A crowbar impulse current circuit for testing the switch-type surge protective device （SPD） is presented. The crowbar circuit consists of a computer control circuit, a trigger voltage pulse generator, a main dischar...A crowbar impulse current circuit for testing the switch-type surge protective device （SPD） is presented. The crowbar circuit consists of a computer control circuit, a trigger voltage pulse generator, a main discharging switch, and a crowbar pseudospark switch. The active trigger technology was studied in the crowbar impulse current circuit. The circuit monitors the main discharging current and generates a trigger signal at a proper time for the crowbar pseudospark switch operation. The trigger characteristics of the main discharge switch and the crowbar pseu- dospark switch were investigated. By monitoring the preset applied capacitor voltage, the gap distance of the main discharging switch could be adjusted to ensure a discharging delay time less than 2 μs. Equipped with a surface ttashover trigger device made of high relative perimittivity dielectric material BaTiO3 （εr = 3460）, the discharge delay time of the crowbar pseudospark switch is less than 85 ns, and the minimum operating voltage is less than 1% of its self-breakdown voltage. With a storage capacitor of 9 μF , an inductor of 18 μH and a crowbar pseudospark switch, a load of 30 mΩ and an applied capacitor voltage of 40 kV, an impulse current waveform of maximum 25 kA was generated with a rise time and time to half peak value of 17.2 μs and 336μs respectively.展开更多
This paper presents a non-autonomous hyper-chaotic system, which is formed by adding a periodic driving signal to a four-dimensional chaotic model extended from the Lorenz system. The resulting non-autonomous hyper-ch...This paper presents a non-autonomous hyper-chaotic system, which is formed by adding a periodic driving signal to a four-dimensional chaotic model extended from the Lorenz system. The resulting non-autonomous hyper-chaotic system can display any dynamic behaviour among the periodic orbits, intermittency, chaos and hyper-chaos by controlling the frequency of the periodic signal. The phenomenon has been well demonstrated by numerical simulations, bifurcation analysis and electronic circuit realization. Moreover, the system is concrete evidence for the presence of Pomeau- Manneville Type-I intermittency and crisis-induced intermittency. The emergence of a different type of intermittency is similarly subjected to the frequency of periodic forcing. By statistical analysis, power scaling laws consisting in different intermittency are obtained for the lifetime in the laminar state between burst states.展开更多
Propose the sequential circuits with the ternary D-ffs in series^1. Discuss the equivalence between the sequential circuits with the p-valued flip-flops in series and in parallel as a part of studying the multiple val...Propose the sequential circuits with the ternary D-ffs in series^1. Discuss the equivalence between the sequential circuits with the p-valued flip-flops in series and in parallel as a part of studying the multiple valued logic circuits.展开更多
A theoretical model is developed for calculating the eigenmodes of the multi-gap resonant cavity. The structure of concern is a kind of ladder-type circuit, offering the advantages of easy fabrication, high characteri...A theoretical model is developed for calculating the eigenmodes of the multi-gap resonant cavity. The structure of concern is a kind of ladder-type circuit, offering the advantages of easy fabrication, high characteristic impedance （R/Q）, and thermal capacity in the millimeter wave to THz regime. The eigenfunction expansion method is used to establish the field expressions for the gaps and the coupling region. Then, the match conditions at the interface are employed, which leads to a group of complicate boundary equations in the form of an infinite series. To facilitate the mathematical treatments and perform a highly efficient calculation, these boundary equations are transformed into the algebraic forms through the matrix representations. Finally, the concise dispersion equation is obtained. The roots of the dispersion equation include both the axial modes in the gaps, which include the fundamental and the high-order modes, and the cavity modes in the coupling region. Extensive numerical results are presented and the behaviors of the multi-gap resonant cavity are examined.展开更多
