The aim of this work was to describe the conversion of raw phosphogypsum, issued from the manufacture of H3PO4 by dissolving the phosphate rock in H2SO4, into (NH4)2SO4 and CaCO3.The thermal analysis technique was us...The aim of this work was to describe the conversion of raw phosphogypsum, issued from the manufacture of H3PO4 by dissolving the phosphate rock in H2SO4, into (NH4)2SO4 and CaCO3.The thermal analysis technique was used to estimate the yield of conversion. (NH4)2CO3 or (NH4)2CO3 with excess NH4OH or (NH4)2CO3 with NH3 gas were used in the preparation of (NH4)2SO4 from phosphogypsum. The obtained samples were separated and tested by chemical and thermogravimetric analyses, infrared spectrum and X-ray diffraction and the optimum conditions of conversion were determined. The results indicated that the yield of conversion equals to 83.37 and 86.70% in case of using (NH4)2CO3 or (NH4)2CO3 with excess ammoniarespectively, while by using NH3 gas the percentage of conversion increased to 94.2% at a flow rate of 6 ml/min. Chemical analysis, infrared spectrum and X-ray diffraction patterns of the yield, (NH4)2SO4 were nearly similar to the standard sample.展开更多
Supported γ-Al2O3 membranes without defects were prepared by the sol-gel procedure. The sol-gel method involved peptization of a boehmite (AlOOH) sol prepared from ammonium aluminium sulphate. The morphology of the s...Supported γ-Al2O3 membranes without defects were prepared by the sol-gel procedure. The sol-gel method involved peptization of a boehmite (AlOOH) sol prepared from ammonium aluminium sulphate. The morphology of the supported membranes was characterized by scanning electron microscopy (SEM) and 3D rotational microscopy. Furthermore, the effects of different preparing conditions on morphological characteristics of the membrane were also investigated. The results show that PVA is a good crack-preventing agent and the morphology of supported membranes is affected by many factors, such as Al2O3 and PVA contents of the sol, drying and sintering procedures and intrinsic defects on the substrate surface.展开更多
The acute toxic effects of ammonium sulphate to fresh-water catfish, Heteropneustes fossilis (H.fossilis) have been studied by determining LC50 values with 95% confidence limits, by the graphic method, the logistic me...The acute toxic effects of ammonium sulphate to fresh-water catfish, Heteropneustes fossilis (H.fossilis) have been studied by determining LC50 values with 95% confidence limits, by the graphic method, the logistic method, the Spearman and Karber method and the trimmed Spearman-Karber method. The trimmed Spearman-Karber method was found the most ideal for ammonium salt toxicity test. The flaws in the trimmed Spearman-Karber method are also discussed.展开更多
Biogas production generates digested slurry as a byproduct. It can be used as a fertilizer especially after its conversion into digested liquid. A pot based study was conducted in order to evaluate the effect of the a...Biogas production generates digested slurry as a byproduct. It can be used as a fertilizer especially after its conversion into digested liquid. A pot based study was conducted in order to evaluate the effect of the application of digested liquid on CH4 and N2O flux, and plant biomass in paddy. Analysis revealed that digested liquid treated soils released more CH4 compared to ammonium sulphate and the control. Ammonium sulphate treated soil emitted the highest N20 whereas digested liquid application decreased its emission significantly. Further, the cumulative emission over 101 d of the experiment was found to be higher for CHa （16.9 to 29.9 g m^-2） compared to N20 （-49.3 to 18.9 mg m^-2） for all treatments. Digested liquid application had positive impact on plant variables such as panicle number and weight of panicles. This study suggests that digested liquid application significantly decrease N20 emission and increase CH4 emission possibly due to affecting the availability of organic C in the soil to microbial activity for methanogenesis. Another possibility for enhancing CH4 emission by following biogas digested liquid could be attributed to the increase in plant biomass.展开更多
In this study, a new method of synthesis of polyethylene glycol supported potassium tribromide （PEG KBr3） and its application in acylation and bromination reactions are reported. Ammonium persulphate oxidizes I（Br ...In this study, a new method of synthesis of polyethylene glycol supported potassium tribromide （PEG KBr3） and its application in acylation and bromination reactions are reported. Ammonium persulphate oxidizes I（Br to the corresponding tribromide which is entrapped by polyethylene glycol leading to stable PEG KBr3. The reagent is proved to be highly efficient for the acylation of variety of alcohols and bromination of activated aromatic substrates. The method is a mild, one pot reaction and involves no use of toxic reagents.展开更多
Alumina membranes without pinholes and cracks were prepared by the sol-gel process using anunordum aluminium sulphate as the starting material. The effects of different preparing conditions on morphology characteristi...Alumina membranes without pinholes and cracks were prepared by the sol-gel process using anunordum aluminium sulphate as the starting material. The effects of different preparing conditions on morphology characteristics of the membrane were investigated by scanning electron microscopy and 3D rotational microscopy. The preparing conditions include the amounts of drying control chemical additives （DCCA）, sintering procedure and sol-gel concentration. The results showed that PVA is a good crack-preventing reagent and the morphology of supported membranes was affected by ninny factors, including Al2O3 concentration, PVA/Al2O3 ratio, heating rate, membrane thickness and intrinsic defects of the substrate surface.展开更多
The addition of a hardener is necessary for the curing of urea-formaldehyde (UF) adhesives in the production of MDF and particleboard. The most commonly used hardener, ammonium chloride, however, is suspected to cause...The addition of a hardener is necessary for the curing of urea-formaldehyde (UF) adhesives in the production of MDF and particleboard. The most commonly used hardener, ammonium chloride, however, is suspected to cause the formation of poisonous dioxin when waste boards are combusted and hence considered as a potential source of pollution. To assess the feasibility of substituting ammonium sulphate for ammonium chloride, working properties and bonding strength were measured for UF adhesives with the two ...展开更多
文摘The aim of this work was to describe the conversion of raw phosphogypsum, issued from the manufacture of H3PO4 by dissolving the phosphate rock in H2SO4, into (NH4)2SO4 and CaCO3.The thermal analysis technique was used to estimate the yield of conversion. (NH4)2CO3 or (NH4)2CO3 with excess NH4OH or (NH4)2CO3 with NH3 gas were used in the preparation of (NH4)2SO4 from phosphogypsum. The obtained samples were separated and tested by chemical and thermogravimetric analyses, infrared spectrum and X-ray diffraction and the optimum conditions of conversion were determined. The results indicated that the yield of conversion equals to 83.37 and 86.70% in case of using (NH4)2CO3 or (NH4)2CO3 with excess ammoniarespectively, while by using NH3 gas the percentage of conversion increased to 94.2% at a flow rate of 6 ml/min. Chemical analysis, infrared spectrum and X-ray diffraction patterns of the yield, (NH4)2SO4 were nearly similar to the standard sample.
