A high integrated monolithic IC, with functions of clock recovery, data decision, and 1 ： 4 demultiplexer,is implemented in 0.25μm CMOS process for 2.5Gb/s fiber-optic communications. The recovered and frequency div...A high integrated monolithic IC, with functions of clock recovery, data decision, and 1 ： 4 demultiplexer,is implemented in 0.25μm CMOS process for 2.5Gb/s fiber-optic communications. The recovered and frequency divided 625MHz clock has a phase noise of -106.26dBc/Hz at 100kHz offset in response to a 2.5Gb/s PRBS input data （2^31-1）. The 2.5Gb/s PRBS data are demultiplexed to four 625Mb/s data. The 0.97mm× 0.97mm IC consumes 550mW under a single 3.3V power supply （not including output buffers）.展开更多
A 28/56 Gb/s NRZ/PAM-4 dual-mode transceiver(TRx)designed in a 28-nm complementary metal-oxide-semiconduc-tor(CMOS)process is presented in this article.A voltage-mode(VM)driver featuring a 4-tap reconfigurable feed-fo...A 28/56 Gb/s NRZ/PAM-4 dual-mode transceiver(TRx)designed in a 28-nm complementary metal-oxide-semiconduc-tor(CMOS)process is presented in this article.A voltage-mode(VM)driver featuring a 4-tap reconfigurable feed-forward equal-izer(FFE)is employed in the quarter-rate transmitter(TX).The half-rate receiver(RX)incorporates a continuous-time linear equal-izer(CTLE),a 3-stage high-speed slicer with multi-clock-phase sampling,and a clock and data recovery(CDR).The experimen-tal results show that the TRx operates at a maximum speed of 56 Gb/s with chip-on board(COB)assembly.The 28 Gb/s NRZ eye diagram shows a far-end vertical eye opening of 210 mV with an output amplitude of 351 mV single-ended and the 56 Gb/s PAM-4 eye diagram exhibits far-end eye opening of 33 mV(upper-eye),31 mV(mid-eye),and 28 mV(lower-eye)with an output amplitude of 353 mV single-ended.The recovered 14 GHz clock from the RX exhibits random jitter(RJ)of 469 fs and deterministic jitter(DJ)of 8.76 ps.The 875 Mb/s de-multiplexed data features 593 ps horizontal eye opening with 32.02 ps RJ,at bit-error rate(BER)of 10-5(0.53 UI).The power dissipation of TX and RX are 125 and 181.4 mW,respectively,from a 0.9-V sup-ply.展开更多
Phase locked loop(PLL) is a typical analog-digital mixed signal circuit and a method of conducting a top level system verification including PLL with standard digital simulator becomes especially significant.The behav...Phase locked loop(PLL) is a typical analog-digital mixed signal circuit and a method of conducting a top level system verification including PLL with standard digital simulator becomes especially significant.The behavioral level model(BLM) of the PLL in Verilog-HDL for pure digital simulator is innovated in this paper,and the design of PLL based clock and data recovery(CDR)circuit aided with jitter attenuation PLL for SerDes application is also presented.The CDR employs a dual-loop architecture where a frequency-locked loop acts as an acquisition aid to the phase-locked loop.To simultaneously meet jitter tolerance and jitter transfer specifications defined in G.8251 of optical transport network(ITU-T OTN),an additional jitter attenuation PLL is used.Simulation results show that the peak-to-peak jitter of the recovered clock and data is 5.17 ps and 2.3ps respectively.The core of the whole chip consumes 72 mA current from a 1.0V supply.展开更多
文摘A high integrated monolithic IC, with functions of clock recovery, data decision, and 1 ： 4 demultiplexer,is implemented in 0.25μm CMOS process for 2.5Gb/s fiber-optic communications. The recovered and frequency divided 625MHz clock has a phase noise of -106.26dBc/Hz at 100kHz offset in response to a 2.5Gb/s PRBS input data （2^31-1）. The 2.5Gb/s PRBS data are demultiplexed to four 625Mb/s data. The 0.97mm× 0.97mm IC consumes 550mW under a single 3.3V power supply （not including output buffers）.
基金supported by National Natural Science Foundation of China under Grant 62174132the Fundamental Research Funds for Central Universities under Grant xzy022022060.
文摘A 28/56 Gb/s NRZ/PAM-4 dual-mode transceiver(TRx)designed in a 28-nm complementary metal-oxide-semiconduc-tor(CMOS)process is presented in this article.A voltage-mode(VM)driver featuring a 4-tap reconfigurable feed-forward equal-izer(FFE)is employed in the quarter-rate transmitter(TX).The half-rate receiver(RX)incorporates a continuous-time linear equal-izer(CTLE),a 3-stage high-speed slicer with multi-clock-phase sampling,and a clock and data recovery(CDR).The experimen-tal results show that the TRx operates at a maximum speed of 56 Gb/s with chip-on board(COB)assembly.The 28 Gb/s NRZ eye diagram shows a far-end vertical eye opening of 210 mV with an output amplitude of 351 mV single-ended and the 56 Gb/s PAM-4 eye diagram exhibits far-end eye opening of 33 mV(upper-eye),31 mV(mid-eye),and 28 mV(lower-eye)with an output amplitude of 353 mV single-ended.The recovered 14 GHz clock from the RX exhibits random jitter(RJ)of 469 fs and deterministic jitter(DJ)of 8.76 ps.The 875 Mb/s de-multiplexed data features 593 ps horizontal eye opening with 32.02 ps RJ,at bit-error rate(BER)of 10-5(0.53 UI).The power dissipation of TX and RX are 125 and 181.4 mW,respectively,from a 0.9-V sup-ply.
基金Supported by the National High Technology Research and Development Programme of China(No.2011AA010301)the Research Foundation of Zhongxing Telecom Equipment Corporation and the National Natural Science Foundation of China(No.60976029)
文摘Phase locked loop(PLL) is a typical analog-digital mixed signal circuit and a method of conducting a top level system verification including PLL with standard digital simulator becomes especially significant.The behavioral level model(BLM) of the PLL in Verilog-HDL for pure digital simulator is innovated in this paper,and the design of PLL based clock and data recovery(CDR)circuit aided with jitter attenuation PLL for SerDes application is also presented.The CDR employs a dual-loop architecture where a frequency-locked loop acts as an acquisition aid to the phase-locked loop.To simultaneously meet jitter tolerance and jitter transfer specifications defined in G.8251 of optical transport network(ITU-T OTN),an additional jitter attenuation PLL is used.Simulation results show that the peak-to-peak jitter of the recovered clock and data is 5.17 ps and 2.3ps respectively.The core of the whole chip consumes 72 mA current from a 1.0V supply.
