This paper studies the attached sheet cavitation in centrifugal pumps. A pump casted from Perspex is used as the test subject. The cavitation bubbles were observed in the entrance of the impeller and the drops of the ...This paper studies the attached sheet cavitation in centrifugal pumps. A pump casted from Perspex is used as the test subject. The cavitation bubbles were observed in the entrance of the impeller and the drops of the head coefficients were measured under different operating conditions. A Filter-Based Model （FBM）, derived from the RNG k-e model, and a modified Zwart model are adopted in the numerical predictions of the unsteady cavitating flows in the pump. The simulations are carded out and the results are compared with experimental results for 3 different flow coefficients, from 0.077 to 0.114. Under four operating conditions, qualitative comparisons are made between experimental and numerical cavitation patterns, as visualized by a high-speed camera and described as isosurfaces of the vapour volume fraction ctv = 0.1. It is shown that the simulation can truly represent the development of the attached sheet cavitation in the impeller. At the same time, the curves for the drops of the head coefficients obtained from experiments and calculations are also quantitatively compared, which shows that the decline of the head coefficients at every flow coefficient is correctly captured, and the prediction accuracy is high. In addition, the detailed analysis is made on the vapour volume fraction contours on the plane of span is 0.5 and the loading distributions around the blade section at the midspan. It is shown that the FBM model and the modified Zwart model are effective for the numerical simulation of the cavitating flow in centrifugal pumps. The analysis results can also be used as the basis for the further research of the attached sheet cavitation and the improvement of centrifugal pumps.展开更多
基金supported by the National Natural Science Funds for Distinguished Young Scholar (Grant No. 50825902)the Natural Science Foundation of Jiangsu Province (Grant Nos.51239005, 51179075)
文摘This paper studies the attached sheet cavitation in centrifugal pumps. A pump casted from Perspex is used as the test subject. The cavitation bubbles were observed in the entrance of the impeller and the drops of the head coefficients were measured under different operating conditions. A Filter-Based Model （FBM）, derived from the RNG k-e model, and a modified Zwart model are adopted in the numerical predictions of the unsteady cavitating flows in the pump. The simulations are carded out and the results are compared with experimental results for 3 different flow coefficients, from 0.077 to 0.114. Under four operating conditions, qualitative comparisons are made between experimental and numerical cavitation patterns, as visualized by a high-speed camera and described as isosurfaces of the vapour volume fraction ctv = 0.1. It is shown that the simulation can truly represent the development of the attached sheet cavitation in the impeller. At the same time, the curves for the drops of the head coefficients obtained from experiments and calculations are also quantitatively compared, which shows that the decline of the head coefficients at every flow coefficient is correctly captured, and the prediction accuracy is high. In addition, the detailed analysis is made on the vapour volume fraction contours on the plane of span is 0.5 and the loading distributions around the blade section at the midspan. It is shown that the FBM model and the modified Zwart model are effective for the numerical simulation of the cavitating flow in centrifugal pumps. The analysis results can also be used as the basis for the further research of the attached sheet cavitation and the improvement of centrifugal pumps.
