为了降低水声信道强多径效应、大多普勒频移等特性对水声通信系统的影响,提出一种基于极化码的正交频分复用(Orthogonal Frequency Division Multiplexing,OFDM)的水声通信系统。选择极化(Polar)码作为信道编码方案,通过量化信道输出直...为了降低水声信道强多径效应、大多普勒频移等特性对水声通信系统的影响,提出一种基于极化码的正交频分复用(Orthogonal Frequency Division Multiplexing,OFDM)的水声通信系统。选择极化(Polar)码作为信道编码方案,通过量化信道输出直接统计信道转移概率,替代通过信道估计得到的信道冲激响应,再计算转移概率,以降低通信系统的复杂度。在特性随时不变、时变、快时变的3种类型水声信道模型下,分别基于蒙特卡罗算法构造Polar码。仿真结果表明,Polar码在3种信道上的编码增益优于同码长同码率的低密度奇偶校验(Low Density Parity Check,LDPC)码和Turbo码,且信道条件越复杂,取得的编码增益越大,所提系统能够明显降低信道多径效应、多普勒频移对水声通信系统的扰乱,提高系统的可靠性。展开更多
In this paper, we focus on the design of irregular QC-LDPC code based multi-level coded modulation(MLCM) scheme by jointly optimizing the component code rate and the degree distribution of the irregular QC-LDPC compon...In this paper, we focus on the design of irregular QC-LDPC code based multi-level coded modulation(MLCM) scheme by jointly optimizing the component code rate and the degree distribution of the irregular QC-LDPC component code. Firstly, the sub-channel capacities of MLCM systems is analyzed and discussed, based on which the optimal component code rate can be obtained. Secondly, an extrinsic information transfer chart based two-stage searching algorithm is proposed to find the good irregular QC-LDPC code ensembles with optimal component code rates for their corresponding sub-channels. Finally, by constructing the irregular QC-LDPC component codes from the designed ensembles with the aim of possibly enlarging the girth and reducing the number of the shortest cycles, the designed irregular QC-LDPC code based 16QAM and 64QAM MLCM systems can achieve 0.4 dB and 1.2 dB net coding gain, respectively, compared with the recently proposed regular QC-LDPC code based 16QAM and 64QAM MLCM systems.展开更多
This paper investigates the simultaneous wireless information and powertransfer(SWIPT) for network-coded two-way relay network from an information-theoretic perspective, where two sources exchange information via an S...This paper investigates the simultaneous wireless information and powertransfer(SWIPT) for network-coded two-way relay network from an information-theoretic perspective, where two sources exchange information via an SWIPT-aware energy harvesting(EH) relay. We present a power splitting(PS)-based two-way relaying(PS-TWR) protocol by employing the PS receiver architecture. To explore the system sum rate limit with data rate fairness, an optimization problem under total power constraint is formulated. Then, some explicit solutions are derived for the problem. Numerical results show that due to the path loss effect on energy transfer, with the same total available power, PS-TWR losses some system performance compared with traditional non-EH two-way relaying, where at relatively low and relatively high signalto-noise ratio(SNR), the performance loss is relatively small. Another observation is that, in relatively high SNR regime, PS-TWR outperforms time switching-based two-way relaying(TS-TWR) while in relatively low SNR regime TS-TWR outperforms PS-TWR. It is also shown that with individual available power at the two sources, PS-TWR outperforms TS-TWR in both relatively low and high SNR regimes.展开更多
The Q-ary low-density parity-check（LDPC） coded high order partial response continuous phase modulation（PR-CPM） with double iterative loops is investigated. This scheme shows significant improvements in power and b...The Q-ary low-density parity-check（LDPC） coded high order partial response continuous phase modulation（PR-CPM） with double iterative loops is investigated. This scheme shows significant improvements in power and bandwidth efficiency, but at the expense of long iterative decoding delay and computational complexity induced by the improper match between the demodulator and the decoder. To address this issue, the convergence behavior of Q-ary LDPC coded CPM is investigated for the Q=2 and Q〉2 cases, and an optimized design method based on the extrinsic information transfer chart is proposed to improve the systematic iterative efficiency. Simulation results demonstrate that the proposed method can achieve a perfect tradeoff between iterative decoding delay and bit error rate performance to satisfy real-time applications.展开更多
