High-purity aluminum titanate was synthesized via a water quenching method with waste-residue in the aluminum factory and industrial TiO2 as the main raw materials, which belongs to the comprehensive utilization of so...High-purity aluminum titanate was synthesized via a water quenching method with waste-residue in the aluminum factory and industrial TiO2 as the main raw materials, which belongs to the comprehensive utilization of solid wastes. Compared with the conventional method, it can reduce synthesis temperature, effectively inhibit decomposition and raise the content of AT; the addition of tiny silicon powder can improve the sintering and optimize the properties of AT. The crystalline phase structure and microstructure of each sample were characterized with XRD and SEM methods; the content of each crystalline phase in each sample was confirmed with Rietveld Quantification method; the properties of each sample were also tested. The experimental results showed that No. 4 is the optimum specimen, with the corresponding mass ratio of Al2O3/TiO2 to be 1.27 and the content of AT of 97.2 wt%. The addition of optimum tiny silicon powder is confirmed to be 8wt%; its corresponding bulk density is 2.63 g/cm^3, bending strength is 46.34 MPa, and the retention of one thermal vibration bending strength is 71.5%.展开更多
This article focused on the influences of fulvic acid and humic acid on aluminum speciation in drinking water. Factors including the concentration of residual chlorine and pH value had been concerned. Aluminum species...This article focused on the influences of fulvic acid and humic acid on aluminum speciation in drinking water. Factors including the concentration of residual chlorine and pH value had been concerned. Aluminum species investigated in the experiments included inorganic mononuclear, organic mononuclear, mononuclear, polymer, soluble, and suspended forms. It was found that the effects of fulvic acid and humic acid on aluminum speciation depended mainly on their molecular weight. Fulvic acid with molecular weight less than 5000 Dalton had little influence on aluminum speciation; while fulvic acid with molecular weight larger than 5000 Dalton and humic acid would increase the concentration of soluble aluminum significantly even at concentration below 0.5 mg/L （calculated as TOC）. Aluminum species, in the present of fulvic acid with molecular weight larger than 5000 Dalton and humic acid, were more stable than that in the present of fluvic acid with molecular mass less than 5000 Dalton, and varied little with reaction time. Within pH range 6.5-7.5, soluble aluminum increased notably in water with organic matter. As the concentration of residual chlorine increased, the effects of fulvic acid and humic acid became weak. The reactions between humic acid, fulvic acid with large molecular weight, and aluminum were considered to be a multi-dentate coordination process. With the consideration of aluminum bioavailability, reducing the concentration of fulvic acid and humic acid and keeping the pH value among 6.5-7.5 were recommended during drinking water treatment.展开更多
Effects of aluminum on water distribution system and human health mainly attribute to its speciation in drinking water. Laboratory experiments were performed to investigate factors that may influence aluminum speciati...Effects of aluminum on water distribution system and human health mainly attribute to its speciation in drinking water. Laboratory experiments were performed to investigate factors that may influence aluminum speciation in water supply system. The concentration of soluble aluminum and its transformation among other aluminum species were mainly controlled by kinetics processes of related reactions. Total aluminum concentration had a notable effect on the concentrations of mononuclear and soluble aluminum in the first 4 day; then its effect became weak. At pH above 7.50, both fluoride and orthophosphate had little effect on aluminum speciation; while, when the solution pH was below 7.50, the concentrations of mononuclear and soluble aluminum were proportional to the concentration of fluoride and inversely proportional to the concentration of orthophosphate. Both mononuclear and polynuclear silicic acids could complex with mononuclear aluminum by forming soluble aluminosilicates. In addition, the adding sequence of orthophosphate and aluminum into drinking water would also affect the distribution of aluminum species in the first 4 day. In order to minimize aluminum bioavailability in drinking water, it was suggested that orthophosphate should be added prior to coagulant process, and that the concentrations of fluoride and silicic acids should be controlled below 2.0 and 25 mg/L, respectively, prior to the treatment. The solution pH in coagulation and filtration processes should be controlled in the range of 6.50-7.50.展开更多
A small amount of mineralizer MgO was added into Al2TiO5 synthesized from the sludge of aluminum factory to form Al（2-x）Mg（x＋y）Ti（1-y）O（5-0.5x-y） solid solution and inhibit the decomposition of Al2TiO5 solid ...A small amount of mineralizer MgO was added into Al2TiO5 synthesized from the sludge of aluminum factory to form Al（2-x）Mg（x＋y）Ti（1-y）O（5-0.5x-y） solid solution and inhibit the decomposition of Al2TiO5 solid solution. It increased the content of Al2TiO5 solid solution and improved the thermal stability of materials. In this work,XRD and SEM methods were adopted to characterize the crystalline structure and microstructure of each kind of sample. Rietveld Quantification method was used to determine the content of crystalline phases in each sample. Results show as follows： the optimal addition concentration of MgO was 2.0%,and the corresponding content of Al2TiO5 solid solution which displayed irregular bulk shape was 100%; the addition of mineralizer MgO could enhance the flexural strength and thermal stability of Al2TiO5 solid solution materials. The optimal addition concentration of MgO determined by performance analysis was 2.0%,and its corresponding retention rate of thermal-shock flexural strength was 86.4%. Structure analysis and performance analysis resulted in good accordance.展开更多
基金Supported by the Natural Science Foundation of Fujian Province (No. T0750005)the Science and Technology Developing Foundation of Fuzhou University (No. 2007-XQ-02)
文摘High-purity aluminum titanate was synthesized via a water quenching method with waste-residue in the aluminum factory and industrial TiO2 as the main raw materials, which belongs to the comprehensive utilization of solid wastes. Compared with the conventional method, it can reduce synthesis temperature, effectively inhibit decomposition and raise the content of AT; the addition of tiny silicon powder can improve the sintering and optimize the properties of AT. The crystalline phase structure and microstructure of each sample were characterized with XRD and SEM methods; the content of each crystalline phase in each sample was confirmed with Rietveld Quantification method; the properties of each sample were also tested. The experimental results showed that No. 4 is the optimum specimen, with the corresponding mass ratio of Al2O3/TiO2 to be 1.27 and the content of AT of 97.2 wt%. The addition of optimum tiny silicon powder is confirmed to be 8wt%; its corresponding bulk density is 2.63 g/cm^3, bending strength is 46.34 MPa, and the retention of one thermal vibration bending strength is 71.5%.
