Unbalance Vibratory Displacement Compensation for Active Magnetic Bearings

As the dynamic stiffness of radial magnetic bearings is not big enough, when the rotor spins at high speed, unbalance displacement vibration phenomenon will be produced. The most effective way for reducing the displacement vibration is to enhance the radial magnetic bearing stiffness through increasing the control currents, but the suitable control currents are not easy to be provided, especially, to be provided in real time. To implement real time unbalance displacement vibration compensation, through analyzing active magnetic bearings （AMB） mathematical model, the existence of radial displacement runout is demonstrated. To restrain the runout, a new control scheme-adaptive iterative learning control （A1LC） is proposed in view of rotor frequency periodic uncertainties during the startup process. The previous error signal is added into AILC learning law to enhance the convergence speed, and an impacting factor/3 influenced by the rotor rotating frequency is introduced as learning output coefficient to improve the rotor control effects, As a feed-forward compensation controller, AILC can provide one tmknown and perfect compensatory signal to make the rotor rotate around its geometric axis through power amplifier and radial magnetic bearings. To improve AMB closed-loop control system robust stability, one kind of incomplete differential PID feedback controller is adopted. The correctness of the AILC algorithm is validated by the simulation of AMB mathematical model adding AILC compensation algorithm through MATLAB soft. And the compensation for fixed rotational frequency is implemented in the actual AMB system. The simulation and experiment results show that the compensation scheme based on AILC algorithm as feed-forward compensation and PID algorithm as close-loop control can realize AMB system displacement minimum compensation at one fixed frequency, and improve the stability of the control system. The proposed research provides a new adaptive iterative/earning control algorithm and control strategy for AMB displacement minimum compensation, and provides some references for time-varied displacement minimum compensation.

An effective algorithm for needle tip displacement compensation in robot-assisted percutaneous surgery

This paper presents an automatic compensation algorithm for needle tip displacement in order to keep the needle tip always fixed at the skin entry point in the process of needle orientation in robot-assisted percutaneous surgery. The algorithm, based on a two-degree-of-freedom （2-DOF） robot wrist （not the mechanically constrained remote center of motion （RCM） mechanism） and a 3-DOF robot ann, firstly calculates the needle tip displacement caused by rotational motion of robot wrist in the arm coordinate frame using the robotic forward kinematics, and then inversely compensates for the needle tip displace- ment by real-time Cartesian motion of robot arm. The algorithm achieves the function of the RCM and eliminates many mechanical and virtual constraints caused by the RCM mechanism. Experimental result demonstrates that the needle tip displacement is within 1 inm in the process of needle orientation.

HIGH TEMPERATURE DISPLACEMENT SENSOR

A high temperature displacement sensor based on the principle of eddy-current is investigated. A new temperature compensation technique by using eddy-current effect is presented to satisfy the special requirement at high temperature up to 550℃. The experiment shows that the temperature compensation technique leads to good temperature stability for the sensors. The variation of the sensitivity as well as the temperature drift of the sensor with temperature compensation technique is only about 7.4% and 90-350 mV at 550 ℃ compared with that at room temperature, and that of the sensor without temperature compensation technique is about 31.2% and 2-3 V at 550 ℃ compared with that at room temperature. A new dynamic calibration method for the eddy-current displacement sensor is presented, which is very easy to be realized especially in high frequency and at high temperatures. The high temperature displacement sensors developed are successfully used at temperature up to 550 ℃ in a magnetic bearing system for more than 100 h.