The heat transfer and pressure loss characteristics on a square channel with two opposite surfaces roughened by high blockage ratio ribs are measured by systematic experiments.Reynolds numbers studied in the channel r...The heat transfer and pressure loss characteristics on a square channel with two opposite surfaces roughened by high blockage ratio ribs are measured by systematic experiments.Reynolds numbers studied in the channel range from 1 400 to 8 000.The ratios of rib height to hydraulic diameter (e/D) are 0.2and 0.33,respectively.The ratio of rib spacing to height (P/e) ranges from 5to 15.The rib orientations in the opposite surfaces are symmetrical and staggered arrangements.The results show that the heat transfer coefficients are increased with the increase of rib height and Reynolds number,though at the cost of higher pressure losses.When the rib spacing to height ratio is 10,it keeps the highest heat transfer coefficient in three kinds of rib spacing to height ratios 5,10 and 15.The heat transfer coefficient of symmetrical arrangement ribs is higher than that of the staggered arrangement ribs,but the pressure loss of the symmetrical arrangement ribs is larger than that of the staggered arrangement ribs.展开更多
The ground-state energy level （GEL） and electron distribution of GaAs pseudomorphic high-electron-mobility transistors （PHEMTs） are analyzed by a self-consistent solution to the Schrodinger-Poisson equations. The ...The ground-state energy level （GEL） and electron distribution of GaAs pseudomorphic high-electron-mobility transistors （PHEMTs） are analyzed by a self-consistent solution to the Schrodinger-Poisson equations. The indium composition and thickness of the InGaAs channel are optimized according to the GEL position. The GEL position is not in direct proportion to 1/d^2 （d is the channel thickness） by considering the influence of electron distribution in the InGaAs channel. Indium composition 0.22 and channel thickness 9 nm are obtained by considering the mismatch between InGaAs and AlGaAs. Several PHEMT samples are grown according to the theoretical results and mobility 6300 cm^2 /V.s is achieved.展开更多
The present study deals with natural convection flow in a vertical open-ended channel with wall constant heat flux. The experimental and numerical investigations are both conducted using water as the working fluid. Th...The present study deals with natural convection flow in a vertical open-ended channel with wall constant heat flux. The experimental and numerical investigations are both conducted using water as the working fluid. The numerical code is developed using finite differences scheme to solve the Navier-Stokes equations under the Boussinesq assumption. Concerning the experimental apparatus, it consists of two heated walls immersed in water. Temperature and velocity measurements are provided for different modified Rayleigh numbers based on the walls spacing b Rab = 1.67 x 10 6,3.6 x 10 6,8.97 x10 6,1.69 x 10 7,4.29 x 10 7. The numerical code is first validated with a numerical benchmark. Then, comparison between experimental and numerical results is performed. The code provides a satisfactory prediction of main quantities compared to the experimental results but only for the lowest Rayleigh numbers. For higher modified Rayleigh numbers, the flow becomes three-dimensional and turbulent. Therefore, 2D numerical simulations fail to predict flow and heat transfer for this range of modified Rayleigh number.展开更多
A certain pattern of channel is the product of its self-adjustment under given boundary, discharge and sediment conditions. Based upon the principle of process-response model, an experimental study with 18 runs is car...A certain pattern of channel is the product of its self-adjustment under given boundary, discharge and sediment conditions. Based upon the principle of process-response model, an experimental study with 18 runs is carried out in LESRC. This paper is focused on the variation of the energy dissipation versus the channel morphology during and after the bedmaking process of braided channel. The results show that there exists a good empirical relationship between the energy dissipation rate and channel morphology. According to this relationship and the theory of minimum rate of energy dissipation, the authors explain the metamorphosis of the model channel with the development of the braided river.展开更多
Brief introduction of experiments,laboratories and stations in geomorphology.The achievements in experimental fluvial geomorphology gained in the last 30 years in China include channel pattern modelling,studies on inf...Brief introduction of experiments,laboratories and stations in geomorphology.The achievements in experimental fluvial geomorphology gained in the last 30 years in China include channel pattern modelling,studies on influence of boundary conditions,applications of fluvial geomorphology,its experimental theories and techniques,etc.Problems in fluvial geomorphic experiments are indicated,tendencies in the development of this branch of geomorphology are predicted,and suggestions are made.展开更多
