance transmission peak is exhibited.The measured spectra are fitted with the presented theoretical model. The fitted coefficient of determinations are near 1,which proves the validity of the theoretical model. This study can be applied to measure FBG loss more accurately, without a reference light. It can play an important role in FBG and FBG-FP writing process optimization and application parameter optimization.

Extraordinary Transmission through Metallic Grating with Subwavelength Slits for S-Polarization Illumination

Based on the rigorous coupled-wave analysis algorithm, we have systematically analysed the effect of the geometrical parameters of a dielectric film coated metallic grating with subwavelength slits on extraordinary optical transmission for s-polarization illumination. Results show that the dielectric film which sustains a waveguide electromagnetic mode on the top of the metallic lamellar grating can strongly enhance the transmittance, the positions of the transmission peaks are mainly determined by the period of the metallic grating, the thickness and refractive index of the dielectric film. This structure shows potential applications in excellent polarizers or polarization-isotropic devices at infrared spectral range by appropriately choosing the geometrical parameters.

Manipulation of extraordinary acoustic transmission by a tunable bull's eye structure

Extraordinary acoustic transmission （EAT） has been investigated in a tunable bull＇s eye structure. We demonstrate that the transmission coefficient of acoustic waves can be modulated by a grating structure. When the grating is located at a distance of 0.5 mm from the base plate, the acoustic transmission shows an 8.77-fold enhancement compared to that by using a traditional bull＇s eye structure. When the distance increases to 1.5 mm, the transmission approaches zero, indicating a total reflection. Thus, we can make an efficient modulation of acoustic transmission from 0 to 877%. The EAT effects have been ascribed to the coupling of structure-induced resonance with the diffractive wave and the waveguide modes, as well as the Fabry-Perot resonances. As a potential application, the modulation of far-field collimation is illustrated in the proposed bull＇s eye structure.

Surface plasmon resonance transmission filters at 1053 nm based on metallic grating with narrow slit

Metallic gratings with narrow slits can lead to special optical properties such as strongly enhancing the trans- mission and considerably strengthening the polarized effect. A narrow-band filter suitable for application in optical communication is designed by sandwiching a metallic grating between two identical dielectric films. The maximum transmission can reach 96% after optimizing the parameters of films and grating at a central wavelength of 1053 nm. It is the first time, to our knowledge, that such high transmission has been reported since the discovery of the extraordinarily high transmission through periodic holes or slits; moreover, the extremely polarized effect is also found in P mode of this symmetric grating.

Controls of pass-bands in asymmetric acoustic transmission

The controls of the pass-bands in an asymmetric acoustic transmission system are investigated numerically and ex- perimentally, and the system consists of a periodical rectangular grating and two uniform brass plates in water. We reveal that the pass-band of the asymmetric acoustic transmission is closely related to the grating period, but is affected slightly by the brass plate thickness. Moreover, the transmittance can be improved by adjusting the grating period and other structural parameters simultaneously. The control method of the system has the advantages of wider frequency range and simple operation, which has great potential applications in ultrasonic devices.

Extraordinary Acoustic Transmission in a Helmholtz Resonance Cavity-Constructed Acoustic Grating

We investigate both experimentally and numerically a complex structure, where ＇face-to-face＇ Helmholtz resonance cavities （HRCs） are introduced to construct a one-dimensional acoustic grating. In this system, pairs of HRCs can intensely couple with each other in two forms： a bonding state and an anti-bonding state, analogous to the character of hydrogen molecule with two atoms due to the interference of wave functions of sound among the acoustic local-resonating structures. The bonding state is a ＇bright＇ state that interferes with the Fabry-Pbrot resonance mode, thereby causing this state to break up into two modes as the splitting of the extraordinary acoustic transmission peak. On the contrary, the anti-bonding state is a ＇dark＇ state in which the resonance mode remains entirely localized within the HRCs, and has no contribution to the acoustic transmission.

Analyzing the Location of the Transmission Windows in Phase-shifted Fiber Grating

Using the matrix approach,we analyzed the relation between the location of the transmission in stop band and the phase shift,and discussed the problem of varying the bandwidth of the transmission window.These theoretical results in this paper have important significance for actual application of the phase-shifted fiber grating.

Highly Angular Tolerant Transmission Filters for Narrow-Band Image Sensors

A dielectric transmittance filter composed of subwavelength grating sandwiched between two few-layers distributed Bragg reflectors (DBRs) is proposed with the aim of being compatible with CMOS technology and to be tunable by lithographic means of the grating pattern without the need of thickness changes, in the broad spirit of metamaterials. The DBR mirrors form a Fabry-Perot (FP) cavity whose resonant frequency can be tuned by changing the effective refractive index of the cavity, here, by tailoring the in-plane filling factor of the grating. The structure has been studied and designed by performing numerical simulations using Fourier Modal Method (FMM). This filter proves to have high broad angular tolerance up to ±30˚. This feature is crucial for evaluating the spectral performance of narrow-band filters especially the so-called Ambient light sensors (ALS). By analyzing the transmittance spectral distributions in the band diagram, it is found that the angular tolerance is due to coupling between the FP and the guided mode inside the cavity in analogy to resonances occurring within multimode periodic waveguides in a different context.

Analysis of Optical Signal Transmission Characteristics in AWG Multi/Demultiplexer with Electromagnetic Field Theory

Based on the electromagnetic field theory, the optical signal transmission characteristics in input/output waveguides, slab waveguides and arrayed waveguides of the arrayed waveguide grating (AWG) multi/demultiplexer are analyzed. The relationship between the physical parameters such as geometry sizes and relative refractive index in AWG multi/demultiplexer and the optical signal transmission characteristics are discussed. This theoretical study can be used for optimizing the design and improving the performance of the AWG multi/demultiplexer.