Formation Mechanism of Chunky Graphite and Its Preventive Measures

The formation mechanism of chunky graphite has been reviewed and studied. The study consisted of a unidirectional solidification method, a small droplet method and a furnace cooling method. Four kinds of iron samples were prepared, namely, the pure Fe-C, Fe-C-S, Fe-C-Ce and Fe-C-Si-Ce alloys, and three kinds of nickel samples, namely the Ni-C, Ni-C-S and Ni-C-Mg alloys. The results of the unidirectional solidification of the Ni-C alloys showed that spheroidal graphite is not observed in the continuous solidified region, in which only flake-like graphite is observed, while spheroidal graphite is usually observed in the quenched liquid region. The existence of spheroidal graphite in the solidified phase is recognized only in the discontinuous growth mode of the Ni-C-Mg alloy solidified at 150 mm/h. This means that the spheroidal graphite is directly crystallized from the melt and entrapped by the flake-like chunky graphite that is formed by the continuous growth mode. In the small droplet method, a small piece of the Fe-C or Fe-C-Ce sample was melted on a pure graphite plate then cooled at a different cooling rate in a He-3%H2 atmosphere. The graphite in the Fe-C-Ce alloy is usually spherical. Nevertheless, the graphite morphology of the final solidified area changed from spherical to chunky and chunky to ledeburite with an increase in the cooling rate. This means that the chunky graphite is formed in the residual liquid region by the solidification into Fe-graphite system. The sample was cooled in a furnace, and the graphite morphology changes from spherical to chunky and chunky to ledeburite with the decrease in the Si content. These phenomena can be confirmed by the cooling curves of these samples.

Some paradoxical observations about spheroidal graphite degeneracy

Differential thermal analysis experiments have been performed on samples machined from Y2-blocks cast with different high-silicon spheroidal graphite irons. Depending on magnesium, silicon, cerium and antimony content, the as-cast microstructure showed various levels of chunky graphite in the central part of the blocks. In contrast, the microstructure of the materials after remelting and resolidification during differential thermal analysis consisted of lamellar or compacted graphite. The formation of chunky graphite in the as-cast microstructure is rationalized using an index or silicon equivalent that has been recently suggested. The differences in the microstructures after differential thermal analysis are discussed in terms of available free magnesium. Emphasis is finally put on the striking differences in characteristic size of the microstructures made of compacted graphite as compared to lamellar graphite and chunky graphite. This leads to tentative conclusions about growth of compacted and chunky graphite which would be worthy of further experimental investigations.

Selection of raw materials and control of trace elements for production of high-quality SG iron

During the production of SG iron, the selection of raw materials and control of chemical composition are most important. From the very early days of SG iron production, the effects of trace elements on graphite form and matrix structure have been studied, and the allowable concentration limits for their detrimental influence has been decreased year by year, during the last fifty years. This paper has reviewed some of the suggested SG iron trace elements in the literature and in several Chinese foundries. It was found that for most SG iron castings, rare earth elements are still required to neutralize the harmful effects of trace elements and improve SG iron quality. It also found that the use of high purity and ultra-high purity base iron melts enabled integrated, safety-critical and complicated SG iron castings of varying thickness, and heavy-section, to be produced successfully. These SG iron castings have surprisingly good structures, and their mechanical and dynamic properties are vastly superior to those specified in current international SG iron standards. Further study is required on the effects of using high purity and ultra-high purity base melts on the structure and properties of SG iron.