基金the National Natural Science Foundation of China (NSFC 20503015)
文摘Supported γ-Al2O3 membranes without defects were prepared by the sol-gel procedure. The sol-gel method involved peptization of a boehmite (AlOOH) sol prepared from ammonium aluminium sulphate. The morphology of the supported membranes was characterized by scanning electron microscopy (SEM) and 3D rotational microscopy. Furthermore, the effects of different preparing conditions on morphological characteristics of the membrane were also investigated. The results show that PVA is a good crack-preventing agent and the morphology of supported membranes is affected by many factors, such as Al2O3 and PVA contents of the sol, drying and sintering procedures and intrinsic defects on the substrate surface.
文摘The acute toxic effects of ammonium sulphate to fresh-water catfish, Heteropneustes fossilis (H.fossilis) have been studied by determining LC50 values with 95% confidence limits, by the graphic method, the logistic method, the Spearman and Karber method and the trimmed Spearman-Karber method. The trimmed Spearman-Karber method was found the most ideal for ammonium salt toxicity test. The flaws in the trimmed Spearman-Karber method are also discussed.
文摘Biogas production generates digested slurry as a byproduct. It can be used as a fertilizer especially after its conversion into digested liquid. A pot based study was conducted in order to evaluate the effect of the application of digested liquid on CH4 and N2O flux, and plant biomass in paddy. Analysis revealed that digested liquid treated soils released more CH4 compared to ammonium sulphate and the control. Ammonium sulphate treated soil emitted the highest N20 whereas digested liquid application decreased its emission significantly. Further, the cumulative emission over 101 d of the experiment was found to be higher for CHa （16.9 to 29.9 g m^-2） compared to N20 （-49.3 to 18.9 mg m^-2） for all treatments. Digested liquid application had positive impact on plant variables such as panicle number and weight of panicles. This study suggests that digested liquid application significantly decrease N20 emission and increase CH4 emission possibly due to affecting the availability of organic C in the soil to microbial activity for methanogenesis. Another possibility for enhancing CH4 emission by following biogas digested liquid could be attributed to the increase in plant biomass.
基金the Department of Science and Technology,DST,New Delhi,India,for fnancial assistance received through a SERC fast track project(No.SR/FTP/CS-100/2007)
文摘In this study, a new method of synthesis of polyethylene glycol supported potassium tribromide （PEG KBr3） and its application in acylation and bromination reactions are reported. Ammonium persulphate oxidizes I（Br to the corresponding tribromide which is entrapped by polyethylene glycol leading to stable PEG KBr3. The reagent is proved to be highly efficient for the acylation of variety of alcohols and bromination of activated aromatic substrates. The method is a mild, one pot reaction and involves no use of toxic reagents.
基金Project supported by National Natural Science Foundation ofChina (Grant No .20373040) Science Foundation of Science andTechnology Commission of Zhejiang Province ( Grant No .0252nm101) Science Foundation of Shanghai MunicipalCommission of Science and Technology (Grant No .0452nm019)
文摘Alumina membranes without pinholes and cracks were prepared by the sol-gel process using anunordum aluminium sulphate as the starting material. The effects of different preparing conditions on morphology characteristics of the membrane were investigated by scanning electron microscopy and 3D rotational microscopy. The preparing conditions include the amounts of drying control chemical additives （DCCA）, sintering procedure and sol-gel concentration. The results showed that PVA is a good crack-preventing reagent and the morphology of supported membranes was affected by ninny factors, including Al2O3 concentration, PVA/Al2O3 ratio, heating rate, membrane thickness and intrinsic defects of the substrate surface.
文摘The addition of a hardener is necessary for the curing of urea-formaldehyde (UF) adhesives in the production of MDF and particleboard. The most commonly used hardener, ammonium chloride, however, is suspected to cause the formation of poisonous dioxin when waste boards are combusted and hence considered as a potential source of pollution. To assess the feasibility of substituting ammonium sulphate for ammonium chloride, working properties and bonding strength were measured for UF adhesives with the two ...
