Comprehensive investigations have been conducted to study the structure and overconsolidation of upper Shanghai clays, i.e. Layers 2–6 clays, typically located at depths of 30–40 m. However, limited information is a...Comprehensive investigations have been conducted to study the structure and overconsolidation of upper Shanghai clays, i.e. Layers 2–6 clays, typically located at depths of 30–40 m. However, limited information is available on their anisotropy, and even less is known about the correlation between structure, overconsolidation, and anisotropy. In this study, the undrained anisotropy characteristics of shear strength and small-strain shear stiffness in upper Shanghai Layers 2–6 clays were thoroughly assessed using a series of K0-consolidated undrained triaxial compression (TC) and triaxial extension (TE) tests (K0 is the coefficient of lateral earth pressure at rest). The effective stress paths, shear strength, and small-strain shear stiffness from the undrained TC and TE tests demonstrate the anisotropic behaviors in upper Shanghai clays. Analyses of data from upper Shanghai clays and other clays worldwide indicate that the shear strength anisotropy ratio (Ks) converges at 0.8 as the overconsolidation ratio (OCR) and plasticity index (Ip) increase, while the small-strain shear stiffness anisotropy ratio (Re) converges at 1.0. The influence of OCR on Ks and Re is more pronounced than that of Ip and sensitivity (St). Nevertheless, no clear correlation between Ks and Re is observed in upper Shanghai clays.展开更多
Continuous soil-cement wall confinement method to resist liquefaction is a new kind of process. However, whether it also has a good effect on anti-liquefaction or not needs to be urgently answered for earthquake engin...Continuous soil-cement wall confinement method to resist liquefaction is a new kind of process. However, whether it also has a good effect on anti-liquefaction or not needs to be urgently answered for earthquake engineering. Quiet boundary is adopted on the lateral face while free field boundary is employed at the bottom. Byrne model on dynamic pore water pressure generation is accepted and natural seismic wave EI Centro whose peak acceleration is adjusted to 0.2 g in proportion is used for input. A double-layer foundation with sandy soil in the upper portion while clay soil in the lower part is chosen as the calculation model, which is 30 m in length and 20 m in width. The groundwater level is on the ground surface. Excess pore water pressure rate is considered as a liquefaction index in the three-dimensional non-linear earthquake response computation. The anti-liquefaction effectiveness and its influencing factors, such as confinement element area are studied. For the natural double-layer foundation, it is liquefied when the excess pore water pressure rate reaches 1.0 under the seismic load. Under the same earthquake load, the peak excess pore water pressure reduces to 0.56 after adopting reinforcement of the continuous soil-cement wall, which is 46% lower than before. It indicates that continuous soil-cement wall confinement method can attain the purpose of anti-liquefaction. Accordingly, it can be a sort of engineering measure to carry on the anti-liquefaction foundation treatment.展开更多
Cement-mixed piles,as countermeasure against liquefaction of silt and sand ground,can improve the shear strength and bearing capacity of foundation soil,meaning cement-mixed piles are capable of resisting displacement...Cement-mixed piles,as countermeasure against liquefaction of silt and sand ground,can improve the shear strength and bearing capacity of foundation soil,meaning cement-mixed piles are capable of resisting displacement when an earthquake happens. However,investigations of cement-mixed piles by experimental methods such as the shaking table test is few and far between. It is especially true for the seismic performance of cement-mixed piles in liquefiable railway foundations in high seismic intensity regions. To this end,a cross-section of the Yuxi-Mengzi railway was selected as the prototype and studied by the shaking table test in this study. The results showed that composite foundation of cementmixed piles was not liquefied when the seismic acceleration was lower than 0. 30g. In the process of acceleration increasing from 0. 30g at 2Hz to 0. 60g at 3Hz,the upper middle silt outside slope toe was partly liquefied. The foundation soil under the shoulders and center of subgrade was far from the initial liquefaction criterion during the test. Cementmixed piles can effectively reduce the embankment settlement and differential settlement. It can be concluded that, the design of cement-mixed piles can ensure the seismic performance of the subgrade,and satisfy the seismic design requirements of the YuxiMengzi railway in areas of VIII degrees seismic fortification intensity.展开更多
The Mbouda alluvial deposit is located at the foot of the Bamboutos mountains (West Cameroon) where three types of clayey materials are widespread. The populations collect these clays in their natural state in view of...The Mbouda alluvial deposit is located at the foot of the Bamboutos mountains (West Cameroon) where three types of clayey materials are widespread. The populations collect these clays in their natural state in view of constructions using fired bricks or compressed blocks. Unfortunately, these buildings are not strong. This study investigates the causes of the strengthlessness of buildings and suggests solutions to overcome the difficulty. The research content includes field and laboratory studies. The methodology consists of sampling black (AN), white (AB) and red (AR) clays specimens identified in the study area and analysing them simultaneously at MIPROMALO (Cameroon) and at ACME LAB in Vancouver (Canada). The results obtained show a high sand content in the samples AN (64%), AB (55.2%), AR (30.9%). The compressive strength of the built specimens is low at 900˚C considered as the traditional firing temperature AN (0.94 MPa), AB (5.25 MPa), AR (2.18 MPa). The mineralogical series are identically made by kaolinite, chlorite, gibbsite, quartz, muscovite, biotite, goethite, magnetite and hematite. Silica (SiO2) presents higher contents AN (52.87%), AB (48.02%), AR (47.68%) followed by alumina (Al2O3) AN (29.96%), AB (28.13%), AR (24.72%). The other elements are poorly represented.展开更多
基金the financial support received from the National Natural Science Foundation of China(Grant Nos.42072317 and 41727802)the Science and Technology Commission of Shanghai Municipality(Funding No.21DZ1204300).
