The properties of concrete incorporating circulating fluidized bed combustion (CFBC) bed ash and ground granulates blast-furnace slag (GGBS) were studied.Compressive strength,drying shrinkage,mercury intrusion por...The properties of concrete incorporating circulating fluidized bed combustion (CFBC) bed ash and ground granulates blast-furnace slag (GGBS) were studied.Compressive strength,drying shrinkage,mercury intrusion porosimetry (MIP),scanning electronic microscopy (SEM),and X-ray diffraction (XRD) of concrete samples containing CFBC bed ash and GGBS were used.This work used initial surface absorption test (ISAT) and rapid chloride penetration test (RCPT) on concrete to measure the absorption and the ability of concrete to resist chloride ion characteristics for different concrete samples containing CFBC bed ash and GGBS.Open circuit potential (OCP),direct current polarization resistance were obtained to evaluate rebar corrosion.The CFBC bed ash was X-ray amorphous and consist of SiO2,Al2O3 and CaO compounds.As the replacement of CFBC for sand increases,the rate of initial surface absorption (ISA) increases but compressive strength decreases.When the content of CFBC bed ash replacement for sand maintains constant,the replacement of GGBS for cement increases,compressive strength increases but the rate of ISA decreases.Chloride and corrosion resistance of rebar significantly improve by utilizing a proper amount of CFBC bed ash and GGBS in concrete.展开更多
Circulating fluidized bed combustion (CFBC) ash can be used as supplementary cementitious material for concrete production for its high pozzolanic activity. We investigated the effect of curing conditions on the hyd...Circulating fluidized bed combustion (CFBC) ash can be used as supplementary cementitious material for concrete production for its high pozzolanic activity. We investigated the effect of curing conditions on the hydration and performance of CFBC ash-Portland cement system (30: 70, by mass) including hydration products, paste microstructure, linear expansion ratio, chemically combined water content and compressive strength. The results show that tobermorite rather than ettringite is generated under the condition of autoclaved curing. The expansion and mortar strength of the system cured in water is higher than those cured in air at a given age, and the strength and bulk volume may retract under the condition of air curing. In addition, autoclaved curing facilitates the increase of strength gain at early curing ages (the increase rate lowers down in the following ages) and the improvement of system volume stability. It is suggested that sufficient water is necessary for the curing of CFBC ash cementitious system, and autoclaved curing may be considered where volume stability is a primary concern.展开更多
A model is presented for the simulation of reactive gas-solids flows in large industrial reactors. Circulating fluidized bed (CFB) combustors with several thousands of cubic meters reaction volume are probably the l...A model is presented for the simulation of reactive gas-solids flows in large industrial reactors. Circulating fluidized bed (CFB) combustors with several thousands of cubic meters reaction volume are probably the largest reactors of this type. A semi-empirical modeling approach has been chosen to model the three-dimensional concentration distributions of gas and solids components and temperatures inside the combustion chamber of such boilers. Two industrial CFB boilers are investigated in detail: the 105 MWe Duisburg combustor in Germany and the 235 MWe Turow combustor in Poland. The semi-empirical model approach is described first. Then the model is used to show how the three-dimensional concentration and temperature fields are formed by the interaction of several local phenomena. Good agreement between simulation and measurements has been achieved.展开更多
文摘The properties of concrete incorporating circulating fluidized bed combustion (CFBC) bed ash and ground granulates blast-furnace slag (GGBS) were studied.Compressive strength,drying shrinkage,mercury intrusion porosimetry (MIP),scanning electronic microscopy (SEM),and X-ray diffraction (XRD) of concrete samples containing CFBC bed ash and GGBS were used.This work used initial surface absorption test (ISAT) and rapid chloride penetration test (RCPT) on concrete to measure the absorption and the ability of concrete to resist chloride ion characteristics for different concrete samples containing CFBC bed ash and GGBS.Open circuit potential (OCP),direct current polarization resistance were obtained to evaluate rebar corrosion.The CFBC bed ash was X-ray amorphous and consist of SiO2,Al2O3 and CaO compounds.As the replacement of CFBC for sand increases,the rate of initial surface absorption (ISA) increases but compressive strength decreases.When the content of CFBC bed ash replacement for sand maintains constant,the replacement of GGBS for cement increases,compressive strength increases but the rate of ISA decreases.Chloride and corrosion resistance of rebar significantly improve by utilizing a proper amount of CFBC bed ash and GGBS in concrete.
基金Funded by the National Natural Science Foundation of China(Nos.51132010 and 51272222)the Programs for Science and Technology Development of Yantai City,Shandong Province,China(No.2012ZH249)
文摘Circulating fluidized bed combustion (CFBC) ash can be used as supplementary cementitious material for concrete production for its high pozzolanic activity. We investigated the effect of curing conditions on the hydration and performance of CFBC ash-Portland cement system (30: 70, by mass) including hydration products, paste microstructure, linear expansion ratio, chemically combined water content and compressive strength. The results show that tobermorite rather than ettringite is generated under the condition of autoclaved curing. The expansion and mortar strength of the system cured in water is higher than those cured in air at a given age, and the strength and bulk volume may retract under the condition of air curing. In addition, autoclaved curing facilitates the increase of strength gain at early curing ages (the increase rate lowers down in the following ages) and the improvement of system volume stability. It is suggested that sufficient water is necessary for the curing of CFBC ash cementitious system, and autoclaved curing may be considered where volume stability is a primary concern.
文摘A model is presented for the simulation of reactive gas-solids flows in large industrial reactors. Circulating fluidized bed (CFB) combustors with several thousands of cubic meters reaction volume are probably the largest reactors of this type. A semi-empirical modeling approach has been chosen to model the three-dimensional concentration distributions of gas and solids components and temperatures inside the combustion chamber of such boilers. Two industrial CFB boilers are investigated in detail: the 105 MWe Duisburg combustor in Germany and the 235 MWe Turow combustor in Poland. The semi-empirical model approach is described first. Then the model is used to show how the three-dimensional concentration and temperature fields are formed by the interaction of several local phenomena. Good agreement between simulation and measurements has been achieved.