Fuzzy Sliding Mode Active Disturbance Rejection Control of an Autonomous Underwater Vehicle-Manipulator System

In this paper, a fuzzy sliding mode active disturbance rejection control(FSMADRC) scheme is proposed for an autonomous underwater vehicle-manipulator system(AUVMS) with a two-link and three-joint manipulator. First, the AUVMS is separated into nine subsystems, and the combined effects of dynamic uncertainties, hydrodynamic force, unknown disturbances, and nonlinear coupling terms on each subsystem are lumped into a single total disturbance. Next, a linear extended state observer(LESO) is presented to estimate the total disturbance. Then, a sliding mode active disturbance rejection control(SMADRC) scheme is proposed to enhance the robustness of the control system. The stability of the SMADRC and the estimation errors of the LESO are analyzed. Because it is difficult to simultaneously adjust several parameters for a LESO-based SMADRC scheme, a fuzzy logic control(FLC) scheme is used to formulate the FSMADRC to determine the appropriate parameters adaptively for practical applications. Finally, two AUVMS tasks are illustrated to test the trajectory tracking performance of the closed-loop system and its ability to reject and attenuate the total disturbance. The simulation results show that the proposed FSMADRC scheme achieves better performance and consume less energy than conventional PID and FLC techniques.

Researches on active structural acoustic control by radiation modes

Based on the radiation modes, an active control strategy is presented for sound radiation from elastic structures with an example of simply supported rectangular panel. The physical characteristics and mathematical meaning of the radiation modes are analyzed. The radiation efficiency of radiation mode falls off very rapidly with the increase of modes order at low frequency. A new control strategy is developed in which by canceling the adjoint coef- ficient of the first k radiation modes, the sound powers of the first k radiation modes is zero theoratically. The numerical calculation is made by using point force actuators as control forces.

Development of a Hand Exoskeleton System for Index Finger Rehabilitation

In order to overcome the drawbacks of traditional rehabilitation method,the robot-aided rehabilitation has been widely investigated for the recent years.And the hand rehabilitation robot,as one of the hot research fields,remains many challenging issues to be investigated.This paper presents a new hand exoskeleton system with some novel characteristics.Firstly,both active and passive rehabilitative motions are realized.Secondly,the device is elaborately designed and brings advantages in many aspects.For example,joint motion is accomplished by a parallelogram mechanism and high level motion control is therefore made very simple without the need of complicated kinematics.The adjustable joint limit design ensures that the actual joint angles don＇t exceed the joint range of motion（ROM） and thus the patient safety is guaranteed.This design can fit to the different patients with different joint ROM as well as to the dynamically changing ROM for individual patient.The device can also accommodate to some extent variety of hand sizes.Thirdly,the proposed control strategy simultaneously realizes the position control and force control with the motor driver which only works in force control mode.Meanwhile,the system resistance compensation is preliminary realized and the resisting force is effectively reduced.Some experiments were conducted to verify the proposed system.Experimentally collected data show that the achieved ROM is close to that of a healthy hand and the range of phalange length（ROPL） covers the size of a typical hand,satisfying the size need of regular hand rehabilitation.In order to evaluate the performance when it works as a haptic device in active mode,the equivalent moment of inertia（MOI） of the device was calculated.The results prove that the device has low inertia which is critical in order to obtain good backdrivability.The experiments also show that in the active mode the virtual interactive force is successfully feedback to the finger and the resistance is reduced by one-third;for the passive control mode,the desired trajectory is realized satisfactorily.