The paper reveals the relation between the linear AND-OR gate and the emitter function logic. With theoretic calculation and PSPICE simulation, the paper proves that the linear AND-OR gates can work at super-high-spee...The paper reveals the relation between the linear AND-OR gate and the emitter function logic. With theoretic calculation and PSPICE simulation, the paper proves that the linear AND-OR gates can work at super-high-speed and can be multi-cascaded. On the basis of analyzing the high-speed switch units which coordinate with linear AND-OR gates, two kinds of emitter coupled logic circuits are designed. The paper also discusses the design principles of super-high-speed digital circuits, and some examples of combinational and sequential circuits using linear AND-OR gate are given.展开更多
Quantum teleportation with entanglement channels and a series of two-qubit SWAP gates between the nearestneighbor qubits are usually utilized to achieve the transfers of unknown quantum state from the sender to the di...Quantum teleportation with entanglement channels and a series of two-qubit SWAP gates between the nearestneighbor qubits are usually utilized to achieve the transfers of unknown quantum state from the sender to the distant receiver. In this paper, by simplifying the usual SWAP gates we propose an approach to speed up the transmissions of unknown quantum information, specifically including the single-qubit unknown state and two-qubit unknown entangled ones,by a series of entangling and disentangling operations between the remote qubits with distant interactions. The generic proposal is demonstrated specifically with experimentally-existing Ising-type quantum channels without transverse interaction; liquid NMR-molecules driven by global radio frequency electromagnetic pulses and capacitively-coupled Josephson circuits driven by local microwave pulses. The proposal should be particularly useful to set up the connections between the distant qubits in a chip of quantum computing.展开更多
换相失败问题(commutation failure,CF)是电网换相换流高压直流输电技术(line commutated converter high voltage directcurrent,LCC-HVDC)面临的固有难题。为了解决该问题,已有文献主要从拓扑结构、控制策略等方面着手,鲜见抵御换相...换相失败问题(commutation failure,CF)是电网换相换流高压直流输电技术(line commutated converter high voltage directcurrent,LCC-HVDC)面临的固有难题。为了解决该问题,已有文献主要从拓扑结构、控制策略等方面着手,鲜见抵御换相失败的新型换流阀研制及试验研究。该文开展基于大功率逆阻型集成门极换流晶闸管(reverse blocking integrated gate commutated thyristor,RB-IGCT)的新型换流阀试验研究及试验等效性分析。首先,阐释新型换流阀抵御换相失败的原理,并针对新型换流阀不同的工作模式,提出对新型电力电子器件的需求。然后,利用现有的型式试验合成回路平台开展适用于传统晶闸管换流阀的运行试验,并分析试验结果,得出大部分试验项目等效性较好而小熄弧角试验和关断试验等效性较差的结论。最后,针对这两项特殊试验提出新的试验方法和试验电路,可为新型换流阀的研发和应用提供一定的技术基础。展开更多
在激光无线能量传输中,由于瞄准系统误差和物体遮挡的影响,光电池阵列接收到的激光辐照分布不均匀,导致光电池阵列组串内的电池间出现电流失配,输出功率下降。针对该问题,采用分布式最大功率点追踪(Distributed Maximum Power Point Tra...在激光无线能量传输中,由于瞄准系统误差和物体遮挡的影响,光电池阵列接收到的激光辐照分布不均匀,导致光电池阵列组串内的电池间出现电流失配,输出功率下降。针对该问题,采用分布式最大功率点追踪(Distributed Maximum Power Point Tracking,DMPPT)技术,减少光电池阵列组串内的电池间电流失配,并用并联型Boost(PT-Boost)电路替代传统Boost电路,降低DC/DC转换器的输入电流纹波,使DMPPT系统获得高追踪效率。实验结果表明,相较于传统Boost电路,PT-Boost电路的追踪效率提高3.6%,达到93.5%。在上述研究的基础上,设置了遮光率分别为0%、25%和50%的激光无线能量传输场景,DMPPT系统整体效率分别达到了93%、92.6%和90.3%。该研究结果对激光辐照不均匀场景下激光无线能量传输的最大功率点追踪指导意义。展开更多
文摘A crowbar impulse current circuit for testing the switch-type surge protective device （SPD） is presented. The crowbar circuit consists of a computer control circuit, a trigger voltage pulse generator, a main discharging switch, and a crowbar pseudospark switch. The active trigger technology was studied in the crowbar impulse current circuit. The circuit monitors the main discharging current and generates a trigger signal at a proper time for the crowbar pseudospark switch operation. The trigger characteristics of the main discharge switch and the crowbar pseu- dospark switch were investigated. By monitoring the preset applied capacitor voltage, the gap distance of the main discharging switch could be adjusted to ensure a discharging delay time less than 2 μs. Equipped with a surface ttashover trigger device made of high relative perimittivity dielectric material BaTiO3 （εr = 3460）, the discharge delay time of the crowbar pseudospark switch is less than 85 ns, and the minimum operating voltage is less than 1% of its self-breakdown voltage. With a storage capacitor of 9 μF , an inductor of 18 μH and a crowbar pseudospark switch, a load of 30 mΩ and an applied capacitor voltage of 40 kV, an impulse current waveform of maximum 25 kA was generated with a rise time and time to half peak value of 17.2 μs and 336μs respectively.