基金supported by the National Natural Science Foundation of China (No.50838005)the Changjiang Scholars and Innovative Research Team in University(No.IRT0853)the American Aluminum Foundation
文摘This article focused on the influences of fulvic acid and humic acid on aluminum speciation in drinking water. Factors including the concentration of residual chlorine and pH value had been concerned. Aluminum species investigated in the experiments included inorganic mononuclear, organic mononuclear, mononuclear, polymer, soluble, and suspended forms. It was found that the effects of fulvic acid and humic acid on aluminum speciation depended mainly on their molecular weight. Fulvic acid with molecular weight less than 5000 Dalton had little influence on aluminum speciation; while fulvic acid with molecular weight larger than 5000 Dalton and humic acid would increase the concentration of soluble aluminum significantly even at concentration below 0.5 mg/L （calculated as TOC）. Aluminum species, in the present of fulvic acid with molecular weight larger than 5000 Dalton and humic acid, were more stable than that in the present of fluvic acid with molecular mass less than 5000 Dalton, and varied little with reaction time. Within pH range 6.5-7.5, soluble aluminum increased notably in water with organic matter. As the concentration of residual chlorine increased, the effects of fulvic acid and humic acid became weak. The reactions between humic acid, fulvic acid with large molecular weight, and aluminum were considered to be a multi-dentate coordination process. With the consideration of aluminum bioavailability, reducing the concentration of fulvic acid and humic acid and keeping the pH value among 6.5-7.5 were recommended during drinking water treatment.
基金supported by the National Natural Science Foundation of China (No.50238020)the American Aluminum Foundation
文摘Effects of aluminum on water distribution system and human health mainly attribute to its speciation in drinking water. Laboratory experiments were performed to investigate factors that may influence aluminum speciation in water supply system. The concentration of soluble aluminum and its transformation among other aluminum species were mainly controlled by kinetics processes of related reactions. Total aluminum concentration had a notable effect on the concentrations of mononuclear and soluble aluminum in the first 4 day; then its effect became weak. At pH above 7.50, both fluoride and orthophosphate had little effect on aluminum speciation; while, when the solution pH was below 7.50, the concentrations of mononuclear and soluble aluminum were proportional to the concentration of fluoride and inversely proportional to the concentration of orthophosphate. Both mononuclear and polynuclear silicic acids could complex with mononuclear aluminum by forming soluble aluminosilicates. In addition, the adding sequence of orthophosphate and aluminum into drinking water would also affect the distribution of aluminum species in the first 4 day. In order to minimize aluminum bioavailability in drinking water, it was suggested that orthophosphate should be added prior to coagulant process, and that the concentrations of fluoride and silicic acids should be controlled below 2.0 and 25 mg/L, respectively, prior to the treatment. The solution pH in coagulation and filtration processes should be controlled in the range of 6.50-7.50.
基金supported by the Natural Science Foundation of Fujian Province (No. T08J0129)the Science and Technology Developing Foundation of Fuzhou University (No. 2008-XQ-001)2007-year New Century Talents Supporting Program of Fujian Province (No. XSJRC2007-17)
文摘A small amount of mineralizer MgO was added into Al2TiO5 synthesized from the sludge of aluminum factory to form Al（2-x）Mg（x＋y）Ti（1-y）O（5-0.5x-y） solid solution and inhibit the decomposition of Al2TiO5 solid solution. It increased the content of Al2TiO5 solid solution and improved the thermal stability of materials. In this work,XRD and SEM methods were adopted to characterize the crystalline structure and microstructure of each kind of sample. Rietveld Quantification method was used to determine the content of crystalline phases in each sample. Results show as follows： the optimal addition concentration of MgO was 2.0%,and the corresponding content of Al2TiO5 solid solution which displayed irregular bulk shape was 100%; the addition of mineralizer MgO could enhance the flexural strength and thermal stability of Al2TiO5 solid solution materials. The optimal addition concentration of MgO determined by performance analysis was 2.0%,and its corresponding retention rate of thermal-shock flexural strength was 86.4%. Structure analysis and performance analysis resulted in good accordance.