Steam–gas pressurizers are self-pressurizing, and since steam and noncondensable gas are used to sustain their pressure, they experience very complicated thermal–hydraulic phenomena owing to the presence of the latt...Steam–gas pressurizers are self-pressurizing, and since steam and noncondensable gas are used to sustain their pressure, they experience very complicated thermal–hydraulic phenomena owing to the presence of the latter. A steam–gas pressurizer model was developed using Relap5 code to investigate such a pressurizer's thermal–hydraulic characteristics.The important thermal–hydraulic processes occurring in the pressurizer model include bulk flashing, rainout, wall condensation with noncondensable gas, and interfacial heat and mass transfer. The pressurizer model was verified using results from insurge experiments performed at the Massachusetts Institute of Technology. It was found that noncondensable gas was one of the important factors governing the pressure response, and the accuracy of the developed model would change with different mass fractions and types of noncondensable gas.展开更多
In this paper, the Multiple Input Multiple Output (MIMO) doubly-iterative receiver which consists of the Probabilistic Data Association detector (PDA) and Low-Density Parity-Check Code (LDPC) decoder is developed. The...In this paper, the Multiple Input Multiple Output (MIMO) doubly-iterative receiver which consists of the Probabilistic Data Association detector (PDA) and Low-Density Parity-Check Code (LDPC) decoder is developed. The receiver performs two iterative decoding loops. In the outer loop, the soft information is exchanged between the PDA detector and the LDPC decoder. In the inner loop, it is exchanged between variable node and check node decoders inside the LDPC decoder. On the light of the Extrinsic Information Transfer (EXIT) chart technique, an LDPC code degree profile optimization algorithm is developed for the doubly-iterative receiver. Simulation results show the doubly-receiver with optimized irregular LDPC code can have a better performance than the one with the regular one.展开更多
文摘为了降低水声信道强多径效应、大多普勒频移等特性对水声通信系统的影响,提出一种基于极化码的正交频分复用(Orthogonal Frequency Division Multiplexing,OFDM)的水声通信系统。选择极化(Polar)码作为信道编码方案,通过量化信道输出直接统计信道转移概率,替代通过信道估计得到的信道冲激响应,再计算转移概率,以降低通信系统的复杂度。在特性随时不变、时变、快时变的3种类型水声信道模型下,分别基于蒙特卡罗算法构造Polar码。仿真结果表明,Polar码在3种信道上的编码增益优于同码长同码率的低密度奇偶校验(Low Density Parity Check,LDPC)码和Turbo码,且信道条件越复杂,取得的编码增益越大,所提系统能够明显降低信道多径效应、多普勒频移对水声通信系统的扰乱,提高系统的可靠性。
基金supported by National Natural Science Foundation of China(No.61571061)
文摘In this paper, we focus on the design of irregular QC-LDPC code based multi-level coded modulation(MLCM) scheme by jointly optimizing the component code rate and the degree distribution of the irregular QC-LDPC component code. Firstly, the sub-channel capacities of MLCM systems is analyzed and discussed, based on which the optimal component code rate can be obtained. Secondly, an extrinsic information transfer chart based two-stage searching algorithm is proposed to find the good irregular QC-LDPC code ensembles with optimal component code rates for their corresponding sub-channels. Finally, by constructing the irregular QC-LDPC component codes from the designed ensembles with the aim of possibly enlarging the girth and reducing the number of the shortest cycles, the designed irregular QC-LDPC code based 16QAM and 64QAM MLCM systems can achieve 0.4 dB and 1.2 dB net coding gain, respectively, compared with the recently proposed regular QC-LDPC code based 16QAM and 64QAM MLCM systems.
