Absorption Capability Comparison of Two Kinds of Super Absorbent Resins from Carboxymethyl Cellulose

The two kinds of super absorbent resins from carboxymethyl cellulose were synthesized with the potassium persulphate and methylenebisacrylamide as initiator and cross linker respectively by radical polymerization in aqueous solution. Thestructures of the two resins were characterized with Fourier transform infrared spectroscopy FTIR, scanning electron miscroscopy （SEM）, and environment scanning electron miscroscopy （ESEM）, the results indicate that the fibriform of the carboxymethyl cellulose （CMC） is disappeared and the crusslink networks in eopolymer of carboxymethyl cellulose-graft-polyacrylic acid（CMC-g-PAA） are denser than that of eopolymer of carboxymethyl cellulose-graft-poly （acrylic acid-co-N-vinyl Pyrrolidone） （CMC-g- PAA-co-PVP）. The comparison between the two resins in absorption capacities is that CMC-g-PAA is better in the water-keep capability being heated, while CMC-g-PAA-co-PVP is better in the water absorbency and salt resistance.

Ballistic performance of spaced multi-ply soft fabrics: Experimental and numerical investigation

It has been reported that the ply gap influences the ballistic resistance of spaced multi-ply fabric systems,but its working mechanism was not well-understood. This paper reports the experimental and numerical approaches and results of an investigation on the mechanisms that enable the improved ballistic performance of spaced multi-ply systems. Penetration tests were performed over a range of impact velocities ranging from 200 m/s to 400 m/s. The results confirmed that the ply gap is beneficial to the energy absorption capability of the systems. This is because the front plies tend to absorb more energy when they are not immediately constrained by the rear plies. During a ballistic event, the gap relieves the reflection of the compressive pulse, prolonging the projectile engagement time with the front plies;on the other hand, the rear plies become increasingly less active in dissipating energy as the gap increases.When the gap is sufficiently widened to avoid any interference between the plies before the failure of the front ply, the responses of the whole system no longer vary. It was also found that the ballistic performance of the spaced systems is influenced by ply thickness, impact velocity, and the stacking order of the ply gap.

Absorption of Arsenite on Several Iron (Hydro-)Oxides and Impact from Pre-processing Methods

The absorption reactions of arsenite on Fe （hydro-）oxides are studied. The three absorbent types are Fe（OH）3 gel and two Fe （hydro-）oxides, in which the Fe（OH）3 gel was dried in a microwave oven under vacuum at 80℃. It is found that pH changes from 9.71 to 10.36 in 6 minutes after the Fe （OH）3 gel was mixed with NaAsO2 solution, as the arsenite replaces the OH- in goethite and Fe（OH）3. At the 40th minute after the start of the reaction, pH decreases, which is most probably because that the monodentate surface complex of absorbed arsenite has changed into mononuclear-bidentate complex and released proton. The decline in pH values indicates not the end of the absorption but a change in the reaction type. Temperature and dissolved gas has little effect on these two types of reactions. The total absorption of arsenite increases after the absorbent is irradiated with ultrasound, which also lead to difficulty in separating the solids from solution. The absorption capacity for arsenite of Fe（OH）3 gel dried in a microwave oven under vacuum is 53.18% and 17.22% respectively better than that of Fe （OH）3 gel and gel dried at 80℃. The possible reasons are that the water molecules in the gel vibrates with high frequency under the effect of microwave irradiation, thereby producing higher porosity and improved surface activity.