Sponge Effect on Coal Mine Methane Separation Based on Clathrate Hydrate Method

The findings were presented from laboratory investigations on the hydrate formation and dissociation processes employed to recover methane from coal mine gas.The separation process of coal mine methane(CMM) was carried out at 273.15K under 4.00 MPa.The key process variables of gas formation rate,gas volume stored in hydrate and separation concentration were closely investigated in twelve THF-SDS-sponge-gas systems to verify the sponge effect in these hydrate-based separation processes.The gas volume stored in hydrate is calculated based on the measured gas pressure.The CH4 mole fraction in hydrate phase is measured by gas chromatography to confirm the separation efficiency.Through close examination of the overall results,it was clearly verified that sponges with volumes of 40,60 and 80 cm 3 significantly increase gas hydrate formation rate and the gas volume stored in hydrate,and have little effect on the CH4 mole fraction in hydrate phase.The present study provides references for the application of the kinetic effect of porous sponge media in hydrate-based technology.This will contribute to CMM utilization and to benefit for local and global environment.

Pretreatment of highly turbid coal mine drainage by a chemical agent free filtration system

A filtration system used without chemical agents for the pretreatment of turbid coal mine drainage is described in this paper.The influence of different aperture sizes and different motor speeds was investigated during the study.The experimental results show that for aperture diameters of 0.4,0.6,or 0.8 mm smaller apertures provide more complete filtration.Rotations of 12,20,28,or 40 r/min show that higher speeds give more efficient filtration.Suspended solids decreased in both particle size and concentration after the filtration.The separated slime can be directly reused as a fuel.Efficient filtration pretreatment systems for coal mine drainage were investigated and the economic feasibility is analyzed in this article.

Direct-impact of sieving coal and gangue

Gangue from underground separation of coal can directly be used for filling mined out areas, saving transport capacity and reducing the amount of waste polluting the environment above the ground. We introduced a structure and operating principle of an underground direct-impact sieving device by which a separation experiment was carried out. By means of high speed conveyer belts, coal and gangue impacted the breaking board at high speeds ranging from 6 to 14 m/s. Given the differences of hardness between coal and gangue, after selective crushing, the gangue with the higher hardness was crushed less and coal with lower hardness crushed more, which could be separated by a 50 mm sieving plate. The material above the sieving plate was disposed of as gangue and the material below as coal. The results indicate that the crush ratio below the 50 mm sieving plate increases linearly with an increase in impact velocity and decays exponentially with an increase in hardness. Employing this equipment to separate coal and gangue, the hardness of coal f should be <2. This separation device provides relatively good effect in separating coal and gangue with a relatively wide difference of hardness.

Preparation and coking properties of coal maceral concentrates

The concentrates with different maceral contents were obtained from Kailuan coking coals with different coal ranks(Ro;ranvarying from 0.88%to 1.73%)by float–sink separation in lab.Then these concentrates were characterized by proximate analysis,ultimate analysis,petrography analysis and coking index determination.The results show that the vitrinite is characterized as nature of lower carbon content,higher hydrogen content,higher volatile matter and stronger caking property compared to inertinite.The relationships between variation rate of volatile matter and maximum volatile matter and coal ranks are identified,and a linear model is developed for fast determination of the maceral contents.Compared to inertinite-rich concentrate,the blending ratio of vitrinite-rich concentrate is increased by 13%,which is considered to be a potential technique based on maceral separation for expanding the coking coal resources.

Effect of chemical conditioning on the triboelectrification of coal and mineral particles

Chemical conditioning was used to modify the triboelectrification of coal and mineral particles.The chemicals tested included starch,lignin,kerosene,ethanol,acetic acid,salicylic acid,sodium oleate,Sodium Hexametaphosphate(SH),sodium silicate, Sodium Dodecylbenzenesulfonate(SDBS),Sodium Bicarbonate(SB) and ammonia.A high-speed,dry mixing method was employed.The charge-to-mass ratio of the coal and mineral samples,both untreated and treated,was tested using a Faraday cup. Dielectric constants were determined by measuring capacitance.It is found that the selectivity of the additives toward coal or minerals is not consistent.Salicylic acid is the optimal additive to enhance the triboelectrification performance of coal samples.Starch, lignin and sodium oleate are suitable for removal of pyrite.SH,sodium silicate,SDBS,SB and ammonia are suitable additives for the removal of ash-forming minerals.

New progress in the processing and efficient utilization of coal

Coal accounts for about 70% of the primary energy sources in China. The environmental pollution and resources waste involved with coal processing and utilization are serious. It is therefore urgent to develop highly-efficient coal resources utilization theory and methods with low-carbon discharge. Based on our long-term basic research and technology development, the progress in beneficiation, cleaning, and trans- formation of coal, which includes dense phase fluidized bed dry beneficiation, deep screening of wet fine coal, micro-bubble flotation column separation, molecular coal chemistry, and transformation and sepa- ration of coal and its derivatives into value-added chemicals under mild conditions, is discussed.

MOSSBAUER ANALYSIS ON THE MICROWAVE-MAGNETIC DESULFURIZATION OF RAW COAL

The selective dielectric heating of microwave energy to convert a portion of each pyrite particle to moderately magnetic pyrrhotite has been suggested to enhance the magnetic separation of inorganic sulfur from coal. The results for Mossbauer analyses show that the considerable amount of pyrrhotite produced during microwave irradiation, carrying with it some of non--magnetic pyrite (unconverted), ferrous sulfate, and troilite, is completely removed from coal after magnetic separation. The opthoum desulfurization efficiency can be attsined by appropriately controlling the irradiation time to maximize the amount of pyrrhotite formed pyrite decomposition.Excessive irradiation would be disadvantageous for improving magnetic separation due to the further decomposition of pyrrhotite to antiferromagnetic troilite.

Motion characteristics and density separation of fine coal in an inflatable-inclined liquid-solid fluidized bed

To improve the adaptability of fluidized beds for fine coal separation,a new type of liquid-solid fluidized bed was constructed,i.e.,the inflatable-inclined liquid-solid fluidized bed(IILSFB).A combination of simulation analysis and separation experiments was used to analyze the fluidization characteristics and separation performance of the IILSFB.The results showed that there was upflow and downflow in the fluidized bed.The upflow was mainly composed of water flow,followed by light and heavy particles;on the other hand,the downflow was caused by the backflow of heavy particles that settled at the inclined section.In addition,the light particles that settled at the inclined section could return to the rising water flow under the action of secondary airflow.As the water velocity,separation time,and secondary gas velocity increased,the comprehensive separation efficiency of fine coal in the fluidized bed improved,while the value decreased as the feed quantity increased.This also indicated the order of importance for these four factors,i.e.,water velocity,separation time,feed quantity,and secondary gas velocity,on fluidisation.Furthermore,the comprehensive separation efficiency of 0.1-1 mm fine coal varied significantly with various factors,while that of∼0.1 mm and 1-3 mm fine coal was always at a low value.In the latter case,the classification process of the size fraction was significantly better than the separation process in the fluidized bed.Under optimal working conditions,an IILSFB was used to separate the fine coal(0.1-1 mm).The yield of clean coal was 37.95% with an ash content of 12.11%,and the possible error was 0.085 g/cm^(3),indicating that the IILSFB had good separation performance for 0.1-1 mm fine coal.

Effect of coal particle swarm properties on the fluidization characteristics and coal beneficiation in a dense-phase gas-solid fluidized bed

This paper analyzes the influence of different coal mass fraction in an air dense medium fluidized bed （ADMFB）. The effect of the low density particles layer on heavy sedimentation increased with increasing material layer thickness. The thickness of the low density particles layer also affected the final settling time of the high densiW particles. Increasing the thickness of the low density particles layer by △h provoked an increase in the settling of high density particles that was related to their diameter （△h/D）. The pressure gradient across the bed was lower than that observed for the control experiment, which had only the dense material, owing to a decrease in the pressure gradient in Zones 1 and 5 （at the top and bottom of the bed, respectively）. Introducing different coal sizes resulted in different fluidization environments, particle accumulation layers, and changes to the surrounding zone. However, the influence of the coal particles on the local bed characteristics was related to its concentration. The feeding mass fraction of 6-13mm size and 13-25mm size coal should be limited to10% and 13%, respectively. The ranges of possible deviation were found to be 0.08-0.15 and 0.07-0.10 for the respective samples.

Distribution and mode of occurrence of uranium in bottom ash derived from high-germanium coals

The radioactivity of uranium in radioactive coal bottom ash（CBA） may be a potential danger to the ambient environment and human health. Concerning the limited research on the distribution and mode of occurrence of uranium in CBA, we herein report our investigations into this topic using a number of techniques including a five-step Tessier sequential extraction, hydrogen fluoride（HF） leaching, Siroquant（Rietveld） quantification, magnetic separation, and electron probe microanalysis（EPMA）. The Tessier sequential extraction showed that the uranium in the residual and Fe–Mn oxide fractions was dominant（59.1%and 34.9%, respectively）. The former was mainly incorporated into aluminosilicates,retained with glass and cristobalite, whereas the latter was especially enriched in the magnetic fraction, of which about 50% was present with magnetite（Fe_3O_4） and the rest in other iron oxides. In addition, the uranium in the magnetic fraction was 2.6 times that in the non-magnetic fraction. The experimental findings in this work may be important for establishing an effective strategy to reduce radioactivity from CBA for the protection of our local environment.

Three-dimensional numerical simulation of flow and splash behavior in an oxygen coal combustion melting and separating furnace

The change of bubbles and the position of the tuyere in an oxygen coal combustion melting and separating furnace affect the flow and splash behavior of the molten pool.To analyze this problem further,a three-dimensional numerical simulation method was used to explore the behavior and change of the flow field inside the molten pool during double-row tuyere injection.In addition,the arrangement of the tuyere was changed for a more detailed understanding of the internal phase distribution and splashing in a molten pool.The results indicated that under three-dimensional numerical simulation conditions,bubbles rise after leaving the tuyere and break on the surface of the molten pool,which results in certain fluctuations in the nearby melt.During the injection process of the tuyere,the meteorological accumulation in the middle part of the molten pool formed part of the foam slag because of the influence of surface tension.When the layout of the upper and lower exhaust tuyeres was changed from staggered to symmetrical,or when the spacing of the upper and lower exhaust tuyeres changed,it had an effect on the phase distribution and splash behavior.