基金supported by the National Natural Science Foundation of China ( No . 61602034 )the Beijing Natural Science Foundation (No. 4162049)+2 种基金the Open Research Fund of National Mobile Communications Research Laboratory,Southeast University (No. 2014D03)the Fundamental Research Funds for the Central Universities Beijing Jiaotong University (No. 2016JBM015)the NationalHigh Technology Research and Development Program of China (863 Program) (No. 2015AA015702)
文摘This paper investigates the simultaneous wireless information and powertransfer(SWIPT) for network-coded two-way relay network from an information-theoretic perspective, where two sources exchange information via an SWIPT-aware energy harvesting(EH) relay. We present a power splitting(PS)-based two-way relaying(PS-TWR) protocol by employing the PS receiver architecture. To explore the system sum rate limit with data rate fairness, an optimization problem under total power constraint is formulated. Then, some explicit solutions are derived for the problem. Numerical results show that due to the path loss effect on energy transfer, with the same total available power, PS-TWR losses some system performance compared with traditional non-EH two-way relaying, where at relatively low and relatively high signalto-noise ratio(SNR), the performance loss is relatively small. Another observation is that, in relatively high SNR regime, PS-TWR outperforms time switching-based two-way relaying(TS-TWR) while in relatively low SNR regime TS-TWR outperforms PS-TWR. It is also shown that with individual available power at the two sources, PS-TWR outperforms TS-TWR in both relatively low and high SNR regimes.
基金supported by the National Natural Science Foundation of China(61403093)the Science Foundation of Heilongjiang Province of China for Returned Scholars(LC2013C22)the Assisted Project by Heilongjiang Province of China Postdoctoral Funds for Scientific Research Initiation(LBH-Q14048)
文摘The Q-ary low-density parity-check（LDPC） coded high order partial response continuous phase modulation（PR-CPM） with double iterative loops is investigated. This scheme shows significant improvements in power and bandwidth efficiency, but at the expense of long iterative decoding delay and computational complexity induced by the improper match between the demodulator and the decoder. To address this issue, the convergence behavior of Q-ary LDPC coded CPM is investigated for the Q=2 and Q〉2 cases, and an optimized design method based on the extrinsic information transfer chart is proposed to improve the systematic iterative efficiency. Simulation results demonstrate that the proposed method can achieve a perfect tradeoff between iterative decoding delay and bit error rate performance to satisfy real-time applications.
文摘Steam–gas pressurizers are self-pressurizing, and since steam and noncondensable gas are used to sustain their pressure, they experience very complicated thermal–hydraulic phenomena owing to the presence of the latter. A steam–gas pressurizer model was developed using Relap5 code to investigate such a pressurizer's thermal–hydraulic characteristics.The important thermal–hydraulic processes occurring in the pressurizer model include bulk flashing, rainout, wall condensation with noncondensable gas, and interfacial heat and mass transfer. The pressurizer model was verified using results from insurge experiments performed at the Massachusetts Institute of Technology. It was found that noncondensable gas was one of the important factors governing the pressure response, and the accuracy of the developed model would change with different mass fractions and types of noncondensable gas.
基金Supported by the National Natural Science Foundation of China (No. 60772061)Science Foundation of Nanjing University of Posts and Telecommunications (No. NY207132)
文摘In this paper, the Multiple Input Multiple Output (MIMO) doubly-iterative receiver which consists of the Probabilistic Data Association detector (PDA) and Low-Density Parity-Check Code (LDPC) decoder is developed. The receiver performs two iterative decoding loops. In the outer loop, the soft information is exchanged between the PDA detector and the LDPC decoder. In the inner loop, it is exchanged between variable node and check node decoders inside the LDPC decoder. On the light of the Extrinsic Information Transfer (EXIT) chart technique, an LDPC code degree profile optimization algorithm is developed for the doubly-iterative receiver. Simulation results show the doubly-receiver with optimized irregular LDPC code can have a better performance than the one with the regular one.