基金supported in part by the National Natural Science Foundation of China(Grant Nos 60774088 and 10772135)the Program for New Century Excellent Talents in University of China(NCET)+1 种基金the Foundation of the Application Base and Frontier Technology Research Project of Tianjin of China(Grant No 08JCZDJC21900)the Science and Technology Research Key Project of Education Ministry of China(Grant No 107024)
文摘This paper presents a non-autonomous hyper-chaotic system, which is formed by adding a periodic driving signal to a four-dimensional chaotic model extended from the Lorenz system. The resulting non-autonomous hyper-chaotic system can display any dynamic behaviour among the periodic orbits, intermittency, chaos and hyper-chaos by controlling the frequency of the periodic signal. The phenomenon has been well demonstrated by numerical simulations, bifurcation analysis and electronic circuit realization. Moreover, the system is concrete evidence for the presence of Pomeau- Manneville Type-I intermittency and crisis-induced intermittency. The emergence of a different type of intermittency is similarly subjected to the frequency of periodic forcing. By statistical analysis, power scaling laws consisting in different intermittency are obtained for the lifetime in the laminar state between burst states.
文摘Propose the sequential circuits with the ternary D-ffs in series^1. Discuss the equivalence between the sequential circuits with the p-valued flip-flops in series and in parallel as a part of studying the multiple valued logic circuits.
基金Project supported by the National Natural Science Foundation of China(Grant Nos.61222110 and 60971073)
文摘A theoretical model is developed for calculating the eigenmodes of the multi-gap resonant cavity. The structure of concern is a kind of ladder-type circuit, offering the advantages of easy fabrication, high characteristic impedance （R/Q）, and thermal capacity in the millimeter wave to THz regime. The eigenfunction expansion method is used to establish the field expressions for the gaps and the coupling region. Then, the match conditions at the interface are employed, which leads to a group of complicate boundary equations in the form of an infinite series. To facilitate the mathematical treatments and perform a highly efficient calculation, these boundary equations are transformed into the algebraic forms through the matrix representations. Finally, the concise dispersion equation is obtained. The roots of the dispersion equation include both the axial modes in the gaps, which include the fundamental and the high-order modes, and the cavity modes in the coupling region. Extensive numerical results are presented and the behaviors of the multi-gap resonant cavity are examined.
基金Supported by the National Natural Science Foundation of China
文摘The paper reveals the relation between the linear AND-OR gate and the emitter function logic. With theoretic calculation and PSPICE simulation, the paper proves that the linear AND-OR gates can work at super-high-speed and can be multi-cascaded. On the basis of analyzing the high-speed switch units which coordinate with linear AND-OR gates, two kinds of emitter coupled logic circuits are designed. The paper also discusses the design principles of super-high-speed digital circuits, and some examples of combinational and sequential circuits using linear AND-OR gate are given.
基金partly supported by the National Natural Science Foundation of China(Grant No.U1330201)
文摘Quantum teleportation with entanglement channels and a series of two-qubit SWAP gates between the nearestneighbor qubits are usually utilized to achieve the transfers of unknown quantum state from the sender to the distant receiver. In this paper, by simplifying the usual SWAP gates we propose an approach to speed up the transmissions of unknown quantum information, specifically including the single-qubit unknown state and two-qubit unknown entangled ones,by a series of entangling and disentangling operations between the remote qubits with distant interactions. The generic proposal is demonstrated specifically with experimentally-existing Ising-type quantum channels without transverse interaction; liquid NMR-molecules driven by global radio frequency electromagnetic pulses and capacitively-coupled Josephson circuits driven by local microwave pulses. The proposal should be particularly useful to set up the connections between the distant qubits in a chip of quantum computing.
文摘在激光无线能量传输中,由于瞄准系统误差和物体遮挡的影响,光电池阵列接收到的激光辐照分布不均匀,导致光电池阵列组串内的电池间出现电流失配,输出功率下降。针对该问题,采用分布式最大功率点追踪(Distributed Maximum Power Point Tracking,DMPPT)技术,减少光电池阵列组串内的电池间电流失配,并用并联型Boost(PT-Boost)电路替代传统Boost电路,降低DC/DC转换器的输入电流纹波,使DMPPT系统获得高追踪效率。实验结果表明,相较于传统Boost电路,PT-Boost电路的追踪效率提高3.6%,达到93.5%。在上述研究的基础上,设置了遮光率分别为0%、25%和50%的激光无线能量传输场景,DMPPT系统整体效率分别达到了93%、92.6%和90.3%。该研究结果对激光辐照不均匀场景下激光无线能量传输的最大功率点追踪指导意义。
