Effect of compression ratio on microstructure evolution of Mg−10%Al−1%Zn−1%Si alloy prepared by SIMA process

A new Mg−10%Al−1%Zn−1%Si alloy with non-dendritic microstructure was prepared by strain induced melt activation(SIMA)process.The effect of compression ratio on the evolution of semisolid microstructure of the experimental alloy was investigated.The results indicate that the average size ofα-Mg grains decreases and spheroidizing tendency becomes more obvious with the compression ratios increasing from 0 to 40%.In addition,the eutectic Mg2Si phase in the Mg−10%Al−1%Zn−1%Si alloy transforms completely from the initial fishbone shape to globular shape by SIMA process.With the increasing of compression ratio,the morphology and average size of Mg2Si phases do not change obviously.The morphology modification mechanism of Mg2Si phase in Mg−10%Al−1%Zn−1%Si alloy by SIMA process was also studied.

Influence of Si Contents on the Microstructure Evolution and Mechanical Properties of Al-Mg-Si-Cu-Zn Alloys

The influence of different Si contents on the microstructure evolution and mechanical properties of Al⁃Mg⁃Si⁃Cu⁃Zn alloys was systematically studied using tensile testing,OM,SEM,EDS,and EBSD.The results indicate that the grain size of as⁃cast alloys was gradually reduced with the increase of the Si content,which mainly resulted from the formation of many iron⁃rich phases and precipitates during the casting process.During homogenization treatment,the plate⁃likeβ⁃AlFeSi phases in the alloy with a higher Si content easily transformed to the sphericalα⁃Al(FeMn)Si phases,which is helpful for improving the formability of alloys.The microstructure evolution of the alloys was also greatly dependent on the content of Si that the number density and homogeneous distribution level of precipitates in the final cold rolled alloys both increased with the increase of the Si content,which further provided a positive effect on the formation of fine recrystallization grains during the subsequent solution treatment.As a result,the yield strength,ultimate tensile strength,and elongation of the pre⁃aged alloys in the direction of 45°with respect to the rolling direction were all increased with increasing Si content.

Interface reaction of high-strength low-alloy steel with Al-43.4Zn-1.6Si(wt.%)metallic coating

The microstructure,elemental distribution,phase composition,and thickness of intermetallic layers between high-strength low-alloy steel(H420)/mild carbon steel(DC51)and Al–43.4Zn–1.6Si(wt.%)(galvalume,GL)alloy were comparatively investigated.The experimental results reveal that the interfacial reaction layer was composed of Fe2Al5,Fe4Al13,and Al8Fe2Si intermetallic compounds.Moreover,the growth curves of the Fe2Al5 and Fe4Al13 intermetallic layers fit the parabolic law well,and the total thickness of the intermetallic layers of H420+GL was almost the same as that of DC51+GL.However,the thickness of the Fe2Al5 layer in H420+GL was thinner than that in DC51+GL.In addition,first-principle calculations were performed to explore the effect of Mn on the growth of the Fe2Al5 intermetallic phase,and the results indicate that Mn substitution in Fe2Al5 removes electronic charge from the Al atoms,thus decreasing the thickness of the Fe2Al5 interface layer.