EFFECT OF AUSTENITIC DENDRITES ON MECHANICAL PROPERTIES OF DUCTILE IRON

Impact toughness of ductile nodular cast iron loaded perpendicular to the austenitic dendrites is found to be 43% higher than that parallel to ones.Yet tensile strength and elongation of the former are 23% and 30% lower than the later respectively.It is belived that the dendritic segregation may cause such differences.

New developments in high quality grey cast irons

The paper reviews original data obtained by the present authors,revealed in recent separate publications,describing specific procedures for high quality grey irons,and reflecting the forecast needs of the worldwide iron foundry industry.High power,medium frequency coreless induction furnaces are commonly used in electric melting grey iron foundries.This has resulted in low sulphur(<0.05wt.%)and aluminium(<0.005wt.%)contents in the iron,with a potential for higher superheating(>1,500°C),contributing to unfavourable conditions for graphite nucleation.Thin wall castings are increasingly produced by these electric melt shops with a risk of greater eutectic undercooling during solidification.The paper focused on two groups of grey cast irons and their specific problems:carbides and graphite morphology control in lower carbon equivalent high strength irons(CE=3.4%-3.8%),and austenite dendrite promotion in eutectic and slightly hypereutectic irons(CE=4.1%-4.5%),in order to increase their strength characteristics.There are 3 stages and 3 steps involving graphite formation,iron chemistry and iron processing that appear to be important.The concept in the present paper sustains a threestage model for nucleating flake graphite[(Mn,X)S type nuclei].There are three important groups of elements(deoxidizer,Mn/S,and inoculant)and three technological stages in electric melting of iron(superheat,pre-conditioning of base iron,final inoculation).Attention is drawn to a control factor(%Mn)x(%S)ensuring it equals to 0.03–0.06,accompanied by 0.005wt.%–0.010wt.%Al and/or Zr content in inoculated irons.It was found that iron powder addition promotes austenite dendrite formation in eutectic and slightly eutectic,acting as reinforcement for the eutectic cells.But,there is an accompanying possible negative influence on the characteristics of the(Mn,X)S type graphite nuclei(change the morphology of nuclei from polygonal compact to irregular polygonal,and therefore promote chill tendency in treated irons).A double addition(iron powder+inoculant)appears to be an effective treatment to benefit both austenite and graphite nucleation,with positive effects on the final structure and chill tendency.

Formation mechanism of bimetal composite layer between LCS and HCCI

A low carbon steel(LCS)/high chromium white cast iron(HCCI) bimetal wear plate about 20 mm in thickness was prepared by liquid-liquid bimetal composite casting technology to substitute for the welding wear plate. A clear and distinguishable composite layer between the LCS and the HCCI was detected with SEM, and the composition and phase were analyzed through EDS and XRD. The composite layer was composed of three sublayers from the LCS to the HCCI: pearlite transition layer, composite layer, and HCCI transition layer. The Vickers hardness from the pearlite transition layer to the HCCI transition layer was 360 HV to 855 HV. The austenite grows as dendrites between the composite layer and the HCCI transition layer under constitutional undercooling. A large amount of C and Cr, and a small amount of Si and Mn dissolve in the matrix. Granular Cr_7C_3 is uniformly distributed. Due to the solute redistribution at the solid-liquid interface, the primary austenite grows from planar to cellular and finally to the distinct dendrite crystals. The dendrite crystals have an obvious growth direction perpendicular to the composite layer.