Electrochemical Detection of Clenbuterol in Pig Liver at Pyrrole DNA Modified Boron-doped Diamond Electrode

The direct detection of clenbuterol（CL） in pig liver without any extraction separation at a pyrrole-DNA modified boron-doped diamond（BDD） electrode is reported. The pyrrole-DNA modified BDD electrode has a strong electrocatalytic effect on the redox reaction of CL. One oxidization and two reduction peaks of CL appear at 340. 2, 299. 8 and 166. 6 mV（ versus SCE）, respectively. The pyrrole polymer alone cannot electrocatalyze the above reaction at a BDD electrode ; the electrocatalytic effect of a BDD electrode modified with DNA membrane is unsufficient for the analytical detection of CL; the replacement of boron-doped diamond by glass carbon makes the electrocatalytic reaction impossible ; the redox process is pH dependent. The influences of various experimental parameters on the pyrrole-DNA modified BDD electrode were investigated. A sensitive cyclic vohammetric response for CL was obtained in a linear range from 3.4 × 10^-6 to 5 × 10^ -4 mol/L with a detection limit of 8.5 × 10^-7 mol/L. A mean recovery of 102. 7% of CL in the pig liver sample solution and a reproducibility of 3.2% were obtained.

Electroanalytical Investigation on Paracetamol on Boron-Doped Diamond Electrode by Voltammetry

An electroanalytical method was developed for the direct quantitative determination of paracetamol in tablets based on its oxidation behavior. The electrochemical oxidation and determination of paracetamol were easily carried out on born-doped diamond (BDD) electrode using two voltammetric techniques (CV and DPV). The electrochemical measurements performed by cyclic voltammetric (CV) and differential pulse voltammetry (DPV) techniques were carried out using a cathodically pretreated boron-doped diamond electrode in HClO4 and KClO4 electrolytes. HClO4 was then selected for analytical purposes and scan rate studies were also completed. The oxidation of the paracetamol is found to be irreversible and a diffusion-controlled nature of the paracetamol oxidation peak was established. A linear calibration curve for DPV analysis was constructed in the paracetamol concentration range from 0 μM to 13.87 μM, with 0.16 μM and 0.55 μM as the detection and quantification limit respectively.

Electrolytic Production of NF3 Using Boron-Doped Diamond Anode in Molten NH4F·2HF

The current efficiency for NF3 formation was independent on the current density in the range of 200 to 1,000 mA·cm^2. The average values of NF3 current efficiencies on the BDD （boron-doped diamond） anode with the boron-concentration of 2,500 ppm were 32.3% at 80℃, 63.3% at 100℃ and 59.7% at 120℃. The best current efficiencies for NF3 formation on the BDD anode with boron-concentrations of 2,500, 5,000 and 7,500 ppm were obtained at 100℃ and those were 63.3%, 73.3% and 56.2%, respectively. Although anode effect occurred on the BDD electrodes covered with a part of the surface of the spiculate structure, which had the boron-concentrations higher than 7,500 ppm, it did not take place on the BDD electrodes covered with the surface of diamond structure, even if the BDD electrode had the boron-concentration of 8,000 ppm.

Direct and Simultaneous Determination of Phenol, Hydroquinone and Nitrophenol at Boron-Doped Diamond Film Electrode

The electrochemical characteristics of multi-component phenolic pollutants, such as phenol （Ph）, hydroquinone （HQ） and 4-nitrophenol （4-NP）, were investigated on boron-doped diamond （BDD） film electrode by differential pulse voltammetry （DPV） technique. A simple and feasible platform was accordingly established for the direct and simultaneous determination of these three phenolic pollutants. Results showed that, Ph, HQ and 4-NP gave obvious oxidation peaks on BDD electrode at the potential of 1.24, 0.76 and 1.52 V, respectively. Each of them displayed good linear relationship between their oxidation peak currents and their corresponding concentrations in a rather wide range coexisting with one or two of the other phenolic pollutants. The detection limits of Ph, HQ and 4-NP were estimated to be as low as 1.82×10^-6, 1.67×10^-6 and 1.44×10^-6 mol·L^-1, respectively. Therefore, a promising direct and simultaneous electrochemical determination method of multi-component phenolic pollutants in wastewater samples was constructed successfully on BDD electrode with advantages being rapid, simple, convenient, sensitive, in situ and inexpensive.