A novel cooling system with cooling channels is proposed for the stator of 3MW wind-driven generator.An experimental platform is built to investigate the performance of the cooling system with different loads.At30%,50...A novel cooling system with cooling channels is proposed for the stator of 3MW wind-driven generator.An experimental platform is built to investigate the performance of the cooling system with different loads.At30%,50% or 80% generator loads,the temperatures meet the design requirement.However,it is a little over the requirement at 100%load,duo to experimental errors and some unknown thermal resistances.In the test at 100%load,the developing trends of the parameters of these two generators are similar and only minor differences occurs when they reach steady state our work can be benefit for the design and improvement of MW wind-driven generator cooling solutions.展开更多
基金supported by the National Natural Science Foundation of China(No.51276088)
文摘The heat transfer and pressure loss characteristics on a square channel with two opposite surfaces roughened by high blockage ratio ribs are measured by systematic experiments.Reynolds numbers studied in the channel range from 1 400 to 8 000.The ratios of rib height to hydraulic diameter (e/D) are 0.2and 0.33,respectively.The ratio of rib spacing to height (P/e) ranges from 5to 15.The rib orientations in the opposite surfaces are symmetrical and staggered arrangements.The results show that the heat transfer coefficients are increased with the increase of rib height and Reynolds number,though at the cost of higher pressure losses.When the rib spacing to height ratio is 10,it keeps the highest heat transfer coefficient in three kinds of rib spacing to height ratios 5,10 and 15.The heat transfer coefficient of symmetrical arrangement ribs is higher than that of the staggered arrangement ribs,but the pressure loss of the symmetrical arrangement ribs is larger than that of the staggered arrangement ribs.
文摘The ground-state energy level （GEL） and electron distribution of GaAs pseudomorphic high-electron-mobility transistors （PHEMTs） are analyzed by a self-consistent solution to the Schrodinger-Poisson equations. The indium composition and thickness of the InGaAs channel are optimized according to the GEL position. The GEL position is not in direct proportion to 1/d^2 （d is the channel thickness） by considering the influence of electron distribution in the InGaAs channel. Indium composition 0.22 and channel thickness 9 nm are obtained by considering the mismatch between InGaAs and AlGaAs. Several PHEMT samples are grown according to the theoretical results and mobility 6300 cm^2 /V.s is achieved.
文摘The present study deals with natural convection flow in a vertical open-ended channel with wall constant heat flux. The experimental and numerical investigations are both conducted using water as the working fluid. The numerical code is developed using finite differences scheme to solve the Navier-Stokes equations under the Boussinesq assumption. Concerning the experimental apparatus, it consists of two heated walls immersed in water. Temperature and velocity measurements are provided for different modified Rayleigh numbers based on the walls spacing b Rab = 1.67 x 10 6,3.6 x 10 6,8.97 x10 6,1.69 x 10 7,4.29 x 10 7. The numerical code is first validated with a numerical benchmark. Then, comparison between experimental and numerical results is performed. The code provides a satisfactory prediction of main quantities compared to the experimental results but only for the lowest Rayleigh numbers. For higher modified Rayleigh numbers, the flow becomes three-dimensional and turbulent. Therefore, 2D numerical simulations fail to predict flow and heat transfer for this range of modified Rayleigh number.
基金Joint project by National Natural Science Foundation of China and Ministry of Water Resources of China No. 59890200 the incenti
文摘A certain pattern of channel is the product of its self-adjustment under given boundary, discharge and sediment conditions. Based upon the principle of process-response model, an experimental study with 18 runs is carried out in LESRC. This paper is focused on the variation of the energy dissipation versus the channel morphology during and after the bedmaking process of braided channel. The results show that there exists a good empirical relationship between the energy dissipation rate and channel morphology. According to this relationship and the theory of minimum rate of energy dissipation, the authors explain the metamorphosis of the model channel with the development of the braided river.
文摘Brief introduction of experiments,laboratories and stations in geomorphology.The achievements in experimental fluvial geomorphology gained in the last 30 years in China include channel pattern modelling,studies on influence of boundary conditions,applications of fluvial geomorphology,its experimental theories and techniques,etc.Problems in fluvial geomorphic experiments are indicated,tendencies in the development of this branch of geomorphology are predicted,and suggestions are made.
文摘A novel cooling system with cooling channels is proposed for the stator of 3MW wind-driven generator.An experimental platform is built to investigate the performance of the cooling system with different loads.At30%,50% or 80% generator loads,the temperatures meet the design requirement.However,it is a little over the requirement at 100%load,duo to experimental errors and some unknown thermal resistances.In the test at 100%load,the developing trends of the parameters of these two generators are similar and only minor differences occurs when they reach steady state our work can be benefit for the design and improvement of MW wind-driven generator cooling solutions.