文摘Comprehensive investigations have been conducted to study the structure and overconsolidation of upper Shanghai clays, i.e. Layers 2–6 clays, typically located at depths of 30–40 m. However, limited information is available on their anisotropy, and even less is known about the correlation between structure, overconsolidation, and anisotropy. In this study, the undrained anisotropy characteristics of shear strength and small-strain shear stiffness in upper Shanghai Layers 2–6 clays were thoroughly assessed using a series of K0-consolidated undrained triaxial compression (TC) and triaxial extension (TE) tests (K0 is the coefficient of lateral earth pressure at rest). The effective stress paths, shear strength, and small-strain shear stiffness from the undrained TC and TE tests demonstrate the anisotropic behaviors in upper Shanghai clays. Analyses of data from upper Shanghai clays and other clays worldwide indicate that the shear strength anisotropy ratio (Ks) converges at 0.8 as the overconsolidation ratio (OCR) and plasticity index (Ip) increase, while the small-strain shear stiffness anisotropy ratio (Re) converges at 1.0. The influence of OCR on Ks and Re is more pronounced than that of Ip and sensitivity (St). Nevertheless, no clear correlation between Ks and Re is observed in upper Shanghai clays.
基金Project(50639010, 90815020) supported by the National Natural Science Foundation of ChinaProject(JKCX-200602) supported by South-to-North Water Diversion in Jiangsu Province, China
文摘Continuous soil-cement wall confinement method to resist liquefaction is a new kind of process. However, whether it also has a good effect on anti-liquefaction or not needs to be urgently answered for earthquake engineering. Quiet boundary is adopted on the lateral face while free field boundary is employed at the bottom. Byrne model on dynamic pore water pressure generation is accepted and natural seismic wave EI Centro whose peak acceleration is adjusted to 0.2 g in proportion is used for input. A double-layer foundation with sandy soil in the upper portion while clay soil in the lower part is chosen as the calculation model, which is 30 m in length and 20 m in width. The groundwater level is on the ground surface. Excess pore water pressure rate is considered as a liquefaction index in the three-dimensional non-linear earthquake response computation. The anti-liquefaction effectiveness and its influencing factors, such as confinement element area are studied. For the natural double-layer foundation, it is liquefied when the excess pore water pressure rate reaches 1.0 under the seismic load. Under the same earthquake load, the peak excess pore water pressure reduces to 0.56 after adopting reinforcement of the continuous soil-cement wall, which is 46% lower than before. It indicates that continuous soil-cement wall confinement method can attain the purpose of anti-liquefaction. Accordingly, it can be a sort of engineering measure to carry on the anti-liquefaction foundation treatment.
基金sponsored by the Railway's Research and Development Project of the Ministry of Railways of the People's Republic of the China:Study on Special Subgrade Construction Technology in High Intensity Earthquake Area of the Yuxi-Mengzi Railway
文摘Cement-mixed piles,as countermeasure against liquefaction of silt and sand ground,can improve the shear strength and bearing capacity of foundation soil,meaning cement-mixed piles are capable of resisting displacement when an earthquake happens. However,investigations of cement-mixed piles by experimental methods such as the shaking table test is few and far between. It is especially true for the seismic performance of cement-mixed piles in liquefiable railway foundations in high seismic intensity regions. To this end,a cross-section of the Yuxi-Mengzi railway was selected as the prototype and studied by the shaking table test in this study. The results showed that composite foundation of cementmixed piles was not liquefied when the seismic acceleration was lower than 0. 30g. In the process of acceleration increasing from 0. 30g at 2Hz to 0. 60g at 3Hz,the upper middle silt outside slope toe was partly liquefied. The foundation soil under the shoulders and center of subgrade was far from the initial liquefaction criterion during the test. Cementmixed piles can effectively reduce the embankment settlement and differential settlement. It can be concluded that, the design of cement-mixed piles can ensure the seismic performance of the subgrade,and satisfy the seismic design requirements of the YuxiMengzi railway in areas of VIII degrees seismic fortification intensity.
文摘The Mbouda alluvial deposit is located at the foot of the Bamboutos mountains (West Cameroon) where three types of clayey materials are widespread. The populations collect these clays in their natural state in view of constructions using fired bricks or compressed blocks. Unfortunately, these buildings are not strong. This study investigates the causes of the strengthlessness of buildings and suggests solutions to overcome the difficulty. The research content includes field and laboratory studies. The methodology consists of sampling black (AN), white (AB) and red (AR) clays specimens identified in the study area and analysing them simultaneously at MIPROMALO (Cameroon) and at ACME LAB in Vancouver (Canada). The results obtained show a high sand content in the samples AN (64%), AB (55.2%), AR (30.9%). The compressive strength of the built specimens is low at 900˚C considered as the traditional firing temperature AN (0.94 MPa), AB (5.25 MPa), AR (2.18 MPa). The mineralogical series are identically made by kaolinite, chlorite, gibbsite, quartz, muscovite, biotite, goethite, magnetite and hematite. Silica (SiO2) presents higher contents AN (52.87%), AB (48.02%), AR (47.68%) followed by alumina (Al2O3) AN (29.96%), AB (28.13%), AR (24.72%). The other elements are poorly represented.
