Petro-chemical wastewater treatment by biological process

In order to study the feasibility of treating petro chemical wastewater by the combination of anaerobic and aerobic biological process, a research of treating wastewater in UASB reactor and aeration basin has been conducted. The test results shows that under moderate temperature, with 5\^2 kgCOD/(m\+3·d) volumetric load of COD Cr in the UASB reactor and 24h of HRT, 85% removal rate of BOD 5 and 83% of COD \{Cr\} and 1\^34 m\+3/(m\+3·d) volumetric gas production rate can be obtained respectively. The aerobic bio degradability can be increased by 20%—30% after the petro chemical wastewater has been treated by anaerobic process. As Ns=0\^45 kgCOD/(kgMLSS·d), HRT=4h in the aeration tank, 94% removal rate of BOD 5, 93% of COD \{Cr\}, 98\^8% total removal rate of COD \{Cr\} and 99% removal rate of BOD 5 can be reached.

Removal of nitrogen and phosphorus in a combined A^2/O-BAF system with a short aerobic SRT

A bench-scale anaerobic/anoxic/aerobic process-biological aerated filter （A^2/O-BAF） combined system was carded out to treat wastewater with lower C/N and C/P ratios. The A^2/O process was operated in a short aerobic sludge retention time （SRT） for organic pollutants and phosphorus removal, and denitrification. The subsequent BAF process was mainly used for nitrification. The BAF effluent was partially returned to anoxic zone of the A^2/O process to provide electron acceptors for denitrification and anoxic P uptake. This unique system formed an environment for reproducing the denitdfying phosphate-accumulating organisms （DPAOs）. The ratio of DPAOs to phosphorus accumulating organisms （PAOs） could be maintained at 28% by optimizing the organic loads in the anaerobic zone and the nitrate loads into the anoxic zone in the A^2/O process. The aerobic phosphorus over-uptake and discharge of excess activated sludge was the main mechanism of phosphorus removal in the combined system. The aerobic SRT of the A^2/O process should meet the demands for the development of aerobic PAOs and the restraint on the nitrifiers growth, and the contact time in the aerobic zone of the A^2/O process should be longer than 30 min, which ensured efficient phosphorus removal in the combined system. The adequate BAF effluent return rates should be controlled with 1--4 mg/L nitrate nitrogen in the anoxic zone effluent of A^2/O process to achieve the optimal nitrogen and phosphorus removal efficiencies.

Elucidating the removal mechanism of N,N-dimethyldithiocarbamate in an anaerobic-anoxic-oxic activated sludge system

N,N-Dimethyldithiocarbamate （DMDTC） is a typical precursor of N-nitrosodimethylamine （NDMA）. Based on separate hydrolysis, sorption and biodegradation studies of DMDTC, a laboratory-scale anaerobic-anoxic-oxic （AAO） system was established to investigate the removal mechanism of DMDTC in this nutrient removal biological treatment system. DMDTC hydrolyzed easily in water solution under either acidic conditions or strong alkaline conditions, and dimethylamine （DMA） was the main hydrolysate. Under anaerobic, anoxic or oxic conditions, DMDTC was biodegraded and completely mineralized. Furthermore, DMA was the main intermediate in DMDTC biodegradation. In the AAO system, the optimal conditions for both nutrient and DMDTC removal were hydraulic retention time 8 hr, sludge retention time 20 day, mixed-liquor return ratio 3：1 and sludge return ratio 1：1. Under these conditions, the removal efficiency of DMDTC reached 99.5%; the removal efficiencies of chemical organic demand, ammonium nitrogen, total nitrogen and total phosphorus were 90%, 98%, 81% and 93%, respectively. Biodegradation is the dominant mechanism for DMDTC removal in the AAO system, which was elucidated as consisting of two steps： first, DMDTC is transformed to DMA in the anaerobic and anoxic units, and then DMA is mineralized to CO2 and NH3 in the anoxic and oxic units. The mineralization of DMDTC in the biological treatment system can effectively avoid the formation of NDMA during subsequent disinfection processes.