Characteristic and optimization of ferrite-rich sulfoaluminate-based composite cement suitable for cold region tunnels

To develop suitable grouting materials for water conveyance tunnels in cold regions,firstly,this study investigated the performance evolution of ferrite-rich sulfoaluminate-based composite cement(FSAC grouting material)at 20 and 3℃.The results show that low temperature only delays the strength development of FSAC grouting material within the first 3 d.Then,the effect of four typical early strength synergists on the early properties of FSAC grouting material was evaluated to optimize the early(£1 d)strength at 3℃.The most effective synergist,Ca(HCOO)_(2),which enhances the low-temperature early strength without compromising fluidity was selected based on strength and fluidity tests.Its micro-mechanism was analyzed by XRD,TG,and SEM methods.The results reveal that the most suitable dosage range is 0.3 wt%−0.5 wt%.Proper addition of Ca(HCOO)_(2)changed the crystal morphology of the hydration products,decreased the pore size and formed more compact hydration products by interlocking and overlapping.However,excessive addition of Ca(HCOO)_(2)inhibited the hydration reaction,resulting in a simple and loose structure of the hydration products.The research results have reference value for controlling surrounding rock deformation and preventing water and mud inrushes during the excavation in cold region tunnels.

Rearing Test of Ictalurus punctatus in Cold Plateau Zone

Three ponds with the areas of 800, 1 000 and 1 000 m2 were settled in Yambajan aquaculture base for rearing test of Ictalurus punctatus in plateau zone. The results showed that as 30 000 fries were released, 19 830 fingerlings of 1. punctatus were obtained after 270 d rearing, with the average body length of 21.2 cm, the average body weight of 216.5 g, the survival rate of 66.1%, and the fingerling harvest of 4 293.2 kg. Thus, it is effective and feasible to rear I. punctatus with residual heat resources of power plants in cold plateau zone.

Abiotic Methane Reservoirs in the Western Tianshan HP–UHP Metamorphic Belt,China

Natural gas,consisting primarily of methane(CH_(4)),has become a major source of clean energy in modern society in many parts of the globe.Recent experimental observations and discoveries of deep-sourced abiotic CH_(4)in cold subduction zones indicate the important ability of cold subducted slabs to generate natural gas reservoirs.However,most CH_(4)flux and reservoirs remain unknown and their potential is overlooked in global carbon flux estimations.Massive abiotic CH_(4)-rich fluid inclusions(FIs)in garnet and omphacite from ultrahigh-pressure(UHP)eclogites have been found in the Western Tianshan(WT)UHP metamorphic belt,which provides one ideal case for quantification of abiotic CH_(4)stored in the cold subducted crust.By two methods,we assess the abiotic CH_(4)content stored in the Chinese WT HP–UHP metamorphic belt.Our calculations show that at least 113 Mt CH_(4)is stored in the WT eclogites.We also discuss the implications for CH_(4)reservoirs in subduction zones worldwide and speculate that the cold subduction zones may represent one of the largest,yet overlooked,sources of abiotic CH_(4)on Earth,which should not be ignored in the global natural resource and carbon flux estimations.

Non-linear Dynamics of Inlet Film Thickness during Unsteady Rolling Process

The inlet film thickness directly affects film and stress distribution of rolling interfaces. Unsteady factors, such as unsteady back tension, may disturb the inlet film thickness. However, the current models of unsteady inlet film thickness lack unsteady disturbance factors and do not take surface topography into consideration. In this paper, based on the hydrodynamic analysis of inlet zone an unsteady rolling film model which concerns the direction of surface topography is built up. Considering the small fluctuation of inlet angle, absolute reduction, reduction ratio, inlet strip thickness and roll radius as the input variables and the fluctuation of inlet film thickness as the output variable, the non-linear relationship between the input and output is discussed. The discussion results show that there is 180° phase difference between the inlet film thickness and the input variables, such as the fluctuant absolute reduction, the fluctuant reduction ratio and non-uniform inlet strip thickness, but there is no phase difference between unsteady roll radius and the output. The inlet angle, the steady roll radius and the direction of surface topography have significant influence on the fluctuant amplitude of unsteady inlet film thickness. This study proposes an analysis method for unsteady inlet film thickness which takes surface topography and new disturbance factors into consideration.

Field Study on Indoor Thermal and Luminous Environment in Winter of Vernacular Houses in Northern Hebei Province of China

In this paper,a climate-adaptation study of vernacular houses in northern Hebei Province has been conducted based on quantitative field surveys. Three typical vernacular houses with different kinds of building envelopes were selected. The field surveys included investigation on building material and construction,measurement of indoor thermal environment, infrared thermographic study of building envelopes and measurement of luminous environment. The results showed that the indoor air temperatures were below thermal comfort zone from late night till early morning and the horizontal temperature gradient was obvious. The adobe wall showed better thermal performance than the other two. As for the building layout,it is beneficial to put a storeroom on the north side of the house as a temperature buffer zone. Furthermore,due to missing insulation and the informal process of construction,significant amounts of heat escaped from building envelopes,especially from the corner of wall,ceiling and around the openings. The daylight factors on the work plan in the main rooms were accordance with design standards and the level of illuminance met the requirements of family's daily activities.

Development of window opening models for residential building in hot summer and cold winter climate zone of China

This study monitors the open/closed states of the windows in 16 residential apartments in representative cities of the hot summer and cold winter zone of China,along with outdoor air temperature,outdoor relative humidity and outdoor PM2.5 concentration in 2017,to investigate the window opening/closing behavior.Three window opening models are developed.All the models are validated by modeling a typical residential apartment to compare the predicted indoor CO_(2)concentration with monitored data.It is found that the window opening probability is negatively correlated to both outdoor PM2.5 concentration and outdoor relative humidity,and the probability of window opening reaches the peak value when the outdoor air temperature is 23.7℃.In terms of season,the shortest window opening duration occurs in winter due to the cold outdoor air temperature and high outdoor PM2.5 concentration.Finally,by comparing the correlation between the measured date and simulation results of indoor CO_(2)concentration,this study provides an appropriate window opening model for reference.

Energy consumption pattern and indoor thermal environment of residential building in rural China

With the continuous deepening of China’s rural construction and development,people’s living conditions are improved day by day,while accompanied by energy and environment crisis issues.This paper mainly analyzes the energy consumption pattern and the indoor environment of rural households in China and discusses the energy-saving optimization strategies for improving the thermal environment of buildings.Questionnaire surveys and field surveys were conducted in three villages in Guanghan,China.The measurement results show that the annual indoor temperature range of the region in the summer is 15-31℃and the relative humidity range is 34%-96%.The average indoor temperatures in summer and winter are 28℃and 16℃respectively.The indoor thermal environment of rural buildings is usually poor and cannot meet the requirements of Chinese standards.At the same time,the architectural design and energy consumption pattern of rural households are different from those in urban areas as countryside has unique characteristics.Finally,we put forward certain energy-saving improvement measures at the end of the article.