A Diamond Electrochemical Cleaning Technique for Organic Contaminants on Silicon Wafer Surfaces

Peroxodiphosphate anion （a powerful oxidant） can be formed in a special water-based cleaning agent through an electrochemical reaction on boron-doped diamond electrodes. This electrochemical reaction was applied during the oxidation,decomposition, and removal of organic contaminations on a silicon wafer surface, and it was used as the first step in the diamond electrochemical cleaning technique （DECT）. The cleaning effects of DECT were compared with the RCA cleaning technique, including the silicon surface chemical composition that was observed with X-ray photoelectron spectroscopy and the morphology observed with atomic force microscopy. The measurement results show that the silicon surface cleaned by DECT has slightly less organic residue and lower micro-roughness,so the new technique is more effective than the RCA cleaning technique.

苯酚在金刚石膜电极上的电化学氧化降解过程

采用循环伏安法、交流阻抗法、恒电位计时电流法,并结合高效液相色谱方法,研究了苯酚在金刚石膜电极上的电化学氧化降解过程.结果表明,苯酚在电化学氧化降解中经历了苯二酚、苯醌的形成和进一步被氧化的过程,苯二酚在反应过程中的积累很少,迅速氧化为苯醌,而醌类中间产物则较难进一步氧化,在反应过程中积累的浓度较高.苯酚在金刚石膜电极上有不同的电化学氧化反应途径,在低于金刚石膜电极析氧电位下,发生单纯直接电化学氧化过程;在高于金刚石膜电极析氧电位下,间接电化学氧化和直接电化学氧化将同时发生作用.

电解与纳滤工艺联合处理十三碳二元酸生产中的废水

十三碳二元酸生产中产生大量有机废水,为了去除其中高含量的COD和SO42-,首先采用电解法降解其中的有机物,再利用2级纳滤系统对电解残液进行分离。实验研究了钽基金刚石薄膜电极在不同电解工艺条件下对有机物降解的影响,确定了适宜的电解操作条件:槽电压1.6 V左右,电解时间7 h。又考察了在纳滤过程中的各种操作因素对膜过程的影响,探索出合适的纳滤系统的操作条件:操作压差为1.2—1.4 MPa;膜面十字流流速对于DL膜为0.15 m/s左右,对于SE膜为0.12 m/s左右;操作温度为35—40℃。经过联合处理后的废水COD去除率在99%以上,SO42-含量可以达到排放标准。

镍催化多孔掺硼金刚石薄膜电极的制备及其电化学氧化降解染料废水实验研究

采用化学气相沉积技术在铌基体上制备了BDD/Nb薄膜电极,并通过高温镍催化处理和电化学处理,获得了多孔BDD/Nb薄膜电极;选用活性橙X-GN染料废水进行了模拟降解实验,探讨2种电极降解废水效果。结果表明:相比于BDD/Nb电极,多孔BDD/Nb电极的有效电极面积增加了2.8倍;在活性橙X-GN染料废水降解实验中,多孔BDD/Nb电极的降解效率显著提高,相对于BDD/Nb电极,色度移除速度提高约4倍,COD移除速度提高约3倍,电流效率提高约15.92个百分点,能耗降低近75%。

A Rapid Separation and Highly Determination of Paraben Species by Ultra-Performance Liquid Chromatography —Electrochemical Detection

In this study, a new technique was developed using rapid ultra-performance liquid chromatography (UPLC)-based separation coupled with electrochemical detection by a boron-doped diamond (BDD) electrode for the detection and quantification of three commonly used parabens (methylparaben (MP), ethylparaben (EP) and propylparaben (PP)). We aimed to reduce the analysis time by using UPLC coupled with a short reverse phase C 18 monolithic column (25 mm×4.6 mm). Operating the monolithic column at low back-pressure resulted in high flow rates. A mobile phaseconsisting of a 25:75 (v/v) ratio of acetonitrile:0.05 Mphosphate buffer (pH 5) at a flow rate of 2.5 mL·min?1 was used to perform the separation. The amperometric detection with the BDD electrode was found to be optimal and reliably reproducible at a detection potential of 1.5 V vs. Ag/AgCl. Under these conditions, the separation of the three targetanalytes (MP, EP and PP) was achieved in 2 min and was linear within a sample concentration range of 0.1 to 50.0 mg·L?1 (r2 values of 0.9970, 0.9994 and 0.9994 for MP, EP and PP, respectively). This method was successfully applied to determine the concentrations of each parabeninsix real samples with therecoveries ranging from of 80.3% - 98.9% for all three parabensfrom samples spiked at 12, 22 and 32 mg·L?1. Therefore, the proposed method can be used as an alternative rapid and selective method for the determination of paraben levels in real samples.

The effects of electrochemical oxidation on in-vivo fluorescence and toxin content in Microcystis aeruginosa culture

The increasing occurrence of cyanobacterial blooms in water bodies is a serious threat to the environment. Efficient in-lake treatment methods for the control of cyanobacteria proliferation are needed, their in-vivo detection to obtain a real-time response to their presence, as well as the information about their physiological state after the applied treatment. In-vivo fluorescence measurements of photosynthetic pigments have proved to be effective for quantitative and qualitative detection of phytoplankton in a water environment. In the experiment, chlorophyll and phycocyanin fluorescence sensors were used concurrently to detect stress caused by electrochemical oxidation applying an electrolytic cell equipped with borondoped diamond electrodes on a laboratory culture of cyanobacteria Microcystis aeruginosa PCC 7806. The inflicted injuries were reflected in a clear transient increase in the phycocyanin fluorescence signal(for 104 %? 43%) 24 h after the treatment, which was not the case for the chlorophyll fluorescence signal. In the next 72 h of observation, the fluorescence signals decreased(on 40% of the starting signal) indicating a reduction of cell number, which was confirmed by cell count(24% reduction of the starting concentration) and analysis of extracted chlorophyll and phycocyanin pigment. These results demonstrate the viability of the combined application of two sensors as a useful tool for in-vivo detection of induced stress, providing real-time information needed for the evaluation of the efficiency of the in-lake treatment and decision upon the necessity of its repetition. The electrochemical treatment also resulted in a lower free microcystins concentration compared to control.

An Electrochemical Cleaning Technique for Removal of Surface Contamination before Texturization of Silicon Solar Cells

In order to decrease the consumption of reagents and silicon during removal of surface contamination before silicon texturing in solar cell manufacturing industry, a new low-cost surface treatment approach of electrochemical cleaning technique(ECT) is reported. In this technique, a powerful oxidizing electrolyte was obtained from the electrochemical reaction on Boron-doped Diamond(BDD) electrodes, and applied during removal of surface contaminations on silicon wafer surfaces. The slightly polished monocrystalline silicon surfaces after cleaning were compared with the ones of primal silicon wafers. The measurement results show that ECT is quite efficient in removing NaCl and organic contaminants. After cleaning, the contrast test was conducted for the textured silicon wafers with/without pre-treatment(polish) separately. The results show that the size of pyramids on the surface without traditional polishing process is homogeneous and smaller than 4μm, and the average surface reflectance is much lower in the wavelength range from 400nm to 800nm. Therefore, the new technique can save silicon material, and effectively avoid optical losses for improving photoconversion effect of solar cells.

Electrochemical behavior and analytical detection of Imidacloprid insecticide on a BDD electrode using square-wave voltammetric method

A sensitive square-wave voltammetric method for the determination of lmidacloprid （IMD） was developed using electrochemically pretreated boron-doped diamond （BDD） electrode. Aqueous solutions were prepared with Confidor 200 SL as the commercial formulation of IMD. Sodium sulfate （Na2SO4） was used as supporting electrolyte. The influence of operating parameters, such as the pH of the medium, frequency, pulse amplitude, scan increment and the concentration of IMD was investigated. An irreversible cathodic peak, corresponding to the reduction oflMD is observed at 1.21 V （vs. SCE） and the electrode reaction was controlled by adsorption. Under optimized conditions, the square-wave reduction peak current was linear over the concentration range of （30-200 μmol L 1） with a detection and quantification limits of 8.60 μmol L 1 and 28.67 μmol L 1, respectively. The results were compared with spectrophotometry and HPLC methods under some conditions and found to be in good agreement. To investigate applicability to real samples, the proposed method was applied to the determination of IMD in plum juice.