Reliability analysis on civil engineering project based on integrated adaptive simulation annealing and gray correlation method

Dynamic reliability is a very important issue in reliability research. The dynamic reliability analysis for the project is still in search of domestic and international research in the exploration stage. By now, dynamic reliability research mainly concentrates on the reliability assessment; the methods mainly include dynamic fault tree, extension of event sequence diagram and Monte Carlo simulation, and et al. The paper aims to research the dynamic reliability optimization. On the basis of analysis of the four quality influence factors in the construction engineering, a method based on gray correlation degree is employed to calculate the weights of factors affecting construction process quality. Then the weights are added into the reliability improvement feasible index （RIFI）. Furthermore, a novel nonlinear programming mathematic optimization model is established. In the Insight software environment, the Adaptive Simulated Annealing （ASA） algorithm is used to get a more accurate construction subsystem optimal reliability under different RIFI conditions. In addition, the relationship between construction quality and construction system reliability is analyzed, the proposed methods and detailed processing can offer a useful reference for improving the construction system quality level.

Test selection and optimization for PHM based on failure evolution mechanism model

The test selection and optimization （TSO） can improve the abilities of fault diagnosis, prognosis and health-state evalua- tion for prognostics and health management （PHM） systems. Traditionally, TSO mainly focuses on fault detection and isolation, but they cannot provide an effective guide for the design for testability （DFT） to improve the PHM performance level. To solve the problem, a model of TSO for PHM systems is proposed. Firstly, through integrating the characteristics of fault severity and propa- gation time, and analyzing the test timing and sensitivity, a testability model based on failure evolution mechanism model （FEMM） for PHM systems is built up. This model describes the fault evolution- test dependency using the fault-symptom parameter matrix and symptom parameter-test matrix. Secondly, a novel method of in- herent testability analysis for PHM systems is developed based on the above information. Having completed the analysis, a TSO model, whose objective is to maximize fault trackability and mini- mize the test cost, is proposed through inherent testability analysis results, and an adaptive simulated annealing genetic algorithm （ASAGA） is introduced to solve the TSO problem. Finally, a case of a centrifugal pump system is used to verify the feasibility and effectiveness of the proposed models and methods. The results show that the proposed technology is important for PHM systems to select and optimize the test set in order to improve their performance level.

Design of Water Network with Multiple Contaminants and Zero Discharge

The paper presents a procedure to design water network. First of all, water reuse system, water regeneration reuse system (including regeneration recycle) and wastewater treatment system are designed separately. But the interaction between different parts demands that each part is designed iteratively to optimize the whole water network. Therefore, on the basis of the separated design a water netvrork superstructure including reuse, regeneration and wastewater treatment is established from the system engineering point of view. And a multi-objective adaptive simulated annealing genetic algorithm is adopted to simultaneously integrate the overall water netvrork to balance the economic and environmental effects. The algorithm overcomes the defect of local optimum of simulated annealing (SA), avoids the pre-maturation of genetic algorithm (GA) and finds a set of solutions (pareto front) in acceptable computer time. Prom the pareto front, a point with minimum fresh water consumption will be extended to zero discharge as our ultimate goal.