Oxide coating mechanism during fluidized bed reduction: solid-state reaction characteristics between iron ore particles and MgO

Experiments on the solid-state reaction between iron ore particles and MgO were performed to investigate the coating mechanism of MgO on the iron ore particles＇ surface during fluidized bed reduction. MgO powders and iron ore particles were mixed and compressed into briquettes and, subsequently, roasted at different temperatures and for different time periods. A Mg-containing layer was observed on the outer edge of the iron ore particles when the roasting temperature was greater than 1173 K. The concentration of Fe in the Mg-containing layer was evenly distributed and was approximately 10wt%, regardless of the temperature change. Boundary layers of Mg and Fe were observed outside of the iron ore particles. The change in concentration of Fe in the boundary layers was simulated using a gas–solid diffusion model, and the diffusion coefficients of Fe and Mg in these layers at different temperatures were calculated. The diffusion activation energies of Fe and Mg in the boundary layers in these experiments were evaluated to be approximately 176 and 172 k J/mol, respectively.

Thermal properties of diamond/Al composites by pressure infiltration:comparison between methods of coating Ti onto diamond surfaces and adding Si into Al matrix

This study was pertained to the effects of Ti coating on diamond surfaces and Si addition into Al matrix on the thermal conductivity（TC） and the coefficient of thermal expansion（CTE） of diamond/Al composites by pressure infiltration.The fracture surfaces,interface microstructures by metal electro-etching and interfacial thermal conductance of the composites prepared by two methods were compared.The results reveal that Ti coating on diamond surfaces and only12.2 wt% Si addition into Al matrix could both improve the interfacial bonding and increase the TCs of the composites.But the Ti coating layer introduces more interfacial thermal barrier at the diamond/Al interface compared to adding 12.2 wt% Si into Al matrix.The diamond/Al composite with 12.2 wt% Si addition exhibits maximum TC of 534 W·m^-1·K^-1and a very low CTE of 8.9×10^-6K^-1,while the coating Ti-diamond/Al composite has a TC of 514 W·m^-1·K^-1 and a CTE of 11.0×10^-6K^-1.

Synthesis kinetics and thermophysical properties of La_2(Zr_(0.7)Ce_(0.3))_2O_7 ceramic for thermal barrier coatings

La2（Zr0.7Ce0.3）2O7 （LZ7C3） ceramic was synthesized by solid state reaction with La2O3, ZrO2 and CeO2 as starting materials. The synthesis kinetics, phase structure, mass loss and microstructure were studied by thermo gravimetric-different thermal analyzer （TG-DTA）, X-ray difference （XRD） and scanning electron microscopy （SEM）. The thermal conductivity and thermal expansion coefficient were measured by laser-flash method and pushing-rod method, respectively. XRD results showed that LZ7C3 was a mixture of La2Zr2O7 （LZ, pyro- chlore） and La2Ce2O7 （LC, fluorite）. The lowest synthesis temperature and time of LZ7C3 were 1400 oC and 5 h. There were no peaks of La2O3 when the powder granularity was about 0.82 μm in the synthesis process. The atom ratio La：Zr：Ce of prepared LZ7C3 powder was very close to 10：7：3 which was the theory value of LZ7C3. The thermal conductivity of LZ7C3 decreased gradually with the temperature increased up to 1200 oC, and was located within 0.79 to 1.02 W/（m·K）, which was almost 50% lower than that of LZ, whereas its thermal expansion coefficient was larger and the value was 11.6×10-6 